ページ1に含まれる内容の要旨
OPERATING AND INSTALLATION
INSTRUCTIONS
FREEZER
TBUL 140
2222683-02
ページ2に含まれる内容の要旨
Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety Check the appliance for transport damage. Under This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
ページ3に含まれる内容の要旨
At the end of the Appliance Life When disposing of your appliance use an authorised disposal site. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherw
ページ4に含まれる内容の要旨
Operation Before use Fresh food refrigeration Remove all securing tapes. Wash inside the To obtain the best performance, do not store warm appliance with lukewarm water and bicarbonate of food or evaporating liquids in the refrigerator; do soda (5 ml to 0.5 litre of water). Do not use soap or cover or wrap the food, particularly if it has a strong detergent as the smell may linger. Dry thoroughly. flavour. Do not cover the shelves with any protective material, such as paper, cardboard or plastic
ページ5に含まれる内容の要旨
The door shelves Normal Operating Sounds To permit storage of food packages of various sizes, You may hear faint gurgling or bubbling sounds when the central door shelf can be adjusted in height. the refrigerant is pumped through the coils or tubing To do this proceed as in the figure. at the rear, to the cooling plate. When the compressor is on, the refrigerant is being pumped round, and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor,
ページ6に含まれる内容の要旨
Defrosting The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located below the appliance, where it evaporates. Important To avoid defrost water overflowing and dripping onto the food in the fridge, periodically P F clean the water discharge hole (F) situated under the salad drawers. Use the special cleaner provided (P) which you will find already inserted into the discharge hole. S.I.011 Maintenance and Cleaning 1. Remove
ページ7に含まれる内容の要旨
When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to prevent unpleasant smells. Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under gua
ページ8に含まれる内容の要旨
Service and Spare Parts In the event of your appliance requiring service, or if For Customer Service in Ireland please contact us at you wish to purchase spare parts, please contact the address below: your local Service Force Centre by telephoning:- Tricity Bendix 08705 929929 Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Your telephone call will be automatically routed to the Republic of Ireland Service Force Centre covering your post code area. Tel: + 353 1 4090751 For the address of yo
ページ9に含まれる内容の要旨
Guarantee Conditions Standard guarantee conditions We, Tricity Bendix, undertake that if within 24 months of the date of purchase this Tricity Bendix appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. The applia
ページ10に含まれる内容の要旨
Technical Specifications DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 54 cm POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 70 W AVERAGE DAILY UNITS ELECTRICITY (*) 0,40 kWh GROSS CAPACITY 142 l NET CAPACITY 140 l (*) This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located. Installation Warning Important IF YOU ARE DISCARDING AN OLD It must be possible
ページ11に含まれる内容の要旨
Door reversal To reverse the opening direction of the door, proceed as shown in the figures: 6 6 4 1 7 8 5 6 2 3 1 2 Attention 6 10 After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit 13 perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 9 6
ページ12に含まれる内容の要旨
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the observed. terminal in the plug which is marked with the letter If the plug that is fitted to your appliance is not «E» or the
ページ13に含まれる内容の要旨
600 550 min. Building-in instructions Before carrying out any work, remove the plug from Building in the appliance under a the power socket. worktop The dimensions of the recessed installation area Grid preparation must correspond with those indicated in the figure. Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure). A B DO013 Installation kit DO002/2 1xB 2xC Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure)
ページ14に含まれる内容の要旨
596 10 2. Push the appliance into place. The plug socket 4. The joint cover (B) is to be assembled after having necessary for connection of the appliance to the installed the appliance in the recess. electricity supply should be positioned, so that the plug is not placed in the recess. 3. To adjust the height proceed as follows: - Loosen or tighten the two front feet. - The rear feet are adjusted by turning the screw in the front kick plate to the left or right. 1 b) 4 + 5. Screw appliance into
ページ15に含まれる内容の要旨
27,5 cm 27,5 cm 10 I F 10 7 1 2 45° ab 3 C click 11 click c 8 1 Upper part of kitchen furniture panel Möbeltür Innenseite a I = 2 = 12 c b 9 15 55 cm = =
ページ16に含まれる内容の要旨
25 - 80 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. I For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to F K an opening height dimension B=870 mm and a plinth height dimension b=150 mm. For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm G wide, in the centre of the
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
Tricity Bendix, 55-77 High Street, Slough, Berkshire SL1 1DZ Consumer care telephone number……08705 950950 © Electrolux plc 2006
