ページ1に含まれる内容の要旨
FWV460
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel. Appliance information: Please enter the details on the appliance rating plat
ページ3に含まれる内容の要旨
Icemaker Display Control Panel Water Nozzle Ice Drawer Water Tray Drip Tray
Icemaker control panel ON OFF 1 2 3 4 5 6 1. On button 2. Off button 3. Water glass button – this button dispenses a small amount of water. 4. Water jug button – this button dispenses a large amount of water. 5. Manual water button – this button dispenses water as long as t
ページ4に含まれる内容の要旨
The Icemaker Before first use: 1. Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you. 2. Fill the water tank (even if the appliance is to be plumbed in to the mains water supply). 3. Turn on the machine at the switch on the left side of the machine. 4. Push the machine back into the housing. 5. Switch on the machine by pressing the ON button. 6 The machine is now ready for use and the display shows ICE ON WATER READY. The water tank It is possible
ページ5に含まれる内容の要旨
The Icemaker Bicarbonate of soda is a safe compound and poses no risk to health. It is commonly available and is sold in all supermarkets. You should only use cold drinking water in this appliance, with water hardness level less than 7˚F. The water tank can be removed for cleaning, following the steps above, and then lifting it out of the machine. The water storage tray is located below the ice drawer. In normal use this fills with water, which is chilled and ready for dispensing; this does
ページ6に含まれる内容の要旨
The Icemaker To make ice The icemaker will make ice automatically once it is switched on and will continue to make ice until the ice compartment is full. Whenever ice is removed, the icemaker will make more ice until the compartment is full again. To dispense water The amount of water dispensed from the water nozzle is controlled by three different buttons. – water glass – water jug – manual setting – this button dispenses water as long as the button is pressed. The water nozzle is height
ページ7に含まれる内容の要旨
Care and maintenance Always disconnect the appliance from the power before any cleaning or maintenance. As the icemaker has a stainless steel or enamel surface, you should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. Stainless steel can be effectively cleaned by simply using a dilute solution of water and mild detergent and drying to a shine with a clean cloth. Proprietary stainless steel cleaners are avail
ページ8に含まれる内容の要旨
Troubleshooting Problem Solution: WATER MISSING shows in the display The water tank is empty and needs to be refilled ICE FAULT WATER READY shows in the display Turn the icemaker off with and the main switch on the side, before at first switch on switching it on again. The icemaker emits a continuous beep UV Sterilizer needs replacing - contact CDA Customer Care The dispensed water has an unpleasant taste Ensure that only water pipes suitable for drinking water are used ICE FAULT shows in t
ページ9に含まれる内容の要旨
2 min. 200cm Installation IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY SUITABLY 600 QUALIFIED PERSON. 450 min 560 1. Slide the base unit into the housing ensuring the dimensions are correct as per figure 1. 450 min 392.5 19 492.5 2. Fix the base unit in place by attaching the 10 screws in to the holes as shown in figure 2 and figure 3. If the sides of the base are not 458 436 flush with the sides of the housing, then use the shims provided. 3. P
ページ10に含まれる内容の要旨
Installation If necessary the included 6 metre water hose can be cut down to the required length using a sharp knife. You should ensure no burrs are left on the hose. The water connection fitting and flow reducer are prefitted However, if you should need to reconnect the fitting, proceed as follows: Connect one push fit tap adaptor to each end of the water hose. fig. 4
Insert the supplied flow restrictor and black o-ring into the tap adaptor as per fig 6. (Please note, the flow restrictor
ページ11に含まれる内容の要旨
Electrical information Warning! This appliance must be earthed. Green & Yellow to Earth Brown to A Live 13 Amp B Fuse Cord Clamp Blue to Neutral The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in
ページ12に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
