ページ1に含まれる内容の要旨
PLEASE READ THIS MANUAL
BEFORE OPERATING THIS UNIT.
RETAIN FOR FUTURE REFERENCE.
AT60J / AT61J
OWNER’S MANUAL
ページ2に含まれる内容の要旨
The Audiobahn Way To bring the product to market that excites the consumer through sound and vision from an orientation of integrity and customer service. We make you look as good as you sound. We strive to take car audio to an extreme the world has never seen, and a world that never stops evolving. Audiobahn was established in 1997 with one long-term goal in mind, “Build it Bigger, Badder, & Better, and the people will take notice!” We back this statement with an engineering team that ha
ページ3に含まれる内容の要旨
TABLE OF CONTENTS Getting Started_________________________________________________ 2 Introduction____________________________________________________ 3 Specifications__________________________________________________ 4 Wiring________________________________________________________ 5 Installation_____________________________________________________ 6-8 Troubleshooting________________________________________________ 9 Warning and Disclaimer__________________________________________ 10 Warranty___
ページ4に含まれる内容の要旨
INTRODUCTION 3 Dear Customer, Congratulations on your purchase of the worlds finest brand of car audio products. Here at Audiobahn Inc. we are devoted to making our musical reproduction the vert best, and we are pleased you have chosen our product. Through years of engineering expertise, hand craftsmanship, and critical testing procedures, we have created a wide range of products that reproduce music with all the clarity and richness you deserve. For maximum performance we recommend you have
ページ5に含まれる内容の要旨
SPECIFICATIONS 4 AT60J BLACK STEEL CASE FERRO FLUID COOLED, HIGH-FLUX NEODYMIUM MAGNET FLUSH, SURF ACE AND FLEX MOUNT HARDW ARE 12dB CROSSOVER WITH AUDIOPHILE GRADE CAP ACIT ORS AND POL YSWITCH PROTECTION 4 OHM IMPEDANCE FREQUENCY RESPONSE: 2kHz - 22kHz POWER HANDLING 100 W A TTS RMS PER P AIR SENSITIVITY 90dB 1W / 1M AT61J BLACK STEEL CASE FERRO FLUID COOLED, HIGH-FLUX NEODYMIUM MAGNET FLUSH AND ANGLE SURF ACE MOUNT HARDW ARE 12dB CROSSOVER WITH AUDIOPHILE GRADE CAP ACIT ORS AND PO
ページ6に含まれる内容の要旨
Wiring 5 Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wires come in contact with the vehicles chassis. Makes sure that your audio system is off while installing and connecting your new Au- diobahn Speakers. Failure to do so could result in damaging the speaker beyond repair. This is not something that would be covered under the manufacturer warranty. Be sure to route
ページ7に含まれる内容の要旨
INPUT Installation 6 (AT60J MODEL ONLY) AT60 4 OHMS OUTPUT
ページ8に含まれる内容の要旨
Sean Wilson and Regin work at Audiobahn 2003 We all rock Installation 7 Angled Surface Mount This will allow you to mount your tweeter on the surface and give you the ability to have the tweeter facing in almost any direction that you desire. 1. Y ou will need to remove the center part of the double sided sticky tape 2. Remove one side of the protective backing of the tape and place it on the back of the angled mounting piece 3. Locate the proper position that you would like to mount the tweet
ページ9に含まれる内容の要旨
INPUT Installation 8 The crossover will allow the tweeter to play the Wiring the tweeter to the crossover correct frequencies without sending harmful low frequencies to the tweeter. 1. Make sure that you match the solid blue wire with the solid blue wire (Positive) AT60 4 OHMS 2. Make sure that you match the blue with black wire to the blue with black wire (Negative) Back of Tweeter If you are looking at the back of any of our Audio- bahn tweeters, the right wire is your positive (+) and t
ページ10に含まれる内容の要旨
Troubleshooting 9 In the event that your Audiobahn speakers appear to require service we ask that you first do a little troubleshooting to determine if the problem is actually the speaker , or a problem located in a dif ferent part of the vehicle such as the amplifier , wiring, fusing or possibly the source unit. If your Audiobahn speakers have been installed professionally by an authorized Audio- bahn Dealer, we recommend that you return to the dealer and demonstrate the problem to a qualif
ページ11に含まれる内容の要旨
Warning And Disclaimer 10 Investigate the layout of your automobile thoroughly before drilling or cutting any holes. Take care when you work near gas tanks, gas lines, hydraulic lines, and electrical wiring. Do not use the power ampli- fier unmounted. Attach the system securely to the automobile to prevent damage, particularly in the event of an accident. Do not mount the system so that the wire connections are unprotected or are subject to pinching or damage from nearby objects. The +1
ページ12に含まれる内容の要旨
WARRANTY 11 Audiobahn Consumer Product Warranty Policy Audiobahn products are manufactured with the highest quality components and some of the most advanced technology available. Because of this we recommend that you have your new products installed by an Au- thorized Audiobahn Dealer. (A list of Authorized Audiobahn Dealers can be found on our web page). Warranty Period: One year from the original date of purchase. Warranty Coverage: This warranty covers manufacturer defects only. The warr
ページ13に含まれる内容の要旨
WARRANTY CONTINUED 12 How to receive warranty service: Contact your local Authorized Audiobahn Dealer, or call Audiobahn at (714) 452.1476 between the hours of 9:00AM and 5:00PM PST. If you are having problems with your system, we recommend you check the product carefully and thoroughly to confirm that the product truly has a manufacturer defect; as opposed to abuse, or other components in the system caused the failure. This might include having an Authorized Audiobahn Dealer look at the pr
ページ14に含まれる内容の要旨
NOTES 13
ページ15に含まれる内容の要旨
NOTES 14
ページ16に含まれる内容の要旨
7050 Village Drive, Bldg G Buena Park, CA 90621 714-452-1476 o ce 888-880-8469 fax info@audiobahn.com PROUD SPONSOR OF Follow us on Facebook and Twitter
