ページ1に含まれる内容の要旨
Model 1090
➤Owner’s Guide
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
limited lifetime consumer warranty Directed Electronics ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), exclud- ing without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally i
ページ4に含まれる内容の要旨
REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER'S PURCHASE PRICE OF THE UNIT. DIRECTED SHALL NOT BE RESPONSIBLE FOR ANY DAMAG
ページ5に含まれる内容の要旨
table of contents limited‑lifetime‑consumer‑warranty �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� i what‑is‑included �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� 3 important‑information �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� ��
ページ6に含まれる内容の要旨
code‑hopping �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� 42 owner‑recognition‑ �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� 43 rapid‑resume‑logic �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� �� ��
ページ7に含まれる内容の要旨
what is included ➤ A control module ➤ A Responder receiver/antenna ➤ One 2‑way Color Remote Control ➤ A Stinger Doubleguard shock sensor ➤ A 514N Neosiren ➤ The plugin ‑ status LED ➤ The plugin ‑ Valet/Program switch ➤ A hood pinswitch ➤ A toggle (override) switch ➤ One Remote Control charger important information Congratulations on the purchase of your combination remote start alarm system. Due to the complexity of this system, it must be installed by an authorize
ページ8に含まれる内容の要旨
➜ your warranty Your warranty registration must be completely filled out and returned within 10 days of purchase. Your product warranty will not be validated if your warranty registration is not returned. Make sure you receive the warranty registration from your dealer. It is also necessary to keep your proof of purchase, which reflects that the product was installed by an authorized dealer. ➜ fcc/id notice This device complies with Part 15 of FCC rules. Operation is subject to the foll
ページ9に含まれる内容の要旨
safety ➜ important safety instructions 1. Follow all instructions. 2. Do not use this apparatus near water. 3. Clean only with a dry cloth. 4. Do not block any of the ventilation openings. Install in accor- dance with the manufacturer's instructions. 5. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 6. Protect the power cord from being walked on or pinched par- ticularly at plugs, convenience re
ページ10に含まれる内容の要旨
CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SEVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Thissymbolisintendedtoalerttheusertothepresence ofuninsulated"dangerousvoltage"withinthe pr oduct's enclosurethatmaybeofsufficientmagnitudetoconstitute arisk of electric shock to persons �� Thissymbolisintendedtoalertthe user tothepr esen
ページ11に含まれる内容の要旨
replacement remote controls You can purchase replacement remote controls from your Authorized Dealer or on-line at the following web site: www.directedstore.com Once you receive your new remote control, please refer to instructions included on the remote packaging. remote control introduction This 2way Remote Control system operates at 434MHz using binary data communication technology for sending and receiving of infor- mation. In this section you will find information about remote control fe
ページ12に含まれる内容の要旨
• 12 Hour Clock • Remote control battery level indicator • Power saver sleep mode • Beeps on/off • Page Mode on/off • Programmable alarm trigger animations & icons • 2way garage door module capable note: for detail on setting the clock and programming of other remote control features, refer to the remote control programming section in this manual. remote control diagram 18 17 16 1 15 2 14 3 13 4 12 5 11 6 10 7 9 8 © 2006 directed electronics—all rights reserved
ページ13に含まれる内容の要旨
1�� ARM & DISARM ICON 2�� SENSOR WARN TRIGGER & CAR CALL ICONS 3�� HOOD TRIGGER ICON 4�� TRUNK OR HOOD ICONS (PROGRAMMABLE) 5�� IGNITION TRIGGER ICON 6�� ARM/LOCK BUTTON 7�� AUXILIARY CHANNEL BUTTON 8�� TRANSMITTER PROGRAMMING BUTTON (ON REAR) 9�� REMOTE START BUTTON 10�� DISARM/UNLOCK BUTTON 11�� REMOTE START ON/OFF ICON 12�� REMOTE CONTOL BEEPS ON/OFF ICON 13�� SENSOR ZONE TRIGGER ICON 14�� FULL TRIGGER FOR ALL ZONES & CAR CALL ICON
ページ14に含まれる内容の要旨
remote control button functions The remote control buttons are initially programmed to Standard Configuration for this system. The instructions in this manual correspond to a Standard Configuration remote control. NOTE: If desired, the remote control button configuration can be customized by an authorized dealer. ➜ standard configuration Button This button controls the arm, lock and panic functions. Button ������� This button controls the disarm, unlock and panic off func- ������� tions. �
ページ15に含まれる内容の要旨
������� and Buttons These buttons control the turbo timer/short run remote start function. ������� and Buttons These buttons control the auxiliary channel 4 output. ������� ������� and Buttons These buttons control the auxiliary channel 5 output. ������� and ������� and Buttons These buttons control the rear window defogger function. and Buttons ������� These buttons control the auxiliary channel 6 output. ������� and Buttons These buttons will replay the last Notification anima
ページ16に含まれる内容の要旨
Note: If the remote control does not play the transmitting anima‑ tion, the remote control did not transmit the command�� • Command response: one second after the system receives and implements a command; it will transmit a command response to the activating remote control�� The remote control will play the appropriate Notification output�� Note: If more than one remote control is programmed to the system, a command update will
ページ17に含まれる内容の要旨
• Alarm Page Alert: an alarm page alert is a single beep that repeats every sixty seconds after an alarm warn or full trigger page has been received�� It will continue to beep until it has been cleared by the user�� • Alarm Page: to clear an Alarm Page Alert, press any button on the remote control�� Until the alert is cleared, the buttons on the remote control will not transmit commands�� a�� During Alarm Page Notification:
ページ18に含まれる内容の要旨
To replay, simultaneously press and release the “ ” & “ ” buttons�� The screen will replay the animation once without beeps�� remote control maintenance ������� This remote control needs no specific maintenance beyond charging of the remote control battery. It is powered by a 4.3V/600mA Lithium Ion battery that will last approximately 1 week on a full charge under normal use. Excessive viewing of on-screen anima- tions will quickly diminish the battery charge. The Battery L
ページ19に含まれる内容の要旨
using your system ➜ warning! safety first The following safety warnings must be observed at all times: ➤ Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. ➤ When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or pa
ページ20に含まれる内容の要旨
injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Directed dealer in accordance with the Safety Check outlined in the product installation guide. If the vehicle starts in gear, cease
