ページ1に含まれる内容の要旨
CD-R/RW DRIVE
SW-232
User's Guide
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. H
ページ2に含まれる内容の要旨
Contents Safety Precautions Safety Precautions 3 The following diagrams illustrate the precautions to be taken when using your CD-R/RW drive. Your CD-R/RW Drive 4 Upgrading the Firmware Flash Memory 5 System Requirements 5 Installing the CD-R/RW Drive 6 Connecting the Cables 6 Installing the CD Record Utility 9 Installing the Device Driver 9 Setting Up the Device Driver 10 Using the CD-R/RW Drive 11 Storing and Cleaning Your Discs 11 Solving Recording Problems 12 Caution with errors 13 Changes
ページ3に含まれる内容の要旨
Your CD-R/RW Drive Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the 5 6 following Web site: http:// www.samsungodd.com www.samsungelectronics.com System Requirements Before you install the CD-R/RW drive, we strongly recommend that you check that your setup meets the system requirements listed below. Item Description Computer Intel Pentium II (or higher), 64 MB of RAM (or higher) 12 3 4 with an E-IDE interface 1. Connector for stere
ページ4に含まれる内容の要旨
Installing the CD-R/RW Drive To install your CD-R/RW drive in the PC, proceed as follows. 2 Connecting the E-IDE cable Insert the IDE cable (40-pin), which is connected to the hard disk to the interface 1 Make sure that the PC is powered off and disconnected from any power source. terminal. (Place the red line of the cable close to the Pin 1.) 2 If necessary, attach a horizontal bracket to Pin 1 both sides of the drive. Key Slot Use of the brackets depends on your computer model; you can purchas
ページ5に含まれる内容の要旨
Installing the CD Record Utility To record data on a CD-R or CD-RW disc in the CD-R/RW drive, you must first 3 Installing a jumper on the master/slave select terminal install the CD record utility. For compatibility reasons, you are recommended to Connect a jumper to the rear side of the CD-R/RW. uninstall any existing software of the same type before installing this utility. If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it
ページ6に含まれる内容の要旨
Setting Up the Device Driver Using the CD-R/RW Drive To play audio or video CDs in your CD-R/RW drive, proceed as follows. Automatic Setup 1 Push the power button and boot the computer. 1 Insert the setup diskette in the diskette drive and change the directory to A:, 2 After booting the computer, open the disc where A: is the diskette drive. compartment by pressing the Eject button. To do so, type A: after the C:\ prompt and press [Enter]. 3 Insert the disc (CD) with the label on the disc 2 Ty
ページ7に含まれる内容の要旨
Solving Recording Problems Caution with errors If you have any problems recording via your CD-R/RW drive, Every CD-R or CD-RW drive records data by applying recording laser onto a CD. follow the appropriate instructions below for the source that you are using. If the CD is damaged or recording data is not possible, you need to remove the following causes of the error before using the CD. Hard Drive It is recommended to set a CD-R or CD-RW drive as follows. 1 Do not work on a multi-tasking envi
ページ8に含まれる内容の要旨
Recommended Disc Types Solving Technical Problems CD-R Ricoh, MCC, Ritek, CMC, MBI, PRINCO, SKC, BRALL Problem Meaning / Solution Samsung The CD-R/RW drive is not Check that the power, audio and IDE cables are CD-RW H/S-RW : Ricoh, Ritek, CMC, SKC correctly connected to the computer. detected by the computer. (4X-10X) Change the IDE cable and reconnect it to the CD-RW : Ricoh, Ritek, MCC, PRODISC, SKC After installing the CD-R/RW computer. (1X-4X) drive, the PC gets slower. Preferably, connect a
ページ9に含まれる内容の要旨
Technical Specifications SAMSUNG continually strives to improve its products. Both the design specifications Problem Meaning / Solution and these user instructions are thus subject to change without notice. When the MPEG software Adjust the size of the replay screen. ITEM SW-232 plays a Video CD, the DISC Disc types supported CD-DA, CD-ROM mode 1, CD-ROM XA mode 2, Form 1, After checking the display resolution, adjust it, pictures are not regular and in read mode Form 2, CD-Plus, CD-Extra, Photo
