ページ1に含まれる内容の要旨
5) The elapsed time after a valid dive is completed
CITIZEN QUARTZ
(maximum of 24 hours) is measured automatically.
This watch can be used as a safety guideline for
HYPER AQUALAND
resting time on the surface. [surface mode]
6) To ensure safe diving, various warning functions
are included.
Model No. MA9XXX
B. For safe diving
Cal. No. D201, D207/D202, D208
• Basic knowledge and techniques are required to
dive safely so please take the necessary training
to acquire them.
• INSTRUCTION MANUAL
• In o
ページ2に含まれる内容の要旨
4) When the watch stops or something goes c. Avoid descending too rapidly. wrong with it, please do not use it. In order to get an accurate depth 5) When the water depth meter reading, slow down the descent, or stop. display on the watch shows a big d. Avoid ascending too rapidly. difference with other water depth If you ascend at a speed greater than meters, please refrain from using 1.5m (5ft) per 5 secs (D201/D207). the watch. /0.9m (3ft) per 6 secs (D202/D208). 18m (60ft) per minute (D201/D2
ページ3に含まれる内容の要旨
2. Things to check before diving E. Various warning functions When you dive please check the following points. This watch has 5 warning functions to help you a. Check your watch avoid any trouble or danger while diving. 1) Check that there are no Use these warning functions, as much as problems like scratches, cracks possible, as safety guidelines for diving. The or chips on the strap or glass. level of danger is often complex depending on 2) Check that the band and your body condition or diving
ページ4に含まれる内容の要旨
The dot display symbols and their meaning • By pressing A button in the time and calendar mode, the watch is in temperature measuring state : Time calendar mode (1st temperature display state). In this mode the : Alarm mode temperature is measured every 10 seconds for 3 : During the measurement of temperature minutes. However, until the first measurement is : Log mode (The display when there is no taken it displays [--°C]. profile data recorded) • After 3 minutes the watch autom
ページ5に含まれる内容の要旨
I. How to set the time and calendar • To set the time from the time and calendar mode, press B button for more than 2 seconds, and the “seconds” will start to flash. • By pressing B button you can make the figures you wish to set flash. • To set the flashing figures, press A button. • If you set the calendar year correctly, you never have to set the calendar again; neither at the change over of the month or for leap years. J. The alarm mode Alarm mode: Once you have set the alarm, the alar
ページ6に含まれる内容の要旨
5) The water temperature displays after 1 min. then One dive: In this watch, one dive starts from the time you dive deeper than 1m (4ft) to the time it measures and displays the water temperature you return shallower than 1m (4ft) depth. every second. The water temperature range is 0 0 However when diving deeper than 1m (4ft) after –5 C to 40 C. When it is out of range, it displays 0 being shallower than 1m (4ft) for less than 10 mins, [ C]. the watch will record it as one continuous dive. 6) Wh
ページ7に含まれる内容の要旨
O. The transfer mode [This function allows transfer of diving data to a personal computer.] 1. You can change to the transfer mode from any mode except the diving mode, by pressing M button for more than 2 secs. 2. In this mode, you can transfer data to a personal computer by using the communications unit and a RS-232C direct cable. 3. Compatible computers IBM PC/AT or any other compatible computer (There are some computers that are not N. The log mode compatible). [This is a function to confi
ページ8に含まれる内容の要旨
Place the watch so that the transfer terminal is touching the centre pin of the communication unit’s three way connector. (Look at the picture below) DEPTH.m N.D.TIME 12m (40ft) _____ 200min. 15m (50ft) _____ 100min. 18m (60ft) _____ 60min. 21m (70ft) _____ 50min. 24m (80ft) _____ 40min. 27m (90ft) _____ 30min. 30m (100ft) _____ 25min. 7. How to remove. 33m (110ft) _____ 20min. Hold the band of the watch and raise by lifting the left side 36m (120ft) ___
ページ9に含まれる内容の要旨
8. Available functions b. The first battery • Time and calendar mode • Alarm Mode • The battery which is already in your watch when • Diving Mode • Surface Mode • Log Mode you purchased it, is a monitor battery used to • Transfer Mode check the functions of the watch, and so the
ページ10に含まれる内容の要旨
3. Avoid Temperature extremes Metal bands should be washed periodically to Avoid leaving your watch in direct sunlight or in keep them looking beautiful at all times. extremely warm locations for long periods of time. Metal watchbands are usually washed in mild, • This will cause malfunctioning and shorten the soapy water and well wiped off with a soft, life of the batteries. absorbent cloth to make sure all water is Do not leave your watch for long periods of time removed. Pay attention to prev
