ページ1に含まれる内容の要旨
Installation and
Operations Manual
POWER MODE
EJECT
AM/FM/CD RECEIVER PULL OPEN 4 X 50W
SEL
DIMMER
VOL
LOUD
MUTE
CONTROL
BAND DISP
VOL
SCAN AS/PS
12 MEM 3 PGM 4 RPT 5 RDM 6 INT 78 9 0
SHIFT ELAPSE
M5000CD
Waterproof
AM/FM/WB and CD Stereo Receiver
A Registered Trademark of Magnadyne Corporation
®
ページ2に含まれる内容の要旨
Introduction Your new M5000CD entertainment system has been designed to give you many years of listening pleasure. Take a moment to read through this manual and become familiar with the operations and features of this outstanding product. It is advisable to keep this manual in your vehicle so it is readily available for reference. Be sure to fill out and send in your warranty card to ensure that you receive the full benefits of warranty repair in the unlikely event that your system will need ser
ページ3に含まれる内容の要旨
Location and Function of Controls at a Glance 8. Multi-Function Button 3/PGM: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Directly accesses CD track number. Enters CD track program mode (See CD Operation for more information). 9. Multi-Function Button 4/RPT: Radio: Recalls a memorized radio station, and programs a radio station into memory (See Radio Operation for more information). CD: Directly accesses CD
ページ4に含まれる内容の要旨
Radio Operation Listening to the Radio Programming the Radio You can program up to 20 FM radio stations and 10 AM 1. Push the “POWER” button (1) once to turn the unit on. radio stations. 2. Press the “BAND” button (12) to select a radio Manual Station Recall Programming band: FM1, FM2, AM or WX (weather band). 1. Press the “BAND” button (12) to select a radio 3. AM or FM Station Selection band: FM1, FM2, or AM. Automatic Seek Station Selection: Press the 2. Select the desired station. or button
ページ5に含まれる内容の要旨
General Operations Setting the Clock Selecting a Mode 1. Press DISP button (13) for more than 3 seconds Press the MODE button (17) to step sequentially until the clock shown in the display area is flashing. through the following sources: Radio Mode to Radio Tuner > CD > CD Changer (optional) > 2. Press the button to adjust the hours Auxiliary > Radio Tuner. 3. Press the button to adjust the minutes. Illumination Dimmer Display Priority Press LOUD / DIMMER button (15) for more than Clock Display
ページ6に含まれる内容の要旨
CD Player Operation Inserting and Ejecting a Disc 3 PGM desired order. Then press the button for Pull the tab at the top of the CD Door, and the several seconds to play the CD in programmed door will open. Push a disc into the CD Slot (20), order. When you have programmed 32 tracks, label side up, and the disc will begin to play. “FULL” will appear in the display. Press the EJECT button (16) to stop CD play and eject the disc. The disc will also eject auto- • When the CD is played in programmed
ページ7に含まれる内容の要旨
Wiring Gray Cable with Red/White RCA Connectors: Step 1: The radio chassis is designed to be “Panel Provides L/R Channel audio signal output to an Mounted” through a opening in the mounting panel. additional amplifier. See the installation part of this manual for panel mounting. Note: This unit is designed to connect to (4) four speakers. If the installation only requires (2) two Step 2: Bring all wiring for the connection of the speakers, use the White and Gray wire sets to con- unit (includin
ページ8に含まれる内容の要旨
Wiring Diagram M5000CD Red Right Channel Antenna Socket Yellow Cable Auxiliary In Ignition Red Wire White Switch (+12v in ) Left Channel Battery Yellow Wire (+12v in) Red Black Wire Ground (B-) Right Channel Gray Cable Audio Line Out Power Antenna Blue Wire (Switched Connect to Line Input +12v out) of Optional Amplifier White Left Channel Left Right White Wire Gray Wire Front Front Speaker Speaker Gray Wire with Black Stripe White Wire with Black Stripe Left Right Green Wire Violet Wire Rear R
ページ9に含まれる内容の要旨
CD Changer Connection M5000CD CD Changer (Optional) Male to Male 8-Pin Din Cable 8-Pin Din Connector (Supplied with CD changer) Auxiliary Connection VCR Audio Out From M5000CD or VCR / TV / Video Game TV Red RCA (Right) Auxiliary Audio Input RCA with Yellow Cables or White RCA (Left) Video Game Wired Remote Connection Wired Remote (Optional) M5000CD Female 8-Pin Male 8-Pin Mini Din Connector Mini Din Connector 9
ページ10に含まれる内容の要旨
Installation Remove Transportation Screws Mounting Surface Before installing the unit, remove the two screws shown in the illustration below. Mounting Location Remove Transportation Screws Before Installation Mounting Holes 3. Use the glue paper to stick the two mounting brackets to the back of the mounting surface. The screw holes of the brackets must respec- tively aim at the mounting holes in order to fix the unit to the mounting surface. 4. Open the two pieces of rubber cover on the unit No
ページ11に含まれる内容の要旨
Installation Sheet Metal Screw Nut Washer Metal Strap Mounting Surface Trouble Shooting Before going through the trouble shooting table below, check the wiring connection. If the problem persist, consult your nearest service dealer. SYMPTOM CAUSE SOLUTION No power The ACC Power Supply is not Both the red and yellow connected. wires require power from the power source. The fuse is blown. Replace the fuse. Disc cannot be loaded, Presence of disc inside the player. Remove the disc in the player,
ページ12に含まれる内容の要旨
Specifications GENERAL CD PLAYER AM RADIO Power Supply Signal to Noise Ratio: Frequency Coverage: Requirements: > 55 dB 530 to 1710 kHz DC 12 Volts, Negative Channel Separation: Sensitivity (S/N=20dB): Ground > 50 dB 32 dBu Chassis Dimensions: Frequency Response: 178 mm (W) x 165 (D) x 40Hz – 18 kHz 50 (H) Tone Controls: FM RADIO Bass: 100 Hz ±10 dB Frequency Coverage: Treble: 10 kHz ±10 dB 87.5 to 107.9 MHz Maximum Output Power: Sensitivity (S/N=30dB): 4 x 50 watts 3µV Current Drain: Stereo Sep
