ページ1に含まれる内容の要旨
Owner's Manual
NOTE TO INSTALLER:
THIS MANUAL MUST BE LEFT WITH THE
EQUIPMENT USER.
USER: PLEASE READ ALL INSTRUCTIONS
IN THE MANUAL AND RETAIN ALL
MANUALS FOR FUTURE REFERENCE.
FIRE OR EXPLOSION HAZARD
Failure to follow warnings could result in personal
iniury , death, or property damage.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
-Do not try to light any appliance.
-Do not touch any electrical s
ページ2に含まれる内容の要旨
TABLE OF CONTENTS WELCOME TO A NEW GENERATION OF COMFORT .... 2 FURNACE COMPONENTS ........................... 3 SAFETY CONSIDERATIONS ......................... 4 BEFORE STARTING YOUR FURNACE ................. 5 STARTING YOUR FURNACE ......................... 5 SHUTTING DOWN YOUR FURNACE .................. 7 PERFORMING ROUTINE MAINTENANCE ............. 8 FILTERING OUT TROUBLE .......................... 9 COMBUSTION AREA AND VENT SYSTEM ........... 11 WINTERIZATION ...............................
ページ3に含まれる内容の要旨
FURNACE COMPONENTS (Furnace shown in upflow position; may be used in downflow or horizontal orientation or applications. HOT SURFACE IGNITER MANUAL RESET GAS BURNER ROLLOUT SWITCH MANUAL RESET ROLLOUTSWITCH GAS VALVE -- MAIN LIMIT SWITCH (BEHIND GAS VALVE) OPERATING INSTRUCTIONS NOT SHOWN (LOCATED ON MAIN FURNACE DOOR, SEE OPERATING INSTRUCTIONS INSIDE DOOR FIGURE). INDUCER MOTOR ASSEMBLY ELECTRICAL JUNCTION BOX (IF REQUIRED, LOCATION MAY VARY) BLOWER DOOR SAFETY SWITCH MEDIA CABINET BLOWER AND
ページ4に含まれる内容の要旨
SAFETY CONSIDERATIONS Installing and servicing of heating equipment can be hazardous due to gas and electrical components. Only trained and qualified personnel should install, repair, or service heating equipment. Untrained personnel can perform basic maintenance flmctions such as cleaning and replacing air filters. All other operations must be \ \ performed by trained service personnel. Observe safety precautions in this manual, on tags, and on labels attached to the furnace and other safety pr
ページ5に含まれる内容の要旨
extended period of time, have it checked periodically for proper operation. This precaution will prevent problems associated with no heat, such as frozen water pipes, etc. See "Before You Request a Service Call" section in this manual. FIRE OR EXPLOSION HAZARD BEFORE STARTING YOUR FURNACE Failure to follow this warning could result in personal injury, death, or property damage. Exanfine the furnace installation to deternfine that: Do not keep combustible materials, gasoline, and other 1. All flu
ページ6に含まれる内容の要旨
• Read and follow the operating instructions on inside of main furnace door, especially the item that reads as fol- lows: (See Fig. 31.) "Wait 5 nfinutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low "B" in the safety information on furnace label. If you don't smell gas, go to the next step." • If a suspected malfunction occurs with your gas control system, such as the burners do not light when they should, refer to the shutdown procedures o
ページ7に含まれる内容の要旨
SINGLE-STAGE GAS CONTROL MObULAT_NG GASCOm_Ot A92359 Fig. 14 - Turn on Electrical Supply SHOWNFN _OFF ¸' PosmoN 9. Open the external manual gas valve, See Fig. 15. Al1292 Fig. 11 - Control Switch to OFF 6. After waiting five minutes, turn control switch on the gas con- trol to the ON position. Turn the control switch to ON. See Fig. 12. i t A06189 I GAS CONTROL SWffCH Fig. 15 - Open Valve MODULATING GAS CONTROL 10. Set the room thermostat "MODE" to "HEAT" and adjust the set point to a temperatur
ページ8に含まれる内容の要旨
Comfort Fan TM - On all but the base series furnace, the blower 4. Remove main furnace door. See Fig. 10. speed can be increased or decreased if desired due to change of 5. Turn control switch on the gas control to OFF position. See seasons, large gatherings in your home, etc. Simply change your Fig. 19. FAN from ON to OFF for I to 3 seconds (or AUTO depending on StN6LE-SrA_E _AS CONTROL l_<_STAGEC,AS CONTROL your thermostat), and then return to ON. The blower will switch to the next higher spee
ページ9に含まれる内容の要旨
a. Remove filter cabinet door. (See Fig. 21 and 22.) NOTE: It may be necessary to remove one thumbscrew. b. Slide air filter out of furnace. Keep dirty side up (if CUT HAZARD dirty) to avoid spilling dirt. Failure to follow this caution may result in personal injury. 3. Inspect the filter. If torn, replace it. NOTE: If a washable filter was supplied with the furnace and has Although special care has been taken to nfininfize sharp edges, be extremely careful when handling parts or reaching been r
ページ10に含まれる内容の要旨
A00228 A00226 Fig. 24 - Removal of Filter from Bottom Blower Cabinet Fig. 22 - Removal of Filter Cabinet Door from Bottom Blower Cabinet @ A00229 A00227 Fig. 25 - Replacement of Filter Cabinet Door to Side Blower Cabinet Fig. 23 - Removal of Filter from Side Blower Cabinet A00230 Fig. 26 - Replacement of Filter Cabinet Door to Bottom Blower Cabinet Table I - Air Filter Located in Filter Cabinet FILTER CABINET HEIGHT - IN (MM) FILTER SIZE - IN (MM) FILTER TYPE (1) 16 x 25 x 6/4" (406 x 635 x 19)
ページ11に含まれる内容の要旨
HOT SURFACE COMBUSTION AIR AND VENT SYSTEM J IGNITOR GAS BURNER ASSEMBLY FLAME SENSOR MANUAL RESET CARBON MONOXIDE POISONING HAZARD UMIT SWITCH Olt+P+'_ _ 0 ;I _ LIMIT SWITCH (BEHIND GAS VAWE) GAS VALVE -- Failure to follow this warning could result in personal iniury D i ' MAIN UMIT SWITCH or death. If holes are found or if the vent pipe is obstructed or is not connected, toxic fumes can escape into your home. DO NOT Al1319 OPERATE YOUR FURNACE. Call your dealer for service. Fig. 27 - Gas Burne
ページ12に含まれる内容の要旨
7. Pour 1 quart of anti-freeze solution into the funnel/tube. WINTERIZATION Antifreeze should run through the inducer housing, overfill condensate trap and flow to an open drain. 8. If a condensate pump is used, check with pump manufacturer to verify pump is safe for use with antifreeze []NIT AND PROPERTY DAMAGE HAZARD used. Allow pump to start and pump anti-freeze to open drain. Failure to follow this caution may result in unit component or property damage. 9. Remove funnel and tube from collec
ページ13に含まれる内容の要旨
A CHECK-UP CHECKLIST BEFORE YOU REQUEST A "SERVICE CALL" Your furnace represents an important investment in your family's comfort and your home's value. To keep it performing properly If your furnace is not operating or not performing properly, and to prevent future problems, have a trained service specialist you may save the expense of a service call by checking a few give your furnace a professional check-up annually. The following things yourself before calling for service. checklist can be u
ページ14に含まれる内容の要旨
NOTE TO EQUIPMENT OWNER: For your convenience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information will be helpful should your system require maintenance or service. FURNACE INSTALLATION INFORMATION: Model # Date Installed Serial # DEALERSHIP CONTACT INFORMATION: AIR CONDITIONER OR HEAT PUMP Company Name Model # Address Serial # Phone Number INDOOR COIL (Furnace Coil or Fan Coil
ページ15に含まれる内容の要旨
Owner's Manual NOTE TO INSTALLER: THIS MANUAL MUST BE LEFT WITH THE EQUIPMENT USER. USER: PLEASE READ ALL INSTRUCTIONS IN THE MANUAL AND RETAIN ALL MANUALS FOR FUTURE REFERENCE. FIRE OR EXPLOSION HAZARD Failure to follow warnings could result in personal iniury , death, or property damage. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS -Do not try to light any appliance. -Do not touch any electrical s
ページ16に含まれる内容の要旨
TABLE OF CONTENTS WELCOME TO A NEW GENERATION OF COMFORT .... 2 FURNACE COMPONENTS ........................... 3 SAFETY CONSIDERATIONS ......................... 4 BEFORE STARTING YOUR FURNACE ................. 5 STARTING YOUR FURNACE ......................... 5 SHUTTING DOWN YOUR FURNACE .................. 7 PERFORMING ROUTINE MAINTENANCE ............. 8 FILTERING OUT TROUBLE .......................... 9 COMBUSTION AREA AND VENT SYSTEM ........... 11 WINTERIZATION ...............................
ページ17に含まれる内容の要旨
FURNACE COMPONENTS (Furnace shown in upflow position; may be used in downflow or horizontal orientation or applications. HOT SURFACE IGNITER MANUAL RESET GAS BURNER ROLLOUT SWITCH MANUAL RESET ROLLOUTSWITCH GAS VALVE -- MAIN LIMIT SWITCH (BEHIND GAS VALVE) OPERATING INSTRUCTIONS NOT SHOWN (LOCATED ON MAIN FURNACE DOOR, SEE OPERATING INSTRUCTIONS INSIDE DOOR FIGURE). INDUCER MOTOR ASSEMBLY ELECTRICAL JUNCTION BOX (IF REQUIRED, LOCATION MAY VARY) BLOWER DOOR SAFETY SWITCH MEDIA CABINET BLOWER AND
ページ18に含まれる内容の要旨
SAFETY CONSIDERATIONS Installing and servicing of heating equipment can be hazardous due to gas and electrical components. Only trained and qualified personnel should install, repair, or service heating equipment. Untrained personnel can perform basic maintenance flmctions such as cleaning and replacing air filters. All other operations must be \ \ performed by trained service personnel. Observe safety precautions in this manual, on tags, and on labels attached to the furnace and other safety pr
ページ19に含まれる内容の要旨
extended period of time, have it checked periodically for proper operation. This precaution will prevent problems associated with no heat, such as frozen water pipes, etc. See "Before You Request a Service Call" section in this manual. FIRE OR EXPLOSION HAZARD BEFORE STARTING YOUR FURNACE Failure to follow this warning could result in personal injury, death, or property damage. Exanfine the furnace installation to deternfine that: Do not keep combustible materials, gasoline, and other 1. All flu
ページ20に含まれる内容の要旨
• Read and follow the operating instructions on inside of main furnace door, especially the item that reads as fol- lows: (See Fig. 31.) "Wait 5 nfinutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low "B" in the safety information on furnace label. If you don't smell gas, go to the next step." • If a suspected malfunction occurs with your gas control system, such as the burners do not light when they should, refer to the shutdown procedures o
