ページ1に含まれる内容の要旨
ELECTRIC FIREPLACE
CARE & USE GUIDE
Please read this manual before
installing and using your fireplace
IF THE INFORMATION IN THIS
MANUAL IS NOT FOLLOWED
EXACTLY, AN ELECTRICAL SHOCK
OR FIRE MAY RESULT CAUSING
PROPERTY DAMAGE, PERSONAL
INJURY OR LOSS OF LIFE
ページ2に含まれる内容の要旨
Thank you for purchasing a Fire Sense Electric Fireplace. Important: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. INSTALLATION INSTRUCTIONS – GENERAL 1. Read all instructions before using this appliance. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this appliance
ページ3に含まれる内容の要旨
Thank you for purchasing a Fire Sense Electric Fireplace. Use this appliance only as described in this manual. Any other use not recommended 17. by the manufacturer may cause fire, electric shock or injury to persons. Important: Read all instructions and warnings carefully before starting installation. Avoid the use of an extension cord because the extension cord may overheat and 18. Failure to follow these instructions may result in a possible electric shock, fire hazard and cause a risk of
ページ4に含まれる内容の要旨
SERVICE INSTRUCTIONS FOR YOUR SAFETY Service must be performed by a qualified service agency. REPLACING THE LIGHT BULBS t This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base, chandelier candle type bulbs). The access plate is located on the back of the unit. For convenience, if one of the light bulbs burns out, it may be easier to replace both of the light bulbs at the same time. WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result
ページ5に含まれる内容の要旨
SERVICE INSTRUCTIONS FOR YOUR SAFETY Service must be performed by a qualified service agency. REPLACING THE LIGHT BULBS This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base, chandelier candle type bulbs). The access plate is located on the back of the unit. For convenience, if one of the light bulbs burns out, it may be easier to replace both of the light bulbs at the same time. WARNING: Do not exceed 40 Watts per bulb. Use of higher rated bulbs may result in
