Belkin OmniView PRO2 F1DA116Tの取扱説明書

ページ1に含まれる内容の要旨

Self Help Guide Self Help Guide
® ®
IMPORTANT! Pro 2 KVM Firmware Update Instructions
This Guide refers to the Please read the following carefully;
following Products:
Synopsis:
This guide will assist you in updating the firmware
of your Belkin OmniView Pro 2 KVM Switch.
Please be advised that firmware updates tend to
be to resolve specific issues and if there is any
doubt if the firmware will resolve your issue you
F1DA104T
should check with Technical Support.
PS/2 & USB
Requirements:
F1DA1

ページ2に含まれる内容の要旨

Self Help Guide Self Help Guide ® ® Pro 2 KVM Firmware Update Instructions Step 1 Before proceeding with the Firmware Update you will need to ensure that the Computer being used for the update process is ready. If you are running Windows 2000 or XP you will need to install an NT Direct Port Access Update prior to running the Flash Update. The NTPDA.exe file Update Utility can be downloaded from the same location as the Firmware Update files. Once downloaded, the file should be unzipped and t

ページ3に含まれる内容の要旨

Self Help Guide Self Help Guide ® ® Step 3 Plug the supplied Firmware Update Cable in to the (DB25) Parallel Port of a stand-alone Text Computer (i.e. one that is not currently connected to and controlled by the KVM) and connect the other end of the Cable into the (RJ45) Firmware Upgrade Port of the KVM. Step 4 Now that everything is setup the KVM can be flash upgraded. Double click the Icon of the Firmware Update File that you downloaded. Once open, click on the button in the KVM Firmware U

ページ4に含まれる内容の要旨

Self Help Guide Self Help Guide ® ® Step 5 Providing the Flash Upgrade is being performed successfully, you should see a Text Window with a Progress Bar similar to that shown below. Step 6 Once the Firmware Upgrade has been successfully completed an extra Window will appear with a message to this effect. Simply close this Window. Next, unplug both the Flash Update Cable from both KVM and the Computer, followed by the power cable to the KVM. The Dip Switches should then be returned to their