Outback Power Systems FLEXware16 Amp Maximum 30VDCの取扱説明書

ページ1に含まれる内容の要旨

FLEXware16 Amp Maximum 30VDC/250VAC
Rated Relay and DIN Mount Base with LED
RELAY
BASE
LED
SIDE VIEW FRONT VIEW

The FLEXware Relay Assembly will activate a two-wire start generator
when wired to the AUX output of either an OutBack FX Inverter/Charger
or an OutBack Charge Controller. The assembly consists of an LED
module and a relay inserted (in one orientation) into a base. The base is
mounted onto the DIN rail of any OutBack AC industrial control panel.
Relay Features:
• Rated current

ページ2に含まれる内容の要旨

WIRING INSTRUCTIONS Wire the relay coil from the AUX positive and negative connections of your OutBack product according to the diagram. The coil connections (A1 and A2) are not polarity sensitive and the LED will light in either polarity as long as proper voltage is present. (Required voltage is nominally 12 VDC, with a minimum of 9 volts.) If you are unsure, run the AUX positive wire to the A2 terminal and the AUX negative wire to the A1 terminal, twisting the wires together for a cle

ページ3に含まれる内容の要旨

TWO WIRE START GENERATOR HOOK UP GENERATOR FX INVERTER/CHARGER INVERTER 12V RELAY ON/OFF NO AUX + COM AUX - NC XCT - XCT + There are two screw terminals for each relay contact. Each can handle up to 8 amps. They are tied together internally. COM 11 and COM 21 are the common relay connections. Either can be used for loads under 8 amps. If the load exceeds 8 amps, use both COM 11 and COM 21. NO 14 and NO 24 are normally open relay connections. Use both 14 and 24 terminals for loads

ページ4に含まれる内容の要旨

Corporate Office European Sales Office 19009 62nd Avenue NE C/ Castelló, 17 Arlington, WA USA 08830 - Sant Boi de Llobregat (+1) 360-435-6030 BARCELONA, España Phone: +34.93.654.9568 www.outbackpower.com 900-0018-01-00 REV A