ページ1に含まれる内容の要旨
REFRIGERADOR
REFRIGERATOR
FRIGORIFICO
ZFC 282 C
LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET MANUAL DE INSTRUÇÕES
2222 151-51
ページ2に含まれる内容の要旨
D223 D224 CONTENTS Warnings............................... Page 11 Installation .............................. Page 12 Location ............................... Page 12 Rear spacers.............................. Page 12 Power connection............................ Page 12 Cleaning the appliance’s interior....................... Page 12 Changing the opening direction of the door ................... Page 13 Changing the opening direction of the compartment door............ Page 1
ページ3に含まれる内容の要旨
WARNINGS It is most important that this instruction book should ª The inner lining of the appliance consists of be retained with the appliance for future reference. channels through which the refrigerant passes. If Should the appliance be sold or transferred to another these should be punctured this would damage the owner, or should you move house and leave the appliance beyond repair and cause food loss. appliance, always ensure that the book is supplied DO NOT USE SHARP INSTRUMENTS to with
ページ4に含まれる内容の要旨
INSTALLATION If this refrigerator featuring magnetic door seals is to Fig. 2 replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct PR153 sunlight etc. Best performance is obtained with ambient Power connection temperature between
ページ5に含まれる内容の要旨
Fig. 3 Changing the opening direction of the door Unplug the appliance before performing the following operations: H Remove the ventilation grille (D-Fig. 4). Unscrew the bottom hinge (E-Fig. 4). I Remove the screws of the bracket with foot (I) and levelling foot (H) and reassemble them on the opposite side (Fig. 3). Remove the door from the upper pivot (A-Fig. 5). Remove the pivot and the washer (A+B-Fig. 5) D691 from the upper hinge (C), then mount these on the Fig. 4 opposite side. Re-as
ページ6に含まれる内容の要旨
USE Operation - Temperature adjustment Fresh food refrigeration Turn the thermostat knob clockwise beyond The refrigerator compartment is suitable for position «O» to the required setting. cooling drinks and for normal food storage. A medium setting is generally the most suitable. To obtain the best performance, do not store warm Temperature is adjusted automatically and may be food or evaporating liquids in the refrigerator, do increased (less cold) by turning the knob towards cover or wrap
ページ7に含まれる内容の要旨
Positioning the door shelves (Fig. 10-11) Frozen food storage To permit storage of food packages of various sizes, The compartment marked by the symbol is the door shelves can be adjusted in height. suitable for storing frozen food and, to obtain the To make these adjustments proceed as follows: best results, make sure the thermostat knob is set near the coldest setting (if ambient temperature is Gradually pull the shelf in the direction of the low-i.e., less than 20 C - it is necessary t
ページ8に含まれる内容の要旨
D137 Remove the plug from the drain hole in the water Defrosting collecting tray. Place a basin under the drain hole in While in operation, the refrigerated surfaces of the the tray to collect the defrost water (Fig. 13). evaporator become progressively covered with When defrosting is completed, operation is resumed frost. automatically. This frost, which acts as a thermal insulator and thus prevents the cold from reaching the food, Remove the defrost water which has collected in should
ページ9に含まれる内容の要旨
MAINTENANCE Before carrying out any maintenance operation, Interior light bulb always disconnect the plug from the wall socket. The light inside the refrigerator compartment is easy to get at. All you have to do is to remove the Periodical cleaning lamp from the fitting itself. If the light does not come on when the door is Wash the interior of the appliance with lukewarm opened, check that it is screwed into place properly. water and sodium bicarbonate. If it still does not light up, change
