ページ1に含まれる内容の要旨
T187, T188, T189, T190, T191, T628, 2320, 2325, 2339, 2370, 2375, 2389 Series
MT692C
Models 12189, 12242, 12341, 12342, 62300, TL181, TL182, TL183, TL191
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
POSI-TEMP
TUB AND SHOWER VALVES
Available with and without stops.
Connections are either 1/2 inch I.P.S. pipe or 1/2 inch copper sweat connections.
If the Moen Slip Fit spout is used, a 1/2 inch copper drop and lookout may be used.
Measurements
These are shown in the dr
ページ2に含まれる内容の要旨
WITH STOPS WITHOUT STOPS Stop Operation 7" 7" CC - This type is integral with casting, actuated by screwdriver, and require a 90° turn to SHOWER SHOWER open or close. When the screwdriver slot is vertical, the rubber stop is closed, and when the slot is horizontal, the rubber stop is open. IPS - This type has been added to the basic shower casting and is actuated by a screwdriv- er. The stop is opened by rotating in a counterclockwise direction until it stops and closed SUPPLY by rotating in a
ページ3に含まれる内容の要旨
Disassembly Turn "OFF" both hot and cold water supplies, then rotate handle counterclockwise until the lever points straight up to relieve pres- sure. Remove handle parts. 1. For handle style A + B , remove handle insert or plug button. Take out handle screw, remove handle and washer. For handle style C , remove cap screw and handle. Remove handle screw and handle adapter. 2. Remove temperature limit stop, key stop and stop tube. Lift out retainer clip. Rotate cartridge shell betwee
ページ4に含まれる内容の要旨
Trim MAKE SURE ALL WATER SUPPLIES ARE OFF TO INSTALL TRIM AFTER ROUGH-IN SHOWERHEAD Slide the flange onto the long end of the shower arm. Wrap both ends of shower arm with SHOWER ARM thread seal tape and screw long end of shower arm into pipe ell inside the wall. Do not install the showerhead. NOTCH Install tub spout (see page 2). CC CONNECTIONS Remove screw holding plaster ground and stop tube guard in place and discard. Temporarily TEMPERATURE LIMIT STOP install handle. Tur
