ページ1に含まれる内容の要旨
INSTALLATION
QUICK-START
A typical system will use an IR receiver, several emitters, and a power supply
MODEL
all connected to a connecting block.
48195D
1. Connect the IR receiver to the “IR RCVR” port on the connecting
Dinky Link™ Surface Mount
block. The ‘red’ connector is installed to the ‘red’ plug.
Note: In some extended distances, additional 3-conductor may be required and can
Universal IR Receiver
be connected to the terminals on the connecting block.
2. Connect the Emitters to the
ページ2に含まれる内容の要旨
While it is possible to make wired connections without the connecting block, PLACEMENT it is not recommended. The connecting block reduces installation time, helps The IR receiver should be located so that it is not directly facing a light to eliminate errors, allows easy troubleshooting and permits easy system source such as lamps or displays (standard, LCD, and Plasma). When upgrades later, if needed. mounted near a display, it should be flush to the display and away from light reflections
ページ3に含まれる内容の要旨
While it is possible to make wired connections without the connecting block, PLACEMENT it is not recommended. The connecting block reduces installation time, helps The IR receiver should be located so that it is not directly facing a light to eliminate errors, allows easy troubleshooting and permits easy system source such as lamps or displays (standard, LCD, and Plasma). When upgrades later, if needed. mounted near a display, it should be flush to the display and away from light reflections
ページ4に含まれる内容の要旨
INSTALLATION QUICK-START A typical system will use an IR receiver, several emitters, and a power supply MODEL all connected to a connecting block. 48195D 1. Connect the IR receiver to the “IR RCVR” port on the connecting Dinky Link™ Surface Mount block. The ‘red’ connector is installed to the ‘red’ plug. Note: In some extended distances, additional 3-conductor may be required and can Universal IR Receiver be connected to the terminals on the connecting block. 2. Connect the Emitters to the
