ページ1に含まれる内容の要旨
Owners Manual
Manual del Usuario
Model No.
200605
U.S. Patent Number: 6,470,877; All Other
Foreign Patents May Apply.
WARNING
FOR YOUR SAFETY
For Outdoor Use Only
(Outside any enclosure)
Solamente Para Uso En
Exteriores
(Fuera de cualquier recinto)
WARNING
FOR YOUR SAFETY
Improper installation,
adjustment, alteration,
service or maintenance
can cause injury or property
damage. Read the installation,
operation and maintenance
instructions thoroughly before
installing or servicing this
ページ2に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. WARNING WARNING FOR YOUR SAFETY FOR YOUR SAFETY For Outdoor Use Only Improper installation, (Outside any enclosure) adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operation and maintenance instructions WARNING thoroughly before installing or servicing this equipment FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open
ページ3に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Table of Contents Safety First! . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 . . . . . . . . . . . . . . . . . Assembly Instructions Component Listing & Hardware . . . . . . . . . . . . . . . . . . . . . . . 5 . . . . . . . . . . General Components & Features . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . . Additional Requirements . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Safety First! Read and become familiar with this entire manual, especially the following precautions . If you are unsure of anything in these instructions, STOP and contact -800-762- 42 for assistance . Caution: This appliance is for outdoor use only (outside any Before you do anything else, enclosure). Always make sure there is fresh air ventilation. read and understand all • Always maintain at least 36” cl
ページ5に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Caution: Liquid propane (LP) gas is flammable and hazardous if “20 lb.” LP Tank handled improperly. Become aware of the characteristics before using any LP product. Collar Valve • LP Characteristics – Flammable, explosive under pressure, heavier than air - settles in pools in low areas . • In its natural state, propane has no odor . For your safety, an odorant is added that smells like rotten cabbage . • Contact
ページ6に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Components Hardware Part Re-order Name Number Used in Picture Qty Description Step(s) Finial . . . . . . . . 56-0 . . .- 03 Carriage Bolt 3 3/8-6 x 3-3/4” Zinc Plated Bolt Dome Cap . . . . . 56-0 . -04 56-0-99 Dome Nut . . . . . . 56-0 . -208 2 Bolt & 2 /4-20 x 3/4” Nickel Dome Plate . . . . . 56-0 . - 05 Plated Hex Head Bolt 56-0-200 Dome Panel (3) . . . 56-0- 07 L
ページ7に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Assembly Instructions General Components & Features Familiarize yourself with all components before proceeding . Refer to page 5 for hardware and components, and page 2 for specifications . Do NOT attempt assembly unless all components are available . If you believe a component is missing or damaged, contact -800-762-42 for assistance . Note: All hardware is mounted on a cardboard pack and numbered to match their as
ページ8に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 2 – Attach Platform to Legs Line up hole in Clip with small threaded hole on bottom of Platform . Attach Clip loosely to Platform with () Large Screw . Note: Do not tighten until step 9 . Using 7/6” wr ench, secure Platform to Legs using (2) Small Bolts, (2) Small Lock Washers and (2) Small Nuts per Leg . Tighten fully . Fully tighten all nuts and bolts from Step . TIP: To tighten use a 7/6” wrench on Bolt
ページ9に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 4 – Insert Gas Line through Platform/Attach Shroud Cover Insert Gas Line up through large hole in Platform from underneath between center and left leg as shown in illustration . Slide Shroud Cover over Gas Line, then over Platform/Leg assembly until bottom of Shroud rests on Base . Step 5 – Attach Engine to Post Lay Engine Assembly on its side, using carton for support . Remove and save Control Knob . Remove and s
ページ10に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 6 – Attach Engine/Post to Platform Insert end of Post without holes over Gas Line, being careful not to bend Gas Line . Slide Post into collar of Platform so Post rests completely on Platform . Tighten bottom three setscrews with hex (Allen) wrench supplied . Make sure Post is perpendicular to Base . Use top three setscrews to adjust Post’s angle as necessary . Tighten all six setscrews . Note: Post must be perpen
ページ11に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 8 – Assemble dome Note: Each dome section has a pin mounted in place in the rolled bottom edge . If necessary for proper alignment of dome sections, loosen each screw prior to further assembly and retighten after sections are aligned . • With the lar ge side facing up, slide a dome rib on to the same side of one dome section as the pin . Slide two dome sections together, allowing the exposed end of the pin slide
ページ12に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 10 – Secure Gas Line Caution Make sure angled side of Gas Clip pokes up through large hole in Platform . Before you attempt to use a propane tank, understand Tighten screw until Gas Line is held securely in place . all tank and propane related Stand Heater upright . precautions in Section #1 - “Safety First.” SECTION VIEW gas line clip gas line BOTTOM VIEW Step 11 – Connect Gas Line to Tank Caution The pressure r
ページ13に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 12 – Check for Leaks • Make 2-3 oz . of leak check solution by mixing one part liquid dishwashing soap and three parts water . • Turn tank valve ON . • Check Gas Line / Control Valve for leaks: • Spoon several drops of solution onto Gas Line and Control Valve connection . • Inspect the solution at the connection to look for bubbles . • If NO bubbles appear, then the connection is secure . • If bubbles appear, the
ページ14に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Step 13 – Replace Engine Access Panel • Slide Igniter wire onto Igniter post . • Slide tab at top of Access Panel into slot in Emitter bottom . • Rotate Panel down until holes line up at bottom . • Secure Access Panel in place with thumbscrew . • Replace Control Knob . Step 14 – Install Igniter Battery Note: This step is required only for models with electronic ignition . • Remove battery cover cap by turning cap counterc
ページ15に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Operation WARNING Caution: Do NOT attempt to operate heater until you have read and FOR YOUR SAFETY understand all precautions in section 1 “Safety First.” • Do NOT attempt to operate heater until you have Before Turning Gas Supply ON read and understand all • Your heater was designed and approved for OUTDOOR USE ONLY . precautions in Section 1 DO NOT use it inside a building, garage, or any other enclosed area .
ページ16に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. • If for some r eason your ignitor fails to deliver a spark, your heater can be started by inserting a lit match through the pilot view hole while WARNING pushing the control knob in while in the PILOT position . FOR YOUR SAFETY If you experience any ignition problem consult “Troubleshooting” on Be careful when attempting page 7 . to manually ignite this heater. Caution: Avoid inhaling fumes emitted from the heat
ページ17に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Operation Checklist For a safe and pleasurable heating experience, perform this check before each use . Before Operating q I am familiar with entir e owner’s manual and understand all precautions noted in “Safety First” . q All components are properly assembled, intact and operable . q No alterations have been made . q All gas connections ar e secure and do not leak . q Wind velocity is below 0 mph . q Outdoor temp
ページ18に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Troubleshooting If the problem is: And this condition exists: Then do this Tank valve is closed Open valve Pilot won’t light Blockage in orifice or pilot tube Clean or replace orifice or pilot tube Air in gas line Open gas line and bleed it (pressing control knob in) for not more than Note: Heater operates at reduced efficiency below 40ºF (5ºC). - 2 minutes or until you smell gas Low gas pressure with tank valve full
ページ19に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Maintenance WARNING To enjoy years of outstanding performance from your heater, make sure you perform the following maintenance activities on a regular basis: FOR YOUR SAFETY Keep exterior surfaces clean . • Do NOT touch or move Use warm soapy water for cleaning . Never use flammable or corrosive heater for at least 45 minutes cleaning agents . after use. While cleaning your unit, be sure to keep the area around
ページ20に含まれる内容の要旨
Contact 1-800-762-1142 for assistance. Do not return to place of purchase. Storage Between uses: Turn Control Knob OFF . Disconnect LP source . Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris) . If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages . Note: Wait until heater is cool before covering . During periods of extended inactivity or when transporting: Tu
