ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
CDC603A Aug.06-03 INTRODUCTION English This CD changer is designed for use only with car radios which have CD changer controls based on either the DIGITAL (SPDIF) or ANALOG standard. Consult your dealer for suitable types of car radio. The functions of the CD changer are described in the operating instructions for the car radio. General Precautions ...............................................................................................................................................
ページ5に含まれる内容の要旨
CDC603A Aug.06-03 GB INSTALLATION PREPARATION FIXING MATERIAL SUPPLIED Fig. 2 Only use screws and fixing material supplied! A 2 L-shape brackets B 2 base-plate C 4 washer screw D 4 nut E 4 tapping screw F 2 dust protection sticker G 4 adhesive label H 4 bolt REMOVING TRANSPORT SCREWS Fig. 1 1 Remove the three transport screws from the underside of the CD changer. 2 Clean around the three holes on the CD changer. 3 Glue the supplied round stickers G over the holes to prevent dust entering
ページ6に含まれる内容の要旨
CDC603A Aug.06-03 SHOCK ABSORBER ADJUSTMENT Be sure to adjust Mounting Angle Setting Lever to appropriate angle(Fig.4,5,6); 0° for horizontal, 22.5° angle, 45° angle, 67.5° angle, 80° angle,or 90° angle for vertical. After setting the position of the shock absorbers, glue the supplied sticker F over the holes of the setting mechanisms. Change the position of the setting mechanisms at both sides of the CD changer. 4
ページ7に含まれる内容の要旨
CDC603A Aug.06-03 GB MOUNTING Caution: Take care not to drill into the fuel tank, the exhaust pipe system, the catalytic converter or the cables laying behind or below any drilled holes! MOUNTING IN THE LUGGAGE BOOT 1 Fix bracket A on the side of the CD changer using the washer screw C(Figs. 7a-c). 2 Fix the base plate with the long bolts H to the bracket using the nut D(Fig.8). 3 If present, lift the carpet covering the floor of the luggage boot(Fig.9). 4 Fix the base plate X2 to the chass
ページ8に含まれる内容の要旨
CDC603A Aug.06-03 MOUNTING CONNECTING THE CABLES (Fig.15) Only use the cables supplied to connect the CD changer to the car radio! 1 Ensure that the negative car battery terminal is disconnected. 2 Connect the car radio as described in the car radio's mounting instructions. 3 Connect the blue plug C3 of the extension cable to the rear of the car radio (socket C3') (fig.15). If your car radio does not already have a socket for the suitable connector, consultyour dealer for an adapter cabl
ページ9に含まれる内容の要旨
CDC603A Aug.06-03 GB OPERATION FILLING THE CARTRIDGE 1 Pull the tab on the cartridge's disc tray to remove one of the trays. 2 Place the disc on the tray with the label side up Each tray can accommodate only one disc. The CD changer will not function if the discs are placed upside down. 3 Press the tab on the disc tray to store the tray back in the cartridge. INSERTING THE CARTRIDGE 1 Open the sliding door. 1 2 Hold the cartridge the correct way up with the narrow side facing the o
ページ10に含まれる内容の要旨
MANU AL EJECT CDC603A Aug.06-03 OPERATION HANDLING DISCS Do not drop discs. Keep discs free from dirt and fingerprints. Scratched discs may cause skipping of music parts. Do not glue paper or labels on discs. Do not write on discs. Do not play damaged or deformed discs. Never expose discs to heat or direct sunshine. Wipe a dirty disc surface clean with a soft cloth; move from the centre to the edge. Never use publicity CDs! EMERGENCY EJECT OF THE CARTRIDGE ATTENTION: Under no ci
ページ11に含まれる内容の要旨
CDC603A Aug.06-03 GB TROUBLESHOOTING An error made in operation or in the connections is sometimes mistaken for a failure or breakdown. Perform the checks described in the following table before calling a Service Agency. Symptom Cause Remedy CD-Changer does not react. Improper connection. Check connections. Blown fuse in the car . Replace with a fuse of the correct type and amperage (consult car radio instructions). If fuse blows again, consult a Service Agency. Cartridge cannot
ページ12に含まれる内容の要旨
CDC603A Aug.06-03 SPECIFICATIONS CHM 604 MP3 Compatible CD types: 12cm CD, CD-R and CD-RW Compressed digital audio: MPEG 1/2 layer 3 (MP3), ID3 Tag v1.0 and 2.0 Microsoft Window Media Audio up to v8.0 (WMA), WMA text * Protected WMA files are not be supported. DAC: 1 bit DAC per channel Oversampling: 4 times Channels: 2-channel stereo or SPDIF (select via a switch) Frequency Response: 20 – 20,000 Hz ± 3 dB Wow and Flutter: Below measurable limits Total Harmonic D
