ページ1に含まれる内容の要旨
C
©
©
0
©
©
03
0
0
©
ページ2に含まれる内容の要旨
1 1 1 21 accessories this Page case case Presser 7 8 8 3 15 3 9 19 5 4 9 5 6 page 7, 13 18 2, 10 Utility 16 17 I 12 14 18 17 lifter 4 14 22 Model Light Oiling 22 23 20 of 25 Fold Bobbin Bobbin 20, 1014 1015 Model 1019 Model 1035 22 26-29 is 24, Utility/stretch Winding Work Bobbin Buttonholing Carrying Carrying Electrical Finger-tip stitch Models Finger-tip stitch Finger-tip stitch Finger-tip stitch 1037 Foot control bulb Machine feed position bar sewing Sewing Sewing sewing Spool Stitch length S
ページ3に含まれる内容の要旨
— CA) 4 9, p4_ 0 N 4 0 (I) 0 a 2 -‘S 0 0 0 CD CD
ページ4に含まれる内容の要旨
L N in in 4 1. will oil in in in 121 is is J I by 101 2. pull tip foot, for with while. 3. with only light 111 lifter with with with Live of with of with follows: is is with or wire is with or to of Carrying Be careful when sewing 100 your Bobbin winder fingers not be injured 102 Hand wheel Stop motion knob Make you out power 103 104 Master switch cord plug you want to 105 Finger stitch sewing 106 Stitch length control bobbin or plate, when you 107 Machine and machine, or when have interrupt 108
ページ5に含まれる内容の要旨
lift ill.) lid and opening cover case cabinet the detachable the support (N), off. case off (P). (Q). is fold with left its N To work by left to on to arrow. swing box put i (not Model For two ) the carrying cover, the rear, an your out Then out Then feet, 1014 this work (1015-1037) handle the indicated hand it toward the cover (0), and The away sewing other N Model 1014 on can be placed a sewing this machine holes at back. Removing Reach under the support the open used thread and cabinet. reaso
ページ6に含まれる内容の要旨
4 oQJ Jewuiej ep:n6 0 e6p 100,t ejoquon 8 d 4oo, 0 bunne 4004 M8iA-JBefQ OOJ o qo1{Jspuig 4004 6U1M89 piepuei N OOJ JOddiz 8 lea! Gu!&as
ページ7に含まれる内容の要旨
in in control Press depressed, Electronic R full connection (N). full 3 of is is is is of = 0 P of of 1 into into wall for 104. foot to to half. = foot foot plug plug Your now you put on foot half control out control down the The switch away, control control illustration top piercing power always sewing Position top top Take machine. under the table. and pedal, and the the outlet. more the pedal sewing. ready the machine runs. sewing. When placed machine again Slide electronic shown the the the
ページ8に含まれる内容の要旨
in of of of of of Q of of Pull of (to left P P is for is for left of with for or pin 0 foot. from pin of from into 113. into into on 0 on right. reel Load to right. For both “up” into below P front slot Swing For into to pin of spool onto spool facing small Small spool onto spool. disc front lever position. Large disc. spool spool draw slot spool slot and lever spool holder: It included draw right holder. bobbin winding sewing. draw slot spool holder machine at diagonal cut end Then push a holde
ページ9に含まれる内容の要旨
into left Hold After by to the One pulled right Before you winding bobbin, into sewing guide wheel and turn on holder. motion knob toward you. bobbin winding, knob turning away from you. from front to back. guide. the Disengaging the sewing mechanism other the start threads then the thread the gage the mechanism. guide, the other the thread the hand steady the the needle stop tighten the again Threading the needle Thread the needle disen I righE of of is it 5
ページ10に含まれる内容の要旨
it. it 5). full. N. full pull of to Fit of foot 101 pin is Pull left 114. 6 Then toward sewing (page wind a few on the spool the bobbin. the bobbin toward right, a down control pedal wind and a spool on bobbin. The bobbin winder bobbin on spindle from spool and matically when bobbin slot and take through P and around bobbin toward out. draw Cut the thread the bobbin win Winding mechanism der and turns thread the Disengage second holder machine Push the a Place press the and place thread so that
ページ11に含まれる内容の要旨
N lift N, 7 108 filled 122. Pull (N). fall P. Remove cover or arm Insert bobbin into bobbin cover out latch out so toward the bobbin latch and out Then into slot and bobbin. The bobbin out into long you latch pulled out. Removing bobbin and bobbin Inserting the bobbin open free the the then the that the thread unreels back case, release the take draw the thread the cannot as under the spring eye as keep case case 0
ページ12に含まれる内容の要旨
it N will Pull P Hold little you until P is Pull of lay 108 122. left 8 up latch bobbin Turn onto far go. Cutout wheel 102 toward must point latch. down and up again and Stud and latch be flush. lever up. bobbin out cover or arm cover hole and both toward back sewing foot. Inserting the bobbin Drawing up the bobbin thread and push the case the needle thread taut. a stud as as hand the needle Release the moves upwards. the take-up must the thread Replace close free the needle threads the and unde
ページ13に含まれる内容の要旨
you work foot. to into to Lower four foot (Before work, Draw you foot for foot sligthly it it slot. foot Lever an bar. N at out lever.) Darning at bottom positions: oblique slot The sewing remove turn hand wheel sewing toward toward back. slot them o The sewing further them. inserting extra-thick materials. darning position and time at notch The sewing lowered sewing. lifter has The located raised. the back the the the raise the needle and the the take-up cutter and raised downwards cut the bar
ページ14に含まれる内容の要旨
it N It 4 full in = Let with is by 3 5. by its lightly. O left for or for P = Q = R I. — Q-’ -‘I 10 112 mark. The normal bobbin bobbin a setting white down freely not slide and The number, down own weight, but should tighter move when you jerk your lower = Regulating correctly, only Turn a should be right a = Both Upper too loose or lower too tight. Lower too loose or too tight. 4 j Upper tension The lower Setting tension the case hang the range between the thread. must higher the the the tensio
ページ15に含まれる内容の要旨
. he , dicate jes 0 length Reverse sewing jegulating the stitch Press depressed, todets indicat chosen set numbers on stitch length control button as keep this stitch length millimeters the button the machine sews 1014 and the stitch length backwards. to Models to to control the so that the number the stitch lenght opposite shows to the stitch length sewing stretch stitches (red stitch push ibols buttons). 106 119. As tong you On 1015 from 0 4 mm, on 1019 from 0 mm. how trol for on in 6 is N. k
ページ16に含まれる内容の要旨
F - controls A, B, E G B 12 2 C; 17). is for left A for mm 2-mm mm mm for triple triple 3.5 3.5-mm triple 5-mm triple 1014 Buttons buttonholing Button button and ppsition Elastic stitch, Elastic stitch, stitch Elastic stitch, 5.0 Elastic stitch stitch on Models 1015 also clearing releasing the buttons setting needle zigzag zigzag stitch zigzag zigzag zigzag zigzag stitch Straight Finger-tip used as the (see page straight and pushed B D
ページ17に含まれる内容の要旨
controls on Model Finger-tip 1019 A, B, Buttons for buttonholing C; Button also used as clearing button for B is releasing the pushed buttons and for setting the left needle position (see page 17). triple zigzag stitch, 2 D Elastic mm 2-mm zigzag stich E Elastic triple zigzag stitch, 3.5 mm 3.5-mm zigzag stitch F Elastic triple zigzag stitch, 5 mm 5-mm zigzag stitch Elastic triple straight G stitch Straight stitch Honeycomb stitch M Elastic stitch 13
ページ18に含まれる内容の要旨
G A, B, is E 5 D F 14 B K M controls as pushed (see page Elastic straight stitch Finger-tip on buttonholing Straight stitch also used clearing Closed stitch the Joining stitch releasing buttons and setting the needle Overlock zigzag stitch, Shell-edge zigzag Honeycomb zigzag stitch, Elastic stitch zigzag zigzag stitch, zigzag Model 1035 triple Buttons Button button overlock position stitch triple Elastic stitch stitch stitch Elastic 3.5 3.5-mm stitch Elastic triple 5-mm stitch for for mm 2-mm tr
ページ19に含まれる内容の要旨
A, E M H K 111 L ___ controls ___ ___ Finger-tip pushed needle page Feather n cD II on 1037 stitch Buttons also used as clearing button Closed stitch releasing the buttons and setting Joining (see zigzag Shell-edge stitch zigzag zigzag Elastic decorative stitch zigzag Honeycomb zigzag zigzag Elastic straight Straight stitch 4 ___ Model Pullover 8, buttonholing Blindstitch Button overlock stitch the position Overlock stitch triple o Elastic stitch, 2-mm stitch stitch Elastic triple stitch, 3.5 3.
ページ20に含まれる内容の要旨
(red far go listed This symbols) symbols) button turn stitch button turn the stitch the the control length control indicating (red symbol). and stitch length when button halved stitch and Push and length it and and are zigzag, are and combinations stitch program also possible applications. utihty Push the desired the desired number as the desired between stretch stitches stitches chart pages the chart contains Selecting as pressed Selecting stretch All All stitches stitches 1 will in in 16 4 6.
