ページ1に含まれる内容の要旨
FM788HB
INSTRUC TION MANUAL
VACUUM CLEANER
FM788HC
FM788HG
Contents
IMPORTANT SAFETY INSTRUCTIONS
1
NAME OF EACH PART
3
PREPARATION BEFORE USE
4
USING THE VACUUM CLEANER
6
USING THE ATTACHMENTS
8
EMPTYING THE DUST COMPARTMENT 10
CLEANING THE FILTERS 11
CLEARING BLOCKAGES IN THE
12
SUCTION HOSE AND CLEANING THE
AGITATOR ASSEMBLY
REPLACEMENT INSTRUCTIONS 13
TROUBLESHOOTING 17
REPLACEMENT PARTS 17
LIMITED WARRANTY
18
HOUSEHOLD AND COMMERCIAL USE
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following. READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING - To reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not allow
ページ3に含まれる内容の要旨
16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth which looks as though they may cause the hose to become blocked. 20. Do not clean or store the vacuum cleaner in places where there are high temperatures. 21. Store the vacuum cleaner away from excessive humidity. 22. When carrying the vacuum cleaner, hold it
ページ4に含まれる内容の要旨
FLOOR NAMES OF EACH PART FRONT REAR Handle Suction Hose A Power Cord Plug Release Button C Plug shown in figure Release may differ from actual Power Cord Button A plug attached to unit Release Carrying Handle for your area. Button B Duster Knob Cord Storage ON/OFF Switch Hooks Duster Dust Compartment Hose Holder Crevice Tool Wand Suction Hose B Filter Cover Upholstery Tool & Dusting Brush Handle Release Holder Lever Mount Rug/Floor (Tools) Height Adjustment Headlight SELECTOR Lever S
ページ5に含まれる内容の要旨
FLOOR PREPARATIONS BEFORE USE Caution: Do not connect the power cord plug to the wall outlet until assembly is completed. Attaching the handle Set the vacuum cleaner lnsert the handle 1 2 to the upright position. as shown in the illustration. Handle Attaching the suction hose A & attachments Wand Crevice Tool Suction Hose A Duster Suction Inlet Hose Cuff Upholstery Tool & Dusting Brush 4 R U G
ページ6に含まれる内容の要旨
FL OO R PREPARATIONS BEFORE USE WINDING THE POWER CORD Wind the power cord around 1 the cord storage hooks. Secure the power cord plug on the power cord. Cord Storage Hooks RELEASING THE POWER CORD Return the hook to the Rotate the upper cord 1 2 storage hook downward. upright position before attempting to rewind the power cord. Upper Cord Storage Hook THERMAL SAFETY DEVICE IN MAIN BODY To protect your vacuum cleaner motor from overheating, a thermal safety device has been built in.
ページ7に含まれる内容の要旨
USING THE VACUUM CLEANER ON/OFF SWITCH Start or stop vacuum cleaner by pushing ON/OFF Switch on the switch. OFF ON ADJUSTING THE HANDLE The handle of this vacuum cleaner can be set to one of three positions -Upright, Normal, Parallel. Place your foot on handle release lever as shown and pull back on the handle until it releases from its upright position. Handle Release Lever Upright position Normal position The handle is normally locked in this This position is used for normal cleaning. posit
ページ8に含まれる内容の要旨
FLO OR USING THE VACUUM CLEANER HEIGHT ADJUSTMENT LEVER Caution: Before using the height adj- ustment lever,please make sure the nozzle head is tilted Height Adjustment Lever backward from the floor. The nozzle head can be Nozzle Head adjusted to four different height settings. LOW Set the height adjustment to the Carpet appropriate carpet length. HIGH Bare Floor/Tools TURN OFF BRUSH ROLL WHEN USING TOOLS. RUG/FLOOR (TOOLS)SELECTOR The RUG/FLOOR(TOOLS)selector should only be adjusted whil
ページ9に含まれる内容の要旨
FLOOR FLOOR USING THE ATTACHMENTS Caution: When using one of the attachments during cleaning,set the vacuum cleaner to the upright position. Wand Remove the attachments from the 1 Crevice Tool vacuum cleaner. Press the release button C to Duster 2 disconnect the handle from the Release vacuum cleaner. Button C Caution: When removing the attachments, pull them in the directions shown in the illustration.Pulling them in the wrong direction or pulling the
ページ10に含まれる内容の要旨
USING THE ATTACHMENTS Hose Attachment Handle Suction Hose A Line up notches Suction Inlet push hose in till it Hose Cuff clicks. 9
ページ11に含まれる内容の要旨
EMPTYING THE DUST COMPARTMENT Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before cleaning. Empty the dust compartment when Press the release button A meanwhile 2 press the release button B to remove contents reach the MAX mark. 1 the dust compartment. Release Button A MAX mark Release Button B 3 Turn the duster knob several times in the Press the release lever to open the 3 4 direction shown to empty
ページ12に含まれる内容の要旨
CLEANING THE FILTERS Remove the dust compartment.(refer to page 10) 1 Set the dust compartment to the parallel 2 position.Open the trapdoor,then push the release button E and pull out the main filter. Release Button E The main filter and prefilter will be removed at the same time. Caution: Do not push the release button E at the upright position. 3 As this may drop or damage the main filter and prefilter. Clean the main filter and prefilter
ページ13に含まれる内容の要旨
FLOOR CLEARING BLOCKAGES AND CLEANING THE AGITATOR ASSEMBLY Caution: Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the power cord from the wall outlet before clearing any blockages in the suction hose and cleaning the agitator assembly. Cleaning blockages Cleaning blockages in the suction hose A, B Suction Hose A Set the vacuum cleaner to the upright position. 1 Suction Inlet Remove the hose cufffromthe suction inlet and
ページ14に含まれる内容の要旨
REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below. REPLACING THE HEADLIGHT LAMP Set the vacuum cleaner to the parallel position. 1 Loosen the screws to remove the lens. Screw 2 Lens When removing the headlight lamp, be careful 3 not to pull on the headlight lamp wiring. Remove th
ページ15に含まれる内容の要旨
REPLACEMENT INSTRUCTIONS Caution: Be sure to turn the ON/OFF switch to the"OFF" position and disconnect the power cord from the wall outlet before replacing any of the parts below. REPLACING THE FLAT BELT Remove the bottom plate. 1 (refer to page 15) Lift out the agitator assembly, and then remove the flat belt from the motor shaft and 2 the agitator pulley. Motor Shaft Flat Belt Place a new flat belt onto the motor shaft and pulley. 3 Motor Shaft Flat Belt Fla
ページ16に含まれる内容の要旨
REPLACEMENT INSTRUCTIONS REMOVING THE BOTTOM PLATE Set the vacuum cleaner to the 1 parallel position and turn it over. Loosen Screws Use a Philips screwdriver to loosen 2 the screw on the bottom plate and slide the latch in the direction of the arrow. Loosen Loosen Screw Screw Lift the bottom plate off. 3 Latch Mounting screw REATTACHING THE BOTTOM PLATE Insert the projection on the bottom plate Re-tighten the screw by using a Philips 1 2 into the groove on the nozzle housing screwdri
ページ17に含まれる内容の要旨
REPLACEMENT INSTRUCTIONS REPLACING THE FILTER Under normal usage, the HEPA Filter will require replacement once every three (3) months, however, vacuuming large amounts of extremely fine dust, powder or similar material over a long period of time may decrease airflow performance through the filter. If this occurs, it may become necessary to replace the HEPA Filter more often. Only use genuine FANTOM replacement filters. Filter Cover 1 Press in the locking tabs at points 1 1 and pull the f
ページ18に含まれる内容の要旨
TROUBLESHOOTING If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord from the wall outlet, and contact FANTOM Customer Service at 1-800-275-9251. Problem Cause R emedy The
ページ19に含まれる内容の要旨
THREE (3) YEAR LIMITED WARRANTY FAN TOM warrants this product to be free from defects in material and workmanship for a period of three (3) years from the date of the original purchase, when utilized for normal commercial or household use, subject to the following conditions, exclusions and exceptions. If your applianc e fails to operate properly while in use under norma l household or commercial conditions within the warranty period, return the complete applian
