ページ1に含まれる内容の要旨
Model RK1
➤ O Ow wn ne er r’’s s G Gu uiid de e
ページ2に含まれる内容の要旨
limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of t
ページ3に含まれる内容の要旨
TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLU- SIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. Should you have any difficulties with the performance of this product during warranty, please call: 1-800-GO-CLARION or visit your local Ungo Pro
ページ4に含まれる内容の要旨
table of contents limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i standard configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 system maintenance . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
standard configuration controls the Lock/Panic ON/Panic OFF function. controls the Unlock function. controls Silent Lock/Unlock and an Auxiliary Output. controls remote engine start. / controls Timer mode. + controls Turbo/Short Run. + controls Channel 4 output. 2
ページ6に含まれる内容の要旨
what is included Control module Receiver/antenna Two four-button remotes Blue status LED indicator light Push-button Override switch Shut-down toggle switch important information Congratulations on the purchase of your remote engine start keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty. By carefully reading this Owner's Guide prior to usin
ページ7に含まれる内容の要旨
FCC/ID notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful inter- ference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsi- ble for compliance could void the user's authority to operate this device. C CA AU UT TIIO ON N:: This product is designed for fuel injected, a
ページ8に含まれる内容の要旨
standard configuration Button The lock and panic functions are controlled by pressing on the remote for one second. Button The unlock function is controlled by pressing on the remote for one second. Button Silent Lock/Unlock and an optional auxiliary function are controlled by this button in conjunction with the or button. (An optional auxiliary function, such as trunk release, can be controlled by pressing this button for 1.5 seconds. The auxiliary output controls __________________________. B
ページ9に含まれる内容の要旨
using your system warning! safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized dealer. When properly installed, this system can start the vehicle via a com- mand signal from the remote. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed area or wh
ページ10に含まれる内容の要旨
gear. This testing should be performed by an authorized dealer in accor- dance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease remote engine start operation imme- diately and consult with the authorized dealer to fix the problem. After the remote engine start module has been installed, contact your authorized dealer to have him or her test the remote engine start module by performing the Safety Check outlined in the product instal- lation g
ページ11に含まれる内容の要旨
locking Pressing for one second locks the doors (if the door locks are con- nected) and activates the starter kill. The horn will honk (if connected) and the parking lights will flash once to confirm arming of the system. While the system is locked, the status LED will flash once per second. The Starter Kill (if installed) will also prevent the vehicle’s starter from cranking. The system can also be programmed to arm the optional Starter Kill automatically (called Passive Mode). If the system ha
ページ12に含まれる内容の要旨
unlocking Pressing for one second unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm unlocking of the system. The optional Starter Kill will be deac- tivated. The status LED will turn off, unless the system is programmed for Passive Mode. In Passive Mode, the status LED will flash rapidly when the system is disabled. This indicates that the system will re- engage the starter kill and re-lock the doors (if Passive Locking h
ページ13に含まれる内容の要旨
override mode You can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. This is very useful when washing the vehicle or having it serviced. In override mode, the starter kill cannot be activated, even with the remote, but all conve- nience functions (door locks, remote engine start, etc.) will continue to work normally. To enter or exit override mode: 1. Turn the ignition on. 2. Turn the ignition off. DRW-35 3. Press an
ページ14に含まれる内容の要旨
remote engine start This feature allows you to remotely start and run your vehicle for a pro- grammable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote engine starting the vehicle. IIM MP PO OR RT TA AN NT T! ! (1) This product is not for use in m
ページ15に含まれる内容の要旨
When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the RUN (not the START) po- sition. 2. Press the brake pedal. N No otte e:: If the brake pedal is pressed before the key is in the ON posi- tion, the engine will shut down. While the vehicle is running during remote engine start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: The brake pedal is pressed. The
ページ16に含まれる内容の要旨
take-over mode The Override take-over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is use- ful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the cli- mate controls on. To perform Take-over mode: 1. Before turning off the engine, press and release on the remote twice in 3 seconds (or press and release the optional momentary switch). The parking lights
ページ17に含まれる内容の要旨
3. Press and release the and buttons at the same time. 4. The lights will flash to indicate the remote engine start has entered short run turbo mode. 5. Turn off the key, the engine will keep running. 6. Exit and secure the vehicle. 7. The engine will turn off after the programmed run time. timer mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration. The remote engine start can be shut off by the remote by pressin
ページ18に含まれる内容の要旨
6. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. iim mp po orrtta an ntt! ! Timer Mode should be used only in open areas. Never start and run the vehicle in an enclosed space such as a garage or carport. starter anti-grind circuity Whenever the vehicle is remote engine started, advanced anti-grind cir- cuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if
ページ19に含まれる内容の要旨
power-up This system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in override mode and the battery is disconnected for any reason, such as servicing the car, when the bat- tery is reconnected the unit will still be in override mode. This applies to all states of the system including lock, unlock, and override mode. programming options Programming options control your syste
ページ20に含まれる内容の要旨
Ignition switch-controlled door-locking on or off. With this feature on, the doors will lock 3 seconds after the ignition key is turned on, and unlock when the ignition key is turned off. Passive Locking or Active Locking (doors lock only with the remote). With Passive Locking, the vehicle doors lock automatically 30 seconds after the ignition has been turned off. Passive Locking can only be selected when the system has been programmed for Passive Mode. The horn honk confirmations for locking
