ページ1に含まれる内容の要旨
M Mo od de ell S S1 10 00 0
➤ O Ow wn ne er r’’s s G Gu uiid de e
ページ2に含まれる内容の要旨
limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of t
ページ3に含まれる内容の要旨
TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLU- SIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. Should you have any difficulties with the performance of this product during warranty, please call: 1-800-GO-CLARION or visit your local Ungo Pro
ページ4に含まれる内容の要旨
table of contents limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i standard remote configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 system maintenance . . . . . . . . . . . . . . . . . . . . . . .
ページ5に含まれる内容の要旨
standard remote configuration controls the Arm function. controls the Disarm function. controls Silent Arm/Disarm and an Auxiliary output. controls the Panic function. and pressed together control an Auxiliary output. 2
ページ6に含まれる内容の要旨
what is included ➤ One control module ➤ A pair of four-button remotes ➤ A dual-stage shock sensor ➤ A six-tone programmable siren ➤ The blue status LED indicator light ➤ A push-button override switch ➤ Starter kill ready circuitry (may require additional labor) ➤ External receiver/antenna important information Congratulations on the purchase of your state-of-the-art vehicle securi- ty system. This system has been designed to provide years of trouble- free operation. Due to the complexity of th
ページ7に含まれる内容の要旨
system maintenance The system requires no specific maintenance. Your remote control is powered by a small, lightweight 3 volt lithium battery that will last approximately one year under normal use. When the battery weakens, operating range will be reduced and the LED on the remote will dim. fcc/id notice This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any inte
ページ8に含まれる内容の要旨
standard configuration Button The arming function is controlled by pressing this button for one second. Button The disarming function is controlled by pressing this button for one second. Button Silent Arm/Disarm and an optional auxiliary function are controlled by pressing this button. (Silent Arm/Disarm works by pressing this button for less than one second before arming or disarming. An optional aux- iliary function, such as trunk release, can be controlled by pressing this button for 1.5 sec
ページ9に含まれる内容の要旨
using your system The buttons used in the instructions in this manual correspond to the standard configuration. Remember, this is not the only way your remote may be set up. It can be custom configured to meet your needs. active arming You can activate, or arm, the system by pressing on your remote for one second. When the system arms, you will hear a short siren sound, or chirp, and the parking lights will flash once. If the vehicle’s power door locks have been connected to the system, the door
ページ10に含まれる内容の要旨
vides you with a 10-second warning prior to arming. n no otte e:: If any protected entry point (such as a door or a switch- protected trunk or hood) is open, the system will not passive- ly arm (unless forced passive arming is programmed on). See Programming Options section of this guide. Additionally, each time a protected entry is triggered during the arming countdown, the 30-second countdown starts over. When armed, your vehicle is protected as follows: ➤ Light impacts will trigger a warning
ページ11に含まれる内容の要旨
remote sensor bypass Remote Sensor Bypass allows you to select which of the security sys- tem's inputs or sensors will be active and which will be bypassed at the time that the system is armed. (See the Table of Zones section of this guide.) Pressing again within five seconds of arming the security system will activate the Remote Sensor Bypass feature. Each time is pressed again, a different security level is selected. The different secu- rity levels can be selected as follows: ➤ Press one time
ページ12に含まれる内容の要旨
arming while driving Your system can be armed while driving the vehicle. Simply press on your remote for two seconds while the vehicle is running or while the igni- tion is on. The siren will chirp once and then once more to indicate that the ignition is on. The security system will not respond to any input except the door triggers and the Starter Kill (if installed) will not be activated. The security system will disarm automatically whenever the ignition is turned off. The siren will chirp twi
ページ13に含まれる内容の要旨
diately. The six second timer is provided for your convenience, in case the system is accidentally triggered. disarming without a remote This feature allows you to disarm the security system without the remote should it be lost, damaged, or disabled. In order to disarm the system without a remote, you must have the vehicle’s ignition key and know where the override switch is located. Be sure to check with the installer for the location and the number of presses of the override switch required to
ページ14に含まれる内容の要旨
silent mode To temporarily turn off the arm or disarm chirps, use Silent Arm/Disarm. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. n no otte e:: The warning response to lighter impacts is bypassed if the system is armed using Silent Arm/Disarm. This ensures that no chirps will be emitted by the siren in an are
ページ15に含まれる内容の要旨
override mode You can prevent your security system from automatically arming and triggering by using Override Mode. This is very useful when washing the vehicle or having it serviced. In Override Mode, the security system will not arm, even with the remote remote, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Override Mode: 1. Turn the ignition on. 2. Turn the ignition off. DRW-35 3. Press and release the Override switch wit
ページ16に含まれる内容の要旨
false alarm prevention circuitry Your system has false alarm prevention circuity. It prevents annoying repetitive trigger sequences due to faulty door pin switches or environ- mental conditions such as thunder, jackhammers, airport noise, etc. Example If the alarm triggers three times within a 60-minute period and each time the same sensor or switch triggers the alarm, The system will inter- pret those triggers as false alarms. After the third trigger, The system ignores, or bypasses, that senso
ページ17に含まれる内容の要旨
diagnostics The microprocessor at the heart of your security system is constantly monitoring all of the switches and sensors that are connected to it. It detects any faulty switches and sensors and prevents them from dis- abling the entire system. The microprocessor will also record and report any triggers that occurred during your absence. Refer to the System Status Chirps and Table of Zones charts for diagnostic information. arming diagnostics If the system is armed while an input is active (d
ページ18に含まれる内容の要旨
of Zones section of this guide.) The system will retain this information in its memory, and continue to chirp four or five times each time it is disarmed, until the next time the ignition key is turned on. system status chirps The siren will chirp when arming/disarming the system. The pattern of chirps will audibly report the system’s status as described below. Action Number of Chirps Description Arm 1 System armed Arm 1 (3-second delay), 1 System armed with open zone notification Disarm 2 Syst
ページ19に含まれる内容の要旨
table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below, along with spaces to write in any optional sensors or switches you have had installed. Zone - Number Dealer-Installed of LED Flashes Description Options 1 Instant trigger - often used for hood/trunk pinswitches 2 Instant trigger - a heavier impact detected by the shock sensor 3 Door switch trigger 4 Instant trigger - for optional sensors 5 Igniti
ページ20に含まれる内容の要旨
n no otte e:: Your system stores the last two triggered zones in memo- ry. If your system has been triggered but the LED has been reset by turning on the ignition, your dealer can still recall the last two zones that were triggered. Contact your dealer for details. anti-code grabbing The receiver and remotes each use mathematical formulas called algo- rithms to change their codes each time the remote is used. This technol- ogy has been developed to increase the security of the unit. The control
