ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
BV7300 User’s Manual - page 1
ページ3に含まれる内容の要旨
spond to the Region number of this Mobile Safety information DVD Player, this Mobile DVD Player cannot play this disc. CAUTION: This mobile DVD player is a Class 1 laser DISC NOTES product. However, this mobile DVD player You can playback the following discs: uses a visible/invisible laser beam which DVD VIDEO/DVD AUDIO could cause hazardous radiation exposure VIDEO CD/AUDIO CD if directed. Be sure to operate the mobile MP3/WMA/JPEG/MPEG4 DVD player correctly as described in this manual
ページ4に含まれる内容の要旨
Preparing new discs with rough spots Installation A new disc may have rough edges on its inside and outside edges. If a disc with Notes: rough edges is used, the disc will not be - Choose a mounting location where the unit properly seated and the player will not will not distract the driver. play the disc. Therefore, remove the rough - Before the installation of the unit, connect edges in advance by using a ballpoint pen the wiring temporarily and make sure it is or pencil as shown on the
ページ5に含まれる内容の要旨
1. DIN front-mount (method A) Installation opening This unit can be installed in any dashboard opening with dimensions as shown below: 7. Reconnect the wire harness and the an- tenna, being careful not to pinch any wires or cables. Installing the unit 8. Slide the unit into the sleeve until it locks Be sure to test all connections fi rst, then into place. follow these steps to install the unit. 9. To further secure the unit, use the sup- 1. Make sure the ignition is turned off. Dis- plied met
ページ6に含まれる内容の要旨
then disconnect the cable from the vehicle Using the detachable front panel battery negative (-) terminal. 2. Remove the metal strap attached to the Removing the front panel back of the unit (if present). 3. Press the release button to remove the 1. Press the RELEASE button to fl ip front panel. down the front panel. 4. Lift the top of the outer trim ring then pull it out to remove it. 5. Insert both of the supplied keys into the slots at the middle left and right sides of the unit then pull
ページ7に含まれる内容の要旨
Wiring diagram WATCHING THE VIDEO MONITOR IS FORBIDDEN WHILE DRIVING: The “PARKING BRAKE” wire must be connected to the parking brake system of your car. The LCD screen will display video images ONLY when the parking brake is engaged. If the parking brake is not engaged, the screen will display the message “DISABLED WHILE DRIVING”. This is a safety feature designed to prevent the driver from watching a video while driving. The video output of this unit is not affected by this. Note: In Radio
ページ8に含まれる内容の要旨
Operation Features and controls Front panel Front panel button legend 12 RELEASE ( ) 1 POWER ( ), MODE 13 DISP (Display) 2 VOL+/- 14 (Fast Reverse), TUNE/TRACK Down 3 IR Sensor 15 MUTE (turns audio off) 4 1 16 (Fast Forward), TUNE/TRACK Up 5 2 INTRO (Intro Scan) 17 ST (Stereo/Mono select), 6 3 RPT (Repeat Mode select) LOC (Local/Distance select) 7 6 GO TO 18 MENU 8 5 STOP 19 AS
ページ9に含まれる内容の要旨
Back of front panel Remote control button legend 1 POWER ( ) 2 DISP (Display) 3 A > B (repeat section from A to B) 4 RPT (Repeat Mode select) 5 ZOOM 6 Cursor (arrow) keys: UP/DOWN/RIGHT/LEFT 7 ENTER 8 SETUP 9 (TUNE/TRACK Down, Last Track) 21 SD/MMC card slot 10 (TUNE/TRACK Up, Next Track) 22 Disc slot 11 TITLE (DVD Title Menu), 23 EJECT ( ) PBC (Playback Control Mode) 24 LED Warning light 12
ページ10に含まれる内容の要旨
To avoid damage, please follow these General operation precautions: - Do not subject it to excessive shock. Initial system start-up Be sure to press the RESET button (25) - Do not carry in a pocket. - Do not leave in direct sunlight. when using the unit for the fi rst time, after all connections are completed correctly. Battery replacement 1. Turn off the unit power. The remote control uses a lithium button 2. Press the RESET button. * The RESET button on the housing must type battery, mo
ページ11に含まれる内容の要旨
Adjusting the Volume Level Selecting Stations Press VOL+/- to adjust the volume level. - Press preset station button 1-6 to select a station which has been stored in the Last position memory memory. - During disc, USB or SD/MMC card play- - Press and hold the or buttons until back, press and hold the to turn off the “MANUAL” appears on the screen, then unit, when you next turn on the unit, the press or buttons to select a station. DVD unit will resume playing from the point If both but
ページ12に含まれる内容の要旨
A/V menu settings You can adjust various settings of the unit from the AV menu. The AV menu contains the menu items and submenus shown in the fi gure below: 1. Press MENU to activate AV menu. 2. Use the arrow buttons to select a menu item. 3. Press VOL+/- button to increase or decrease the parameter you have selected. 4. Repeat steps 2 and 3 to adjust other items if necessary. 5. Press ZOOM or MODE to return to previous menu. 6. Press MENU to fi nish the procedure. MAIN MENU AUDIO PICTURE SETUP AU
ページ13に含まれる内容の要旨
Audio menu AUDIO MENU VOLUME 00 FADER R.F BASS 00 EQ CLAS TREBLE 00 LOUD OFF BALANCE L.R SUB.W ON 1. Press the arrow buttons to select a menu item you wish to adjust. 2. Press VOL+/- button to adjust the item selected. Volume level: 0 to 63 Bass level: -7 to +7 Treble level: -7 to +7 Balance: 15L to 15R This setting adjusts the balance between the left and right speakers. Fader: 15R ~ 15F This setting adjusts the ba
ページ14に含まれる内容の要旨
Picture menu PICTURE MENU BRIGHT 00 TINT 00 CONTRAST 00 DISP.M 4:3 COLOR 00 DEFAULT OFF 1. Use the arrow buttons to select a menu item you wish to adjust. 2. Press VOL+/- button to adjust the item selected. Brightness: 0 to 63 Adjust this setting if the picture is too bright or too dark. Contrast: 0 to 63 Use this setting to adjust the contrast of the picture. Color: 0 to 63 Use this setting to adjust the color o
ページ15に含まれる内容の要旨
Setup menu SETUP MENU SYSTEM TIME ON TIME.M 12 AM 11 : 0 0 Hour Minute 1. Use the arrow buttons to select a menu item you wish to adjust. 2. Press VOL+/- button to adjust the item selected. 3. Repeat steps 1 and 2 to adjust other items if necessary. 4. Press ZOOM or MODE to return to previous menu. Time: ON/OFF Turns the clock display on/off. Time.M: 12 / 24 Use this setting to select 12 hour clock mode or 24 hour clock mode. Clock setting: Use this menu item to set or make changes to th
ページ16に含まれる内容の要旨
Disc operation For CD: Loading/Removing a disc 1. Press the button (7) to fl ip down the front panel. 2. Insert a disc with the label side facing up. The disc will be drawn into the player au- Selecting tracks in single steps tomatically. The information for the current -Press button or button to skip to the disc will be shown on the screen. previous or next track. * To eject the disc, press the button. -Press and hold button or button to fast reverse or fast forward. Return to nor
ページ17に含まれる内容の要旨
For CD/VCD/SVCD: Previewing all tracks (Intro scan) REP 1 REP ALL REP OFF Press the INTRO button to play the fi rst several seconds of each track on the cur- For MP3: rent disc. Press the button again to stop REP 1 REP DIR REP ALL REP intro scan and return to normal mode. OFF For DVD: REP CHAPTER REP TITLE REP Special disc operation OFF Disc menu operations NOTES: Menu-driven playback is possible while REP 1: Only one track (fi le) is played playing a disc with menu-driven features
ページ18に含まれる内容の要旨
AUDIO button to switch between the audio languages recorded on the disc. Notes: - Some time may be required for the angle to change. - Depending on the disc, the viewing angle may switch in one of two ways. 1. Seamless: The angle switches smoothly. Notes: 2. Non-seamless: When the angle is - The number of available languages var- switched, a still picture is displayed fi rst, ies from disc to disc. after which the angle switches. - Some discs only contain one soundtrack - The n
ページ19に含まれる内容の要旨
PBC indication (only for VCD with PBC) 1) Use the / / / cursor buttons to select Repeat playback indication the item that you want to program. The item : One track repeat playback you selected will be highlighted. : One directory repeat playback 2) Input the track number that you want to : The whole disc repeat playback program using the numeric buttons (0-9) on : Exit repeat playback mode the remote control. 3) Press the / / / cursor buttons to GOTO function move to “
ページ20に含まれる内容の要旨
Data disc playback USB playback When you insert a data disc including audio This disc player features a front panel USB (MP3), movie (MPEG4) or picture (JPEG) interface (10). A USB device can be con- fi les into the disc slot, the following main nected to this port. menu will appear: When you insert a USB device into the USB connector, the DVD player will read the USB automatically. The unit gives priority to a disc or SD/MMC card. If you insert a disc into the disc slot or insert a SD/MMC c
