ページ1に含まれる内容の要旨
INSTALLER / CONSUMER
SAFETY INFORMATION
Please read this manual
before installing and using
Unvented
the heater.
Gas-Fired Room Heater
WARNING: If the information in
this manual is not followed
Blue Flame Heaters
exactly, a fire or explosion may
Models: RMC-LC10NG, RMC-LC10LP - 10,000 Btu/hr.
result causing property damage,
RMC-LC20NG(F), RMC-LC20LP(F) - 20,000 Btu/hr
personal injury or loss of life.
RMC-LC30NG(F), RMC-LC30LP(F) - 30,000 Btu/hr
RMC-LC10NG(T), RMC-LC10LP(T) - 10,000 Btu/hr.
R
ページ2に含まれる内容の要旨
General Information bathroom and an unvented room heater having an input Table of Contents rating of more than 6,000 BTU per hour shall not be installed in a bathroom. Installer / Consumer Safety Information . . . . 1 • Do not install RMC-LC30, LI30, LC20 or LI18 heaters in a General information . . . . . . . . . . . . . . . . . . . 2 bedroom or a bathroom. Specifications . . . . . . . . . . . . . . . . . . . . . . . . 3 • Do not install RMC-LC10 or LI10 heaters in a bathroom, they Installation
ページ3に含まれる内容の要旨
RMC-LCNG, RMC-LCLP, RMC-LING, RMC-LILP Specifications Input Rating Regulator Inlet Gas Supply Models (Btu/Hr) Variable Pressure Size Pressure (Manual & Gas Type Weight of Heater Setting Thermostat) Min. Max Min. Max 1/2 RMC-LC30NG 15,000 30,000 27”x24”x8 ” 30 lbs. 3/8 7/8 1/2 RMC-LC20NG Natural 10,000 20,000 4.0” w.c. 5.0” w.c. 11” w.c. 19 ”x22 ”x8 ” 22 lbs. RMC-LC10NG 5,000 10,000 1/2 7/8 7/8 17 lbs. 15 ”x20 ”x7 ” RMC-LC30LP 15,000 30,000 1/2 30 lbs. 27”x24”x8 ” RMC-LC20LP LP 10,000 20,000 10
ページ4に含まれる内容の要旨
Installation PROVIDE ADEQUATE COMBUSTION WARNING: If the area in which the heater may be operated is smaller that that defined as an unconfined space or if the AND VENTILATION AIR building is of unusually tight construction, provide adequate • This heater shall not be installed in a confined space or combustion and ventilation air by one of the methods unusually tight construction unless provisions are provided described in the National fuel Gas code, ANSI Z223.1 / NFPA for adequate combustion a
ページ5に含まれる内容の要旨
LOCATING THE HEATER • Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies. Keep flam- mable objects more than 36” from the front and top of the heaters and more than 10” from the sides of the heater. • Provide adequate clearances for accessibility for purposes of servicing the heater. • Maintain adequate clearances around the air openings to allow for proper and safe operation of the heater. • WARNING: Do not allow fans to blow directly
ページ6に含まれる内容の要旨
WALL ANCHOR METHOD FLOOR INSTALLATION When mounting heater to hollow walls (wall areas between 1. Heater may only be installed on a noncombustible flat studs) or solid walls (concrete or masonry) it may be neces- surface. Where the flooring is carpeting, tile or of other sary to use wall anchors. combustible material other than wood flooring, maintain the minimum clearances to the floor as shown in figure 2 or 1. Place paper template on wall maintaining minimum clear- else use a metal or woo
ページ7に含まれる内容の要旨
CONNECT TO GAS SUPPLY PRESSURE TEST GAS SUPPLY PIPING SYSTEM Installation should be done by a qualified service person. Before connecting the appliance, turn off all gas appliances. The appliance and its individual shut off (control) valve must Close the main gas valve at the gas meter or LP tank. Make be disconnected from the gas supply piping system during any certain there is good ventilation where the installation will be pressure testing of the system at test pressure in excess of made. I
ページ8に含まれる内容の要旨
Operation Instructions FOR YOUR SAFETY - READ THIS LIGHTING INSTRUCTIONS SECTION BEFORE LIGHTING MANUAL GAS CONTROL 1. Stop! Read and Heed the Warnings and Cautions on the side WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS of the heater. EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING 2. Check that gas supply to the heater is on. PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE 3. Push in gas control knob slightly and turn clockwise A. BEFORE LIGHTING smell all around the appliance area for t
ページ9に含まれる内容の要旨
TO TURN OFF GAS TO APPLIANCE MANUAL GAS CONTROL Turning Heater Off Push in gas control knob slightly and turn clockwise to "OFF" position. Do not force. Turning Burner Only Off (Pilot stays lit). Turn control knob clockwise to the PILOT position. CAUTION: Do not try to adjust heating levels by using the manual shut-off valve. NOTE: The thermostat sensing bulb measures the temperature of air near the heater cabinet. This may not always agree with room temperature (depending on housing constructi
ページ10に含まれる内容の要旨
Troubleshooting Problem Possible Cause What To Do When control knob is pressed in 1. Ignitor electrode positioned wrong. 1. Reposition ignitor electrode. and turned counterclockwise to 2. Ignitor electrode broken. 2. Replace electrode. ignition, there is no spark at 3. Ignitor cable pinched or broken. 3. Free ignitor cable, if damaged, replace. ODS pilot. 4. Ignitor cable not connected to ignitor 4. Connect cable to electrode electrode. When control knob is pressed in 1. Gas supply turned off.
ページ11に含まれる内容の要旨
Troubleshooting continued Problem Possible Cause What To Do Heater produces a clicking 1. Metal expanding and contracting. 1. This is common with heaters. If noise is noise just after burner is lit or excessive, contact a qualified service turned off. technician. Gas odor even when control 1. Gas leaks. Refer to front of page Warnings. 1. Locate and correct leaks immediately. knob is in OFF position. 2. Gas control defective. 2. Replace gas control. Gas odor during combustion. 1. Foreign mat
ページ12に含まれる内容の要旨
RMC-LI NG/LP Unvented Room Heater Item/Model Number RMC-LI06NG/LP RMC-LI10NG(T)/LP(T) RMC-LI18NG(T)/LP(T) RMC-LI30NG(T)/LP(T) 1. Lower Heat Cover LI10LP-01-01-02 LI10LP-01-01-02 LI18LPT-01-01-03 LI30NG-01-01-02 2. Guard Assembly LC10NG-01-04 LC10NG-01-04 LI18LPT-01-04 LC30NGTF-01-04 3. Reflector LI10LP-01-01-01 LI10LP-01-01-01 LI18LPT-01-01-01 LI30NG-01-01-01 4. Upper Heat Cover LC10NG-01-01-02 LC10NG-01-01-02 LI18LPT-01-01-02 LC30NGTF-01-01-02 5. Leg Front LC10NG-05 LC10NG-05 LC10NG-05 LC10NG
ページ13に含まれる内容の要旨
CFM Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this heater may result in property damage or personal injury. 13
ページ14に含まれる内容の要旨
RMC-LC NG/LP Unvented Room Heater Item/Model Number RMC-LC10NG/LP RMC-LC20NG/LP RMC-LC30NG/LP 1. Guard Assembly LC10NG-01-04 LI18LPT-01-04 LC30NGTF-01-04 2. Glass Panel LC10NG-01-02-01 LC20NGT-01-02-01 LC30NGTF-01-02-01 3. Glass Holder LC10NG-01-02-02 LC10NG-01-02-02 LC10NG-01-02-02 4. Reflector LC10NG-01-01-01 LC20NGT-01-01-01 LC30NGTF-01-01-01 5. Heat Cover – Upper LC10NG-01-01-02 LI18LPT-01-01-02 LC30NGTF-01-01-02 6a. Pressure Regulator – Natural RTZ-11/20B5 RTZ-11/20B1 RTZ-11/20B1 6b. Pres
ページ15に含まれる内容の要旨
CFM Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this heater may result in property damage or personal injury. Accessories continued for thermostatically controlled operation as desired. Thermostat CAUTION: Damaged power cord can cause a fire or electric turn
ページ16に含まれる内容の要旨
WARRANTY Service and Limited Warranty TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURIS- DICTION THAT GOVERNS THE SALE OF THE PRODUCT; THIS CFM Home Products warrants this product to be free from EXPRESS WARRANTY EXCLUDES ANY AND ALL OTHER defects in materials and components for three (3) years from EXPRESSED WARRANTIES AND LIMITS THE DURATION OF ANY the date of first purchase, provided that the product has been AND ALL IMPLIED WARRANTIES, INCLUDING WARRANTIES OF properly installed, operated an
