ページ1に含まれる内容の要旨
INSTALLER’S & OWNER’S MANUAL
HVAC INSTALLER: PLEASE LEAVE MANUAL FOR HOMEOWNER
DEH 3000R
DEH 3000R
Part No. 4028407
Dehumidifier & Ventilation System Controller
P.O. Box 8680 Madison, WI 53708 • TOLL-FREE 1-800-533-7533 • www.thermastor.com • sales@thermastor.com
© 2008 Therma-Stor LLC • Manual P/N TS-506b
ページ2に含まれる内容の要旨
Table of Contents 2.1 Install Instructions 1. Contents & Specifications ............................................... 2 1. S eparate the front panel from the back panel by depressing 2. Installation ...................................................................... 2 the middle sections of the top and bottom of the front 2.1 Install Instructions ...................................................... 2 panel. 2.2 Wiring......................................................................
ページ3に含まれる内容の要旨
The White wire controls the optional motorized damper 2.2 Wiring that can be installed into a fresh air duct. This damper provides the ability to control fresh air ventilation using WARNING! DO NOT ALLOW THE YELLOW the ventilation timer function of the DEH 3000R and WIRE FROM THE ULTRA-AIRE DEHUMIDIFIER TO CONTACT the terminal labeled “DMP” on the DEH 3000R (See THE RED OR WHITE WIRES FROM THE ULTRA-AIRE Section 3.8). Leave the “DMP” terminal unused if a DEHUMIDIFIER, DAMAGE TO THE 24-
ページ4に含まれる内容の要旨
Red A/C Unit Green Yellow 2. Run the Yellow wire from the A/C unit to the COM terminal wiring from the A/C transformer is used to set up the Lock-in on the DEH 3000R. dehumidifier function. 1. The common wire from the existing A/C transformer (usually Black) must be attached to the Yellow wire from the Ultra-Aire dehumidifier. Red A/C TIP: The common wire can be identified as the wire Unit from the A/C transformer that reads 0 volts between it Green and the Yellow air conditioning call fo
ページ5に含まれる内容の要旨
d. R elease the “VENT” button, then press it again to switch 2.5 Testing vent mode to “OPEN”. Verify the wiring connections. e. Confirm that the Ultra-Aire fan is ON. Ventilation damper is WARNING! ONLY CONNECT THE WHITE WIRE OPEN. Ultra-Aire compressor must be OFF. TO THE CONTROL IF IT IS WIRED IN A CIRCUIT THROUGH AN f. P ress and hold the “VENT” button until the “OPEN” ELECTRIC DAMPER, OTHERWISE TRANSFORMER DAMAGE flashes on the display. MAY RESULT. g. R elease the “VENT” button, then
ページ6に含まれる内容の要旨
seconds, the control will remember any changes made and FOR INSTALLER & HOMEOWNER: return to the normal display screen, allowing you to proceed to 3. Operation the next step. On the display screen, a solid “O” in front of any of the 3 3.3 Personal Settings reference list functions (SETPOINT, VENT, FAN) indicates the function is Please record your settings here. operating. A flashing “O” indicates it is in a wait mode and Function Factory setting My Setting not available at the moment. No
ページ7に含まれる内容の要旨
5. Press the “CLOCK” button again and the day display will 3.7 Fan Setting and Operation flash. Use the “RH” buttons to change the value. Use the “FAN” button to change the fan operation. There are 2 choices for fan operation: “ON” or “AUTO”. The factory preset 6. D on’t touch any buttons for several seconds until the display is “AUTO”. stops flashing, this will save your settings. If you need to change anything go back to step #1. “ON” –The fan in the Ultra-Aire dehumidifier will run con
ページ8に含まれる内容の要旨
3.8 Damper Operation and Ventilation, Manual (Hold) Mode The “VENT” setting controls the ventilation function of the system. It has no control over the dehumidification function. In order to provide ventilation, the motorized damper must be open and the fan must be running. The controller takes care of these two functions automatically so that whenever the damper is open, the fan is running. The ventilation indicator “O” will be displayed whenever the unit is ventilating. The fan operati
ページ9に含まれる内容の要旨
7-day version or the weekday/weekend split version), use the down “RH” button to highlight the EXIT option and then press “PROGRAM ENTER” to select it. Running the Ventilation Program Press and hold the “PROGRAM ENTER” button until the “PROGRAM” screen appears. Use the down “RH” button to highlight “RUN PROGRAM”: You can select from: “MON-FRI” “SAT-SUN” for separate weekday and weekend schedules, or “MON-SUN” which gives you equal weekday and weekend schedules. 3. Using the Up/Down “RH” but
ページ10に含まれる内容の要旨
5.0 DEH3000R — Remote sensor option. This section is applicable only to customers who have purchased a remote sensor package. The standard DEH 3000 controller does not offer remote functionality. limit sensor distance. Thicker gauges will not work with 5.1 Remote Sensor Usage splice connectors provided. IMPORTANT! • Avoid routing parallel to high voltage wiring. • The use of spray paint on the sensor housing may damage • Maintain a distance of 2 ft. or more from high voltage lines. the se
ページ11に含まれる内容の要旨
DEH 3000R Dehumidifier & Ventilation System Controller DEH 3000R Limited Warranty. Therma-Stor, LLC (“Therma-Stor”) warrants Customer Responsibilities. As a further condition to obtaining as follows: (i) the DEH 3000R (“Product”) will be free of material warranty coverage hereunder, the Customer must send a valid defects in workmanship or materials for a period of three (1) year warranty claim to Therma-Stor such that Therma-Stor receives (“One-Year Warranty”) following the date of initial pu
ページ12に含まれる内容の要旨
Information in this document is subject to change without notice. No part of PO Box 8680 • Madison, WI 53708 this document may be reproduced or transmitted in any form or by any means, Phone: 608-222-5301 • Fax: 608-222-1447 electronic or mechanical, for any purpose, without the express written permission of Therma-Stor LLC. © 2007 Therma-Stor LLC. All rights reserved. www.thermastor.com • sales@thermastor.com DEH 3000R Dehumidifier & Ventilation System Controller Installation, Operation &
