ページ1に含まれる内容の要旨
TABLE OF CONTENTS
SECTION PAGE
1
INTRODUCTION .............................................................3
1
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE ...........................7
2
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE ............................49
3
4
UNDERSTANDING YOUR INSTRUMENT PANEL ..................................81
4
5
STARTING AND OPERATING ................................................143
5
6
WHAT TO DO IN EMERGENCIES .............................................197
6
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
INTRODUCTION 1 CONTENTS Introduction ........................... 4 Vehicle Identification Number .............. 6 How To Use This Manual ................. 4 Vehicle Modifications / Alterations .......... 6 Warnings And Cautions .................. 6
ページ4に含まれる内容の要旨
4 INTRODUCTION INTRODUCTION WARNING! This manual has been prepared with the assistance of service and engineering specialists to acquaint you with Engine exhaust, some of its constituents, and certain the operation and maintenance of your new vehicle. It is vehicle components contain or emit chemicals supplemented by a Warranty Information Booklet and known to the State of California to cause cancer and various customer oriented documents. You are urged to birth defects or other reproductive har
ページ5に含まれる内容の要旨
INTRODUCTION 5 1
ページ6に含まれる内容の要旨
6 INTRODUCTION WARNINGS AND CAUTIONS This manual contains WARNINGS against operating procedures which could result in an accident or bodily injury. It also contains CAUTIONS against procedures which could result in damage to your vehicle. If you do not read this entire manual you may miss important information. Observe all Warnings and Cautions. VEHICLE IDENTIFICATION NUMBER The vehicle identification number (VIN) is on a stamped plate on the left front corner on the body of the vehicle, visible
ページ7に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 2 CONTENTS A Word About Your Keys ................. 9 ▫ Central Locking — If Equipped ............15 ▫ Ignition Key Removal ................... 9 ▫ Door Ajar Warning .....................15 ▫ Automatic Transaxle Ignition Interlock System . .10 ▫ Automatic (Rolling) Door Locks ............15 ▫ Key-In-Ignition Reminder ................10 ▫ Automatic Unlock On Exit — Only Available If Automatic Door Locks Are Enabled .........16 Sentry Key — If Equipp
ページ8に含まれる内容の要旨
8 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE ▫ To Use The Panic Alarm .................19 ▫ Seat Belt Pretensioners ...................30 ▫ To Program Additional Transmitters .........19 ▫ Enhanced Driver Seat Belt Reminder System (BeltAlert) ...........................30 ▫ General Information ....................20 ▫ Seat Belts And Pregnant Women ............31 ▫ Transmitter Battery Service ...............21 ▫ Seat Belt Extender ......................31 Vehicle Theft Alarm ..................
ページ9に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 9 A WORD ABOUT YOUR KEYS Ignition Key Removal You can insert the double sided keys into the locks with either side up. 2 The dealer that sold you your new vehicle has the key code numbers for your vehicle locks. These numbers can be used to order duplicate keys from your dealer. Ask your dealer for these numbers and keep them in a safe place. Ignition Key Positions Place the shift lever in PARK and make sure that the gearshift knob push button has retu
ページ10に含まれる内容の要旨
10 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE NOTE: If you try to remove the key before you place CAUTION! the lever in PARK, the key may become trapped tempo- rarily in the key cylinder. If this occurs, rotate the key An unlocked car is an invitation to thieves. Always clockwise slightly, then remove the key as described. If a remove key from the ignition and lock all doors malfunction occurs, the system may trap the key in the when leaving the vehicle unattended. ignition cylinder to warn you
ページ11に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 11 SENTRY KEY — IF EQUIPPED the vehicle. These devices cannot damage the Sentry With this system, an electronically coded ignition key Key System, but can cause a momentary problem sends a signal to the vehicle electronics. If the electronics when attempting to start the engine. If a problem recognizes the signal, the vehicle will start and continue occurs, remove the Sentry Key from the key ring and 2 to run. If the system does not recognize the signa
ページ12に含まれる内容の要旨
12 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Replacement Keys Customer Key Programming You can program new keys to the system if you have two NOTE: Only keys that have been programmed to the valid keys by doing the following: vehicle electronics can be used to start the vehicle. Once a Sentry Key has been programmed to a vehicle, it can 1. Insert the first valid key into the ignition and turn the not be programmed to any other vehicle. ignition On for at least 3 seconds but no longer than 15 s
ページ13に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 13 General Information DOOR LOCKS The Sentry Key system complies with FCC rules part 15. Operation is subject to the following two conditions: WARNING! 2 1. this device may not cause harmful interference For personal security and safety in the event of an 2. this device must accept any interference that may be accident, lock the vehicle doors as you drive and received, including interference that may cause undes- when you park and leave the vehicle. ir
ページ14に含まれる内容の要旨
14 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Power Door Locks There is a door lock switch on each front door trim panel located to the front of the door handle. Press this switch to lock or unlock the four doors. Door Lock Plunger If the door lock plunger is down when you shut the door, the door will lock. Therefore, make sure that the keys are not inside the vehicle before closing the door. Power Door Lock Switch The rear doors cannot be opened from inside the vehicle If you press the door lo
ページ15に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 15 Central Locking — If Equipped The Automatic Door Locks can be disabled or re-enabled All vehicle doors are locked with the first turn of the key by performing the following procedure: to the LOCK position. The double activation feature 1. Close all doors and place the key in the ignition. requires you to turn the key in the cylinder lock two 2 times within five seconds to UNLOCK all vehicle doors 2. Cycle the ignition switch between OFF and ON/RUN a
ページ16に含まれる内容の要旨
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Depress the power door lock switch to lock the doors. Automatic Unlock on Exit — Only Available if Automatic Door Locks are Enabled This feature will unlock all the doors when the driver’s door is opened and the ignition switch is in the LOCK position. This function is disabled as delivered from the factory. Automatic Unlock on Exit can be enabled or disabled by performing the following procedure: 1. Close all doors and place the key in the ignit
ページ17に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 “Child Protection” Door Lock System (Rear Doors) To provide a safer environment for small children riding in the rear seat, the rear doors of your vehicle have the 2 “child-protection” door lock system. To use the system, open each rear door and use a key to move the control near the door latch UP to the “Engage” position as shown on the door label. When the system on a door is engaged, that door can be opened only by using the outside door handle.
ページ18に含まれる内容の要旨
18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE REMOTE KEYLESS ENTRY — IF EQUIPPED 1. Press and hold the Unlock button on the transmit- This system allows you to lock or unlock the doors or ter. open the trunk from distances up to 23 feet (7 meters) 2. Continue to hold the Unlock button, wait at least 4 using a transmitter. You don’t have to point the transmit- but no longer than 10 seconds, then press the LOCK ter at the vehicle to activate the system. button. 3. Release both buttons. The headli
ページ19に含まれる内容の要旨
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 19 To lock the doors: 2. Continue to hold the Unlock button, wait at least 4 The horn will chirp and the headlamps will flash once to but no longer than 10 seconds, then press the Trunk acknowledge the lock signal. button. 2 NOTE: The horn chirp can be enabled or disabled by 3. Release both buttons. the following procedure: Panic Alarm 1. Press and hold the Lock button on the transmitter. The panic mode unlocks the driver’s door, turns on the interior
ページ20に含まれる内容の要旨
20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 2. Using a currently programmed transmitter, press the General Information Unlock button on the transmitter. Continue to hold the This transmitter complies with FCC rules part 15 and Unlock button, wait at least 4 but no longer than 10 with RS-210 of Industry Canada. Operation is subject to seconds, then press and hold the Panic button for at least the following two conditions: one second. Release both buttons simultaneously. You 1. This device may
