ページ1に含まれる内容の要旨
Power Edger Attachment
Operator's Manual
MODEL 99944200475
MODELS USED ON: SRM-260SB/261SB
PAS-2400
PAS 230/231
PAS 260/261
PAS-265
WARNING
Read rules for safe operation and instructions carefully. ECHO provides an
Operator's Manual and a Safety Manual Pro Attachment Series power source or
Split Boom Trimmer. Those manuals and this manual must be read and under-
stood for proper and safe operation, otherwise serious personal injury may result.
X770001321
X770209370
ページ2に含まれる内容の要旨
2 Introduct Ino Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the- job-dependability. Read and understand this manual and the SAFETY MANUAL you found in the same package. You will find both easy to use and full of helpful operating tips and SAFETY messages. teh cetahnm tt a ort opera 's alamun Read and understand this manual before operation. Keep it in a safe place for future reference. It contains specifications and information fo
ページ3に含まれる内容の要旨
Power e dger Att Achment 3 o Per A or t 's m Aun Al s eafty manual smoesysybalft nda I ant mport I t nforma Ion Throughout this manual and on the product itself, you will find safety alerts and helpful, information messages preceded by symbols or key words. The following is an explanation of those symbols and key words and what they mean to you. CIRCLE AND SLASh SyMBOL DANGER This symbol means the specific action The safety alert symbol accompanied by the word shown is prohibited. Ignori
ページ4に含まれる内容の要旨
4 lnosrepa ocnd It Ion nda saytfe equ Ipment WARNING Edger users risk injury to themselves and others if the edger is used improperly and or safety precautions are not fol- lowed. Proper clothing and safety gear must be worn when operating an edger. Physical Condition Proper Clothing Your judgment and physical dexterity may not be good: Wear snug fitting, durable clothing; • if you are tired or sick, • Pants should have long legs, shirts with
ページ5に含まれる内容の要旨
Power e dgre Att Achmtne 5 o Per A or t 's m Anu Al Repetitive Stress Injuries -- It is believed that overusing the muscles and tendons of the fingers, hands, arms and shoulders may cause soreness, swell- ing, numbness, weakness and extreme pain in those areas. Certain repetitive hand activities may put you at a high risk for developing a Repetitive Stress Injury (RSI). An extreme RSI condition is Carpal Tunnel Syndrome (CTS), which could occur when your wrist swells and squeezes a vital nerv
ページ6に含まれる内容の要旨
6 uqe Itnemp WARNING Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non approved ECHO product. Before operation a complete check of the unit must be performed; • Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed. • Inspect shield for damage and is securely in place. Replace if shield is damaged or missing. • Check that the c
ページ7に含まれる内容の要旨
Power e dger Att Achment 7 o Per A or t 's m Anu Al 1. BLADE - Rotates to provide cutting action. 2. DEBRIS ShIELD/FLAP - Mounted over the cutting attachment. Helps protect operator by deflecting debris produced during the edging operation. 3. DRIVE ShAFT ASSEMBLy - Contains a specially designed liner and the flexible drive shaft. 4. WhEEL - Adjustable up/down, sets depth of blade. c sontent After opening the carton, check for damage. Immediately notify your retailer or ECHO
ページ8に含まれる内容の要旨
8 NOTE D C Earlier model Power Heads may have shorter couplings. Short couplings fit flush to decal point (E). New couplings are 4-3/4 in. long, and fit flush to line (C). NOTE Lower bearing housing and head assembly must be in line with the engine. 5. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft hole. Insure locator pin is fully engaged by twisting lower drive shaft. Locator pin should snap flush in coupler. Full engagement will prevent further shaft rotation. 6. S
ページ9に含まれる内容の要旨
Power e dgre Att Achtenm 9 o Per A or t 's m Aun Al WARNING Never adjust blade height with engine running, otherwise serious personal injury may result. ADJUSTMENT WHEEL KNOB 4. Adjust the blade's depth of cut to produce a fine cut between side- INCREASE walk and grass using a minimum blade depth, usually with about DEPTH 13 mm (1/2 in.) of the blade into the ground. 5. Before edging, plan your direction of travel so that the unit will al- DECREASE ways be positioned on your right side and
ページ10に含まれる内容の要旨
10 sk Ill lelev Level 1 = Easy to do. Common tools may be required. Level 2 = Moderate difficulty. Some specialized tools may be required. ma Intenance I als v nter Component/System Maintenance Procedure Skill Level Frequency Drive Shaft Grease 1 Every 25 hours of use Gear Housing Grease 1 Every 15 - 25 hours of use Screws/Nuts/Bolts Inspect/Tighten/Replace 1 Before each use eladb replacemtne /lubr I t ac Ion Level 1. Tools Required: T-Wrench, Locking Tool, Needle Nose Pliers, 13
ページ11に含まれる内容の要旨
Power e dger Att Achment 11 o Per A ro t 's m Anu Al 5. Clean all loose debris from gear box. 6. Remove plug (G) and check level of grease. Grease should fill gear case to bottom of grease plug hole. G 7. Add grease if necessary using manual grease gun or squeeze-type tube. Do not use high pressure grease gun. DO NOT over-fill. 8. Install inner blade adapter (B) onto PTO shaft (C). 9. Install and center new blade (F) onto inner adapter (B). 10. Install outer adapter (E) and nut (D). Tighten
ページ12に含まれる内容の要旨
12 s oraget Storage Hook Installation 1. Insert small end of hook into locating hole on attachment shaft. 2. Slide plastic cap onto end of attachment shaft. s pec If I t ca Iosn MODEL ---------------------------------------------------- 99944200475 Shaft Length ------------------------------------------------ 825 mm (32.48in.) Attachment Width ----------------------------------------- 150 mm (5.9 in.) Attachment Height ----------------------------------------- 295 mm (11.61 in.) Weight w/blad
ページ13に含まれる内容の要旨
Power e dger Att Achment 13 o Per A or t 's m Aun Al enots
ページ14に含まれる内容の要旨
14 notes
ページ15に含まれる内容の要旨
Power e dger Att Achment 15 o Per A or t 's m Aun Al enots
ページ16に含まれる内容の要旨
s v er Ic Ign I t amrofn Ion tsra p /res Ila unerbm Genuine ECHO Parts and ECHO REPOWER™ Parts and Assem- blies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number and Serial Number of the attachment with you. You can find these numbers on the driveshaft model/serial number label. For future reference, write them in the space provided below. Model No. _____________ SN. ____________ v ers Ice DEALER? Servic
