ページ1に含まれる内容の要旨
PLCDCS300
OWNER’S MANUAL
Mobile Audio System
• PLL Synthesizer Stereo Radio
• Digital Compact Disc Player
• Cassette Player
• Automatically Memory Storing
• Preset Equalization
• Auxiliary Input Function
• Remote Control
• Slide Down Undetachable Panel
ページ2に含まれる内容の要旨
CONTENTS Installation .....................................................................................................3 Wiring Connection ........................................................................................4 Operation.......................................................................................................5 General Operation ..................................................................................................6 Radio Operation....................
ページ3に含まれる内容の要旨
INSTALLATION Installation onto the car bracket using supplied screws (M5 x 6mm). The holes of the car bracket to use will differ depending on the car model. Screw (M5 x 6mm) 3
ページ4に含まれる内容の要旨
WIRING CONNECTION For 4 x 50W MAIN UNIT ANTENNA SOCKET (BLACK) Rch RED TV AUDIO IN FUSE IGNITION RED Lch WHITE SWITCH (B+) YELLOW MEMORY BACK-UP (GREY) Rch RED RCA CABLE BLACK GROUND (B–) Lch WHITE BLUE POWER ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER SPEAKER WHITE/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK 4
ページ5に含まれる内容の要旨
OPERATION 21 20 19 4 1 18 9 7 15 25 26 2 3 22 23 24 11 6 16 30 14 12 13 17 8 10 29 5 28 27 5
ページ6に含まれる内容の要旨
OPERATION • MUTE GENERAL OPERATION Press the MUTE button (2) to silence the receiver. Press it again to release Note: In this product design, there has the mode. different sound accompanying with every button pressed and the sound is • LIQUID CRYSTAL DISPLAY designed differently according to the Exhibit current frequency and activated customers. functions on the display (7). • ON/OFF • EQUALIZATION Switch on the unit by pressing POWER Press EQUALIZER button (12) to button (9). When system
ページ7に含まれる内容の要旨
OPERATION Stations are searched automatically RADIO OPERATION from next frequency and detected station is stored into the preset • BAND SELECTION memory. In case of LOC state, the At radio mode, press BAND button first Auto Store is done by LOC state (13) to select the desired band. and if 6 CH is not fully memorized, The reception band will change in the the seconds Auto Store search following order: continued by Distant state. At the FM1 FM2 FM3 AM1 AM2 end of Auto Store operation, m
ページ8に含まれる内容の要旨
OPERATION CASSETTE OPERATION • TAPE OPEN/CLOSE Press TAPE OPEN/CLOSE button (26), the front panel will slide down to show the cassette compartment (28). Press TAPE OPEN/CLOSE button (26) again or POWER button (9) to slide up the front panel. • PROGRAM BUTTON These two buttons (27) perform the dual functions of changing the direction of tape playback and fast forward/rewind of the tape. - Change Tape Playback Direction Press both buttons together to play the other side of a tape. - Fast Forw
ページ9に含まれる内容の要旨
OPERATION • REPEAT THE SAME TRACK CDP OPERATION Press RPT button (21) to continuously repeat the same track. Press it again • CD OPEN/CLOSE/EJECT to stop repeat. Press CD OPEN/CLOSE/EJECT button (4) shortly, the front panel will • PREVIEW ALL TRACKS slide down halfway to show the disc Press SCN button (20) to play first slot (5). several seconds of each track on the Press CD OPEN/CLOSE/EJECT current disc. button (4) again or POWER button (9) Press it again to stop intro and listen to s
ページ10に含まれる内容の要旨
OPERATION REMOTE CONTROL HANDSET 1 7 4 3 8 9 6 5 13 2 12 10 11 14 15 FUNCTION KEYS & CONTROL 1. PWR = Power Button 2. MUT = Mute Button 3. SEL = Select Button 4. VOL = Volume Up Button 5. VOL = Volume Down Button 6. BND = Band Select Button 7. MOD = Mode Button 8. TUNE/SEEK = Tune/Seek Down Button 9. TUNE/SEEK = Tune/Seek Up Button 10.EQ = Preset Equalization Button 11.PRESET = Preset Buttons 12.PAU = Pause Button 13.SCN = Scanning Button 14.RPT = Repeat Button 15.RND = Random Button 10
ページ11に含まれる内容の要旨
SPECIFICATIONS GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 200 mm (W) x 138 mm (D) x 100 mm (H) Loading Impedance : 4 - 8 Ω per channel Maximum Output Power : 4 x 50 Watts Current Drain : 10 Ampere (max.) CD PLAYER Signal to Noise Ratio : More than 55 dB Channel Separation : More than 50 dB Frequency Response : 20 Hz - 20 KHz CASSETTE PLAYER Tape Speed : 4.76 cm/sec Fast Forward Time : 180 seconds (C-60 type) Frequency Response : 50 to 8,000 Hz Channel S
ページ12に含まれる内容の要旨
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Disc cannot Presence of CD disc inside Remove the disc in the player, then be
ページ13に含まれる内容の要旨
MAINTENANCE 3. Clean the tape head with the cotton For System swab. The following suggestions help you care for the product so that you can enjoy it for years. 1. Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. 4. Clean the capstans and the pinch 2. Keep the product away from dust and rollers with the cotton swab. dirt, which can cause premature wear 5. Allow the tape head, capstans and of parts. pi
ページ14に含まれる内容の要旨
CAUTION 1. This unit is designed to operate on 3. Your unit has built-in filtering to 12-volts DC, negative ground eliminate most of the noise that might electrical system only. Do not attempt come through the power source. to install this unit in a vehicle having a However, with some vehicles, positive ground system. particularly older models, some clicking or other unwanted noise 2. You should not touch the might be present. high-polished playback head with any metallic or magnetic tools
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
www.pyleaudio.com 88-C1380-01
