ページ1に含まれる内容の要旨
Projector
MP-57i / MP-58i
User's Manual - Operating Guide
Thank you for purchasing this projector!
1.800.762.5757
www.boxlight.com
©2004, BOXLIGHT Corporation. All rights reserved.This manual may not be copied in any media or form without the written consent of the manufacturer.
ページ2に含まれる内容の要旨
Projector MP-57i / MP-58i User's Manual - Operating Guide Thank you for purchasing this projector! WARNING! Before using, read the “User’s Manual - Safety Guide” and these manuals to ensure correct usage through understanding. After reading, store them in a safe place for future reference NOTE: The information in this manual is subject to change without notice. The manufacturer assumes no responsibility for any errors that may appear in this manual. The reproduction, transmission or use o
ページ3に含まれる内容の要旨
Projector Features Projector Features This multimedia projector is used to project various computer signals as well as NTSC/PAL/SECAM video signals onto a screen. Little space is required for installation and large images can easily be realized. Ultra High Brightness ● Crisp, ultra-bright presentations is achieved by using a UHB (ultra high brightness) lamp and a highly efficient optical system. Whisper Mode Equipped ● Special mode is available for reducing projector noise to achieve quieter o
ページ4に含まれる内容の要旨
Contents Contents Projector Features 2 Multifunctional Settings 22 Preparation 2 Using The Menu Functions 22 Part Names 4 MAIN Menu 23 Projector 4 PICTURE-1 Menu 24 Control Buttons 5 PICTURE-2 Menu 26 Remote control 5 INPUT Menu 27 Setting Up 6 AUTO Menu 29 Arrangement 6 SCREEN Menu 31 Adjusting The Projector’s OPTION Menu 33 Elevator 7 NETWORK Menu 35 Using The Lens shift Buttons 7 Network Setting Up 36 Connecting Your Devices 8
ページ5に含まれる内容の要旨
KEYSTONE SEARCH M1-DINPUT LENS SHIFT RGB BNG RESET FOCUS ZOOM COMPONENT INTER MENU S-VIDEO VIDEO STANDBY/ON TEMP LAMP CONTROL NETWORK REMOTE CONTROL AUDIO IN1 AUDIO OUT AUDIO IN2 CR/PR Ca/Pa Y RGB RGB OUT R/CR/PR G/Y B/CB/PB H V R-AUDIO IN-L VIDEO S-VIDEO BNC Part Names Part Names Projector 1 Elevator button 2 Elevator foot 3 Remote sensor 6 3 4 Lens cap 5 Lens The picture is projected from 5 here. 6 Filter cover 1 An air filter is inside. 2 4 Projector (Front/Right) A RGB port B M1-D port -
ページ6に含まれる内容の要旨
Part Names (continued) Part Names (continued) Control Buttons 1 STANDBY/ON button KEYSTONE and STANDBY/ON indicator e SEARCH 2 TEMP indicator M1-D 7 6 INPUT RGB 3 LAMP indicator 8 5 LENS SHIFT FOCUS ZOOM RESET 4 LENS SHIFT buttons BNC t 9 5 INPUT dial 4 COMPONENT ENTER y 6 SEARCH button 0 MENU S-VIDEO r 7 M1-D indicator - u 8 RGB indicator VIDEO w q 9 BNC indicator STANDBY/ON = 2 3 0 COMPONENT indicator TEMP LAMP 1 - S-VIDEO indicator = VIDEO indicator q ZOOM buttons w FOCUS buttons e KEYSTONE
ページ7に含まれる内容の要旨
Setting Up Setting Up Arrangement WARNING • Before installation, make sure that the projector is turned off and the power code is disconnected. • Do not set up and move the projector, while it is hot. • Install the projector in a suitable environment according to instructions of the “User’s Manual – Safety Guide” and this manual. • The power outlet should be close to the projector and easily accessible. Refer to the illustrations and tables below to determine the screen size and projection di
ページ8に含まれる内容の要旨
Setting Up (continued) Setting Up (continued) Adjusting The Projector's Elevator WARNING • Do not touch about the lens and ventilation openings during use or immediately after use to prevent a burn. CAUTION • To prevent damaging the projector and injuring yourself, always hold the projector whenever using the elevator buttons to adjust the elevator feet. You can use the elevator feet to make adjustments if the surface on which you need to set the projector is uneven or if you otherwise need to
ページ9に含まれる内容の要旨
Setting Up (continued) Setting Up (continued) Connecting Your Devices WARNING • Whenever attempting to connect other devices to the projector, read thoroughly the "User's Manual - Safety Guide", this manual and the manual of each device to be connected. Incorrect connecting could result in fire or electrical shock. CAUTION • TURN OFF ALL DEVICES prior to connecting them to the projector. Attempting to connect a live device to the projector may generate extremely loud noises or other abnormalit
ページ10に含まれる内容の要旨
KEYSTONE M1-DINPUT SEARCH LENS SHIFT BNG RGB RESET FOCUS ZOOM COMPONENT INTER S-VIDEO MENU VIDEO STANDBY/ON TEMP LAMP CONTROL NETWORK REMOTE CONTROL AUDIO IN1 AUDIO IN2 AUDIO OUT CR/PR Ca/Pa Y RGB RGB OUT R/CR/PR G/Y B/CB/PB H V R-AUDIO IN-L VIDEO S-VIDEO BNC Setting Up (continued) Setting Up (continued) Please refer to the following (for example) for connecting your devices. See the rear of the projector. You can see the ports. Examples of connection with a computer Computer Projector A RGB
ページ11に含まれる内容の要旨
Setting Up (continued) Setting Up (continued) Examples of connection with a VCR/DVD Player VCR/DVD Player Projector CONTROL NETWORK REMOTE CONTROL AUDIO IN1 R-AUDIO IN-L VIDEO AUDIO OUT AUDIO IN2 RGB RGB OUT CR/PR Ca/Pa Y Audio out (R) R-AUDIO IN H R/CR/PR G/Y B/CB/PB HV HI Audio out (L) R-AUDIO IN-L VIDEO S-VIDEO AUDIO IN-L BNC Video out VIDEO IN I ■ If using a s-video signal J S-video out S-video cable S -VIDEO CONTROL NETWORK REMOTE CONTROL AUDIO IN1 AUDIO OUT AUDIO IN2 CR/PR Ca/Pa Y RGB
ページ12に含まれる内容の要旨
KEYSTONE RGB M1-DINPUT SEARCH LENS SHIFT BNG RESET FOCUS ZOOM COMPONENT INTER S-VIDEO MENU VIDEO STANDBY/ON TEMP LAMP CONTROL NETWORK REMOTE CONTROL AUDIO IN1 AUDIO IN2 AUDIO OUT CR/PR Y RGB RGB OUT Ca/Pa R/CR/PR G/Y B/CB/PB H V R-AUDIO IN-L VIDEO S-VIDEO BNC Setting Up (continued) Setting Up (continued) Connecting to a monitor CONTROL NETWORK REMOTE CONTROL AUDIO IN1 L AUDIO OUT AUDIO IN2 RGB RGB OUT CR/PR Ca/Pa Y Monitor Projector R/CR/PR G/Y B/CB/PB HV R-AUDIO IN-L VIDEO S-VIDEO BNC L R
ページ13に含まれる内容の要旨
Remote Control Remote Control About The Laser Pointer WARNING • The laser pointer of the remote control is used in place of a finger or rod. Never look directly into the laser beam outlet or point the laser beam at other people. The laser beam can cause vision problems. CAUTION • Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. AVOID EXPOSURE-LASER RADIATION IS EMITTED FROM THIS APERTURE CAUTION LASER RADI
ページ14に含まれる内容の要旨
M1-DI KEYSTON SE EARCH LENS SHIFT BNG RGB NPUT RESET FOCUS ZOOM CO SM -VP ID O E N O ENT INTER MENU VIDEO / STANDBY ON TEMP LAMP REMOTE CONTROL CONTROL NETWORK AUDIO IN1 AUDIO IN2 RGB RGB OUT AUDIO OUT CR/PR Ca/Pa Y R/CR/PR G/Y B/CB/PB H V R-AUDIO IN-L VIDEO S-VIDEO BNC Remote Control (continued) Remote Control (continued) Operating The Remote Control CAUTION • Do not disassemble the remote control. • Do not place the remote control near the projector’s lens, fan, or vents. • Do not drop or
ページ15に含まれる内容の要旨
Remote Control (continued) Remote Control (continued) Using The Mouse/Keyboard Control Function CAUTION • Before connecting, read the manuals of the device you will connect. Mistaken use of the mouse/keyboard control could damage your equipment. • Only connect to a PC. • Do not unplug the connector cables while the computer is operating. Using the USB control feature, you can use the remote control as a simplified mouse or keyboard of the computer. Connect the M1-D port of the projector to the
ページ16に含まれる内容の要旨
I M1- D KEYS TONE SEARCH LENS SHIFT BNG RGB N PU T RESE T FOCUS ZOOM CO S M -VP ID OE N OENT IN TER MENU VIDEOS TANDBY/ON T EM P L AMP KEYSTONE LENS SHIFT RGB M1-DINPUT S R E E A SE RC TH FOCUS ZOOM COMPONENT BNG INTER VID SE -V O IDEO MENU STANDBY/ON TEMP LAMP M1-D KEYSTON SE EARCH LENS SHIFT BNG RGB INPUT RESET FOCUS ZOOM CO SM -VP ID O E N O ENT INTER MENU VIDEOSTANDBY/ON TEMP LAMP E O OL CONTROL NETWORK AUDIO IN1 R M TE CONTR AUDIO IN2 RGB RGB O UT AUDIO O UT CR/PR Ca/Pa Y R/CR/PR G/Y B/CB/P
ページ17に含まれる内容の要旨
KEYSTONE RGB M1-DINPUT SEARCH LENS SHIFT BNG RESET FOCUS ZOOM CO SM -VP IDEO ONENT INTER MENU VIDEOSTANDBY/ON TEMP LAMP KEYSTONE LENS SHIFT RGB M1-DINPUT S R EA ESR EC TH FOCUS ZOOM COMPONENT BNG INTER VID SE -V O IDEO MENU STANDBY/ON TEMP LAMP REMOTE CONTROL CONTROL NETWORK AUDIO IN1 AUDIO OUT AUDIO IN2 RGB RGB OUT CR/PR Ca/Pa Y R/CR/PR G/Y B/CB/PB H V R-AUDIO IN-L VIDEO S-VIDEO BNC CONTROL NETWORK AUDIO IN1 REMOTE CONTROL AUDIO IN2 RGB RGB OUT AUDIO OUT CR/PR Ca/Pa Y R/CR/PR G/Y B/CB/PB H V
ページ18に含まれる内容の要旨
Operating (continued) Operating (continued) Selecting The Aspect Ratio Press the Aspect button to toggle between the 1 modes for aspect ratio. LASER INDICATOR ■ At a M1-D signal STANDBY/ON VIDEO RGB + ++ NORMAL 4:3 16:9 LENS SHIFT FOCUS ZOOM –– – ASPECT button BLANK ASPECT LASER PREVIOUS NEXT memo NORMAL keeps the original aspect ratio of the ENTER input signal. ESC MENU ■ At a RGB signal (not M1-D) POSITION RESET AUTO MAGNFY PinP VOLUME ON FREEZE MUTE 16:9 4:3 OFF KEYSTONE SEARCH 1 2 3 ■
ページ19に含まれる内容の要旨
Operating (continued) Operating (continued) Adjusting The Picture Position memo This function is available only for RGB signals. Press the POSITION button. LASER INDICATOR 1 STANDBY/ON VIDEO RGB As illustrated on the right, a dialog will appear on the + ++ LENS SHIFT FOCUS ZOOM –– – screen to aid you in adjusting BLANK ASPECT LASER POSITION Cursor the position. buttons PREVIOUS NEXT ENTER Use the cursor buttons / / / to adjust the 2 position. ESC MENU POSITION POSITION RESET AUTO memo When y
ページ20に含まれる内容の要旨
Operating (continued) Operating (continued) Adjusting The Volume Press the VOLUME button. VOLUME LASER INDICATOR 1 STANDBY/ON VIDEO RGB As illustrated on the right, a dialog will appear on the screen to aid you + ++ LENS SHIFT FOCUS ZOOM –– – in adjusting the volume. BLANK ASPECT LASER Cursor buttons PREVIOUS NEXT Use the cursor buttons / to ENTER 2 adjust the volume. 16 ESC MENU POSITION RESET AUTO Press the VOLUME button again to close the MAGNFY PinP VOLUME VOLUME ON 3 FREEZE MUTE OFF dia
