ページ1に含まれる内容の要旨
OPERATING INSTRUCTIONS
En (English)
CD Stereo System
MANUAL DE INSTRUCCIONES
E (Español)
XR-X77
U C
MODE D'EMPLOI
F (Français)
Owner’s record
For your convenience, record the model number and serial
number (you will find them on the rear of your set) in the space
provided below. Please refer to them when you contact your
Aiwa dealer in case of difficulty.
Model No. Serial No. (Lot No.)
For assistance and information
(United States and Puerto Rico)
8C-CL2-903-01
020305BSW-H-M
ページ2に含まれる内容の要旨
WARNING IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Read the Operating Instructions carefully and completely before Ventilation - The unit should be situated with adequate space operating the unit. Be sure to keep the Operating Instructions for around it so that proper heat ventilation is assured. Allow 13 cm future reference. All warnings and cautions in the Operating clearance from the rear and the top of the un
ページ3に含まれる内容の要旨
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ......... 2 Outdoor Antenna Lightning PREPARATIONS ................................... 4 Power lines - An outside antenna system should not be located For added protection for this unit receiver during a lightning storm, PARTS AND CONTROLS ......................... 5 in the vicinity of overhead power lines or other electric light or power or when it is left unattended and unused for long periods of time, ADJUSTMENTS BEFORE OPERATION .......... 7 ci
ページ4に含まれる内容の要旨
PREPARATIONS 3 Connect the supplied antennas. Connection Remote control Connect the FM antenna to the FM 75 terminals and Plug in the AC power cord to the AC outlet after all other Detach the battery compartment lid at the rear of the remote the AM antenna to the AM LOOP jack. Connect the FM connections are made. control and insert two R6 (size AA) batteries with correct antenna to the FM 75 terminals without the 2 mark, polarity. as illustrated. 1 Connect the speaker cords to the speakers. FM
ページ5に含まれる内容の要旨
PARTS AND CONTROLS 8 DIGITAL OUT (OPTICAL) jack Main unit CD digital sound signals can be output through this jack. Use an optical cable to connect digital audio equipment. 12 3 4 8 90 Remove the dust cap from the DIGITAL OUT (OPTICAL) jack. Then connect an optical cable plug to the DIGITAL OUT (OPTICAL) jack. 9 AM LOOP jack and FM 75 terminal En Plug in the supplied AM and FM antennas. 0 SPEAKERS3 terminals Connect the supplied speaker cords. ! AC power cord @ VIDEO/AUX IN jacks !@ #$ Accept
ページ6に含まれる内容の要旨
The numbered buttons take on these functions when pressed with 8 PRESET +, - Remote control SHIFT held down: 9f/r, t/g CLOCK 0 VOLUME +, - Selects clock mode. 1 7 ! SLEEP TUNER MODE Selects sleep-timer mode. 2 Switches between stereo or monaural FM reception. En DISPLAY Changes the display in CD playback mode. 3 8 TIMER 4 Selects timer mode. 9 5 3 RANDOM/REPEAT 0 6 Selects random or repeat CD playback mode. ! PROGRAM Selects programmed CD playback mode. 4ECD Buttons with the same or similar name
ページ7に含まれる内容の要旨
ADJUSTMENTS BEFORE OPERATION ECO mode ECO/DIMMER POWER Reduces power consumption in standby mode with the following POWER 6STANDBY/ON SET operations. Press ECO/DIMMER while the power is off (standby). Each press of the button changes the mode as follows; CD,AUX TUNER/BAND ECO ON: Power economizing mode is activated. En When the unit turns off, everything on the display clears and SET f,g only the red indicator on POWER lights to show that the power is being supplied. f,g ECO OFF: Power econo
ページ8に含まれる内容の要旨
CD OPERATIONS To change the display in playback mode 0–10, +10 Press DISPLAY (hold down SHIFT and press DISPLAY on the DISPLAY remote control) during play. E zOPEN/CLOSE DISPLAY The display changes in the following order: Track number being played and elapsed playing time RANDOM/ Remaining time of play E REPEAT •Remaining time of play cannot be displayed during 1, " s En random or programmed play. PROGRAM f,g To remove the disc SHIFT Press zOPEN/CLOSE in stop mode to open the disc s compartmen
ページ9に含まれる内容の要旨
To check the program Random/Repeat play Programmed play Press f or g repeatedly in stop mode. The track In random play mode the unit plays all the tracks in random Plays back up to 30 selected tracks in programmed order. number and program number are displayed in succession. order. In repeat play mode it plays repeatedly all the tracks or 1 Press PROGRAM on the remote control in stop To clear the program the track being played. You can select random and repeat all mode. play at the same time. P
ページ10に含まれる内容の要旨
RADIO OPERATIONS Tuning in preset stations TUNER MODE 1 Select the band. TUNER/BAND SET 2 Press PRESET (PRESET +, - 1on the remote control) repeatedly. 0–10, +10 With each press, the station with the succeeding (or preceding) preset number is tuned in. PRESET +,- s En You can tune in the desired preset station directly by TUNER/BAND pressing the numbered buttons on the remote control. SET f,g -To select preset number 11, press +10 and 1. SHIFT -To select preset number 15, press +10 and 5. POWER
ページ11に含まれる内容の要旨
SOUND ADJUSTMENTS Adjustments To switch to monaural FM reception TONE Hold down SHIFT and press TUNER MODE on the remote control so that "MONO" is displayed. To cancel, repeat the above so that "STEREO" is displayed. Tip: En TONE When FM stereo reception is poor, switching to monaural f,g reduces noise. VOLUME +,- To switch the AM tuning interval VOLUME The default setting of the AM tuning interval is 10 kHz/step. If f,g you use this unit in an area where the frequency allocation system is 9 kHz
ページ12に含まれる内容の要旨
TIMER OPERATIONS Sleep timer POWER TUNER/BAND, AUX, ECD Turns off the unit automatically after a specified time. SET 1 Press SLEEP on the remote control. CLOCK "SLEEP" is displayed. TIMER TUNER/BAND, 2 Within 6 seconds, press f or g repeatedly AUX, ECD, to set the sleep timer duration. En s With each press, the timer duration changes in 5-minute f,g SET steps between 5 to 240 minutes. If there is no button input VOLUME+,- for 6 seconds, the current setting is entered automatically. SHIFT VOLU
ページ13に含まれる内容の要旨
7 Prepare the source. To check the timer setting Timer playback To play CD, load a disc. Hold down SHIFT and press TIMER on the remote control so Turns on the unit at a specified time for the specified duration. To play the radio, select the band and tune in the desired that " PLAY" appears on the display. Make sure the clock is set correctly. station. The timer-on time, the source and the timer-activated duration To play external equipment connected to the VIDEO/AUX are displayed for 12 seconds
ページ14に含まれる内容の要旨
REFERENCE Condensation Care and maintenance Troubleshooting Moisture may form on the CD pickup lens when: Occasional care and maintenance of the unit and the software If your unit fails to perform properly, check the following guide •The unit is moved from a cold spot to a warm spot are needed to optimize the performance of your unit. and the relevant sections of the Operating Instructions. •The heating system has just been turned on •The unit is used in a very humid room To clean the cabinet Th
ページ15に含まれる内容の要旨
GENERAL COPYRIGHT Specifications Power requirements 120 V AC, 60 Hz Check copyright laws relevant to recordings from discs or radio MAIN UNIT CX-LX77 Power consumption 35 W for the country where the unit is to be used. TUNER Power consumption in standby mode FM tuning range 87.5 MHz to 108 MHz With ECO mode on: 0.6 W With ECO mode off: 13 W FM usable sensitivity (IHF) 13.2 dBf ∗ FM antenna terminal 75 ohms (unbalanced) Dimensions (W × H (H ) × D) 249.8 × 92 (220.8) × 337.7 mm 7 3 3 3 AM tuning r
ページ16に含まれる内容の要旨
NOTE REMARQUE CAUTION This equipment has been tested and found to comply with the Cet appareil a été testé et jugé conforme aux limites des TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, limits for a Class B digital device, pursuant to Part 15 of the appareils numériques de Classe B, conformément à la Partie RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN FCC Rules. These limits are designed to provide reasonable 15 des Règles FCC. Ces limites sont conçues po
