ページ1に含まれる内容の要旨
1
Assembling the new Mirage Drive drums and cables
Caution: The new cables and drums are slotted for easier maintenance and
tune ups. They are not interchangeable with the older parts.
Warning: If cables are installed incorrectly, they may twist off the drums,
causing the Drive to fail.
Tip: DO NOT REUSE Nyloc nuts when installing new cables. The slotted cable
threads have 40% less area -- worn Nylocs may back out causing Drive failure or
adjustment problems.
Tools and mat
ページ2に含まれる内容の要旨
2 link of chain with marking pen for easy placement). 2. Lightly grease drum axle Note: there are two methods of assembling the cables to the new drums -- on the bench (3 through 7 "A" below) or with the drive properly mounted in a bench vise (3 through 7 "B" below). Each is described separately. Use which ever is easiest for you. Bench method: 3 A. Mount left or right drum / crank arm assembly (noting correct side) onto drum shaft 4 A. Install front and rear cable into upp
ページ3に含まれる内容の要旨
3 Vise method: 3 B. Secure Drive to vise by rear portion as shown. Use a rag in vise to prevent marks (rag removed for illustration purposes, right). 4 B. Mount both drum / crank arm assemblies to drum shaft, noting correct left and right side. 5 B. Mount the rear sprocket cable. Note, the cable is first inserted from the side, with the help of needle nose pliers if necessary, then re-routed over the top lip of the drum. Hand thread Nyloc nuts enough to keep the
ページ4に含まれる内容の要旨
4 8. (both methods) Tighten and tune all cables. Make sure they are running properly on the drums (below). Align and center fins as necessary. Troubleshooting: 1. Cable wanders off drum. Cable is twisted. Remount, removing twist or warping cable toward inboard side of drum. 2. Cable appears to be uneven. Recheck center link of chain is mounted on center cog. Make sure chain is fully pressed in, particularly the center cog.
