ページ1に含まれる内容の要旨
5 6
4 7
3 8
2 9
SPEED
MIN 1 MAX 10 HI LOW
COOL COOL
FAN ONLY
POWER
Wait 3 Minutes Before Restarting
ON OFF
HWF05XC5 HWR05XC5
0010551959
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
1
ページ4に含まれる内容の要旨
2
ページ5に含まれる内容の要旨
6-7 8-11 8 8-11 12-16 13 13 14-16 17-18 18-19 20 3
ページ6に含まれる内容の要旨
Important: Test power plug before each use: 1. Press ìreset ìbutton. 2 . Press ìtest ìbutton, unit should trip. 3. Press ìresetî button again for use . Do not use if above test fail. In the event this device trips , the cause of the malfunction is to be corrected before further use of the device . 4
ページ7に含まれる内容の要旨
5
ページ8に含まれる内容の要旨
easy 2-way control access panel airflow filters 5 6 4 7 3 8 2 9 SPEED 1 10 HI LOW COOL MIN COOL MAX FAN ONLY Wait 3 Minutes Before POWER Restarting ON OFF MODEL: HWF05XC5 2. MODE Set Switch 6
ページ9に含まれる内容の要旨
easy 2-way control access airflow panel filters TIME ON TIME OFF HI SPEED LOW SPEED FAN COOL ON/OFF POWER MODEL: HWR05XC5 2. fan Speed Pressing the Fan Speed button of remote control between High and Low speed. 7
ページ10に含まれる内容の要旨
MODEL: HWF05XC5 5 6 4 7 3 8 9 2 SPEED 1 10 HI LOW MIN MAX COOL COOL FAN ONLY POWER Wait 3 Minutes Before Restarting ON OFF 8
ページ11に含まれる内容の要旨
POWER Turns air conditioner off. SPEED "LOW" Low speed fan operation with cooling or not. SPEED "HI" High speed fan operation with cooling or not. This automatically controls the temperature of indoor air. Turn the knob so that arrow points to the cooler marks for more moderate cooling. Normal Fan 1. Turn the SPEED mode switch to the "HI" or the "LOW" setting. 2. Set the thermostat control to the temperature mark "FAN ONLY". Normal cooling 1. Turn the SPEED mode switch to the "HI" or the "LOW"
ページ12に含まれる内容の要旨
MODEL: HWR05XC5 Control Panel 1 ON/OFF TIME ON 2 TIME OFF MODE SPEED TIMER HI SPEED 3 LOW SPEED 4 TEMP/TIME 1 FAN COOL 5 POWER ON/OFF 10
ページ13に含まれる内容の要旨
1. ON/OFF To turn set ON, press the button. To turn set OFF, press the button again. 2. TIMER Press TIMER button, for each press, TIMER mode will changes as follows: TIMER ON TIMER OFF CANCEL 3. FAN Pressing the FAN button changes between LOW and HIGH SPEED. 4. MODE Every time you press this button, it will change between COOL and FAN. 5. TEMP./TIME Used to set temperature and time. 11
ページ14に含まれる内容の要旨
12
ページ15に含まれる内容の要旨
wood screws 31/32" toprail window seal gasket short screws 13/32" Model: HWF05XC5 wood screws 31/32" toprail window seal gasket ON/OFF MODE SPEED TIMER TEMP/TIME short screws 13/32" Remote ìCR2025ì battery control Model: HWR05XC5 13
ページ16に含まれる内容の要旨
5 6 3 4 7 8 2 MIN 1 MAX 10 9 HI SPEED LOW COOL FAN ONLY COOL Wait 3 Minutes Before Restarting POWER ON OFF HWF05XC5,HWR05XC5 31 1 32 5 11 8 13 11 16 7 34 16 15 20 32 7 11 16 5 17 16 13 13 32 ASSEMBLE CURTAINS/TOP RAIL Install top rail with 3 short screws13/32". Insert the side curtains into the top and bottom rails of the air conditioner. Fasten the curtains to the unit with 8 short screws 13/32". 14
ページ17に含まれる内容の要旨
INNER 2 SILL I O N U D T 1. This unit is designed for installation in standard double hung windows O D with actual opening widths of 21 to 35 . The upper and lower sash O O R O must open sufficiently to allow a clear vertical opening of 12 from the OUTER S R bottom of the sash to the window stool. SILL S 2. If storm window presents interference, fasten a 2 wide wood strip(not included) (OUTER SILL) to the inner window sill across the full width of the sill. The wood strip should be thick enough
ページ18に含まれる内容の要旨
INSTALL THE AIR CONDITIONER WINDOW FRAME IN THE WINDOW UPPER GUIDE Carefully lift the air conditioner and slide it into the open ABOUT 1/4 window. Make sure the bottom guide of the air conditioner drops into the notches of the basepan angle. While steadying the air conditioner ,carefully bring the window sash down behind the upper guide of the air conditioner. BOTTOM GUIDE BASEPAN ANGLE INSTALL THE SEAL GASKET AND SASH LOCK WINDOW SEAL GASKET BASEPAN ANGLE SHORT SCREW13/32" Extend the side curta
ページ19に含まれる内容の要旨
Always unplug your air conditioner before cleaning. The air filter behind the inlet grille should be checked and cleaned at least once every 2 weeks (or as necessary) to maintain optimal performance of the air conditioner. How to remove the air filter 1. The grille may be opened from the top for easy maintenance after installation. 2. Open the inlet grille by pulling off the exposed door on the top of the unit(based on the installation). 3. Pull the tab slightly to release the filter. Pull the f
ページ20に含まれる内容の要旨
18
