Revolabs Inc.HDX 7000の取扱説明書

ページ1に含まれる内容の要旨

Revolabs Single Channel System - Polycom HDX 7000 Setup Guide
NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 7000 video codec.

1. Connecting the Cables
2. Configuring the HDX 7000 Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through

ページ2に含まれる内容の要旨

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL SYSTEM TO POLYCOM HDX 7000 VIDEO CODEC 1. Connect a Revolabs 2.5mm to RCA audio cable between the 2.5mm analog output on the Single Channel System and the red “Audio Input AUX” port on the HDX 7000.

ページ3に含まれる内容の要旨

Configuring the HDX 7000 Video Codec CONFIGURING THE AUDIO MENUS OF THE HDX 7000 VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS and enter the Administrator password (if needed) 3. Select AUDIO 4. Select AUDIO SETTINGS 5. Disable POLYCOM MICROPHONES by removing the check mark. Having Revolabs and Polycom microphones will increase ambient noise, add to echo cancellation problems, and reduce articulation* 6. Verify LIVE MUSIC MODE is disabled by removing the check mark. Polycom