ページ1に含まれる内容の要旨
NOTE:
Please read all instructions
carefully before using this
product
APEX
Tri-Level Dumbbell Rack
Safety Notice
DBR 92
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
DBR 92
Retain This
Manual for
Reference
07-4-06
®
IMPEX INC.
OWNER'S
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
MANUAL
Tel: (800) 999-8899 Fax: (626) 961-9966
www.impex-fitness.com
info@impex-fitness.com
ページ2に含まれる内容の要旨
TABLE OF CONTENTS BEFORE YOU BEGIN...................................................................................... 1 IMPORTANT SAFETY NOTICES..................................................................... 2 HARDWARE PACK……….....…....................................................................... 4 ASSEMBLY INSTRUCTIONS........................................................................... 5 EXPLODED DIAGRAM.......................................................
ページ3に含まれる内容の要旨
IMPORTANT SAFETY NOTICE PRECAUTIONS This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions: 1. Keep children and pets away from the machine at all times. DO NOT leave children unattended in the same room with the machine. 2. Only one person a
ページ4に含まれる内容の要旨
WARNING LABEL REPLACEMENT The Warning Label shown here has been placed on the Stabilizer. If the label is missing or illegible, please call customer service at 1-800-999-8899 for replacement. Apply the label in location shown. 3
ページ5に含まれる内容の要旨
HARDWARE PACK 4
ページ6に含まれる内容の要旨
ASSEMBLY INSTRUCTION Tools Required Assembling the Machine: One Adjustable Wrench and Allen Wrench NOTE: It is strongly recommended this machine be assembled by two or more people to avoid possible injury. STEP 1 (See Diagram 1) A.) Connect the Left Stabilizer (#3) to the Left Upright Beam (#1). Secure the side with two M10 x 3 ½” Allen Bolts (#13), four ∅ ¾” Washers (#9), and two M10 Aircraft Nuts (#14). Secure the Bottom with one M10 x 5/8” Allen Bolt (#10) and Ø ¾” Washer (
ページ7に含まれる内容の要旨
STEP 2 (See Diagram 2) A.) Connect the Left & Right Upright Beams (#1 & #2) with one Dumbbell Rack (#5) on the top level. Align the holes then secure each end of the Rack with one M10 x 2 ¾” Allen Bolt (#12), two ∅ ¾” Washers (#9), and one M10 Aircraft Nut (#14). Repeat the same step to install the other Dumbbell Rack. Do not tighten the nuts and bolts yet. B.) Repeat Procedure A above to install two Dumbbell Racks to the second level. C.) Repeat Procedure A above to install two Dumbbe
ページ8に含まれる内容の要旨
STEP 3 (See Diagram 3) A.) Insert a Weight Post (#6) into the hole on the side of the Left Upright Beam (#1). Secure it with a M10 x 1 1/8” Allen Bolt (#11) and ∅ ¾” Washer (#9). B.) Slide an Olympic Sleeve (#8) onto the Weight Post. Repeat the same step to install the other three Posts DIAGRAM 3 7
ページ9に含まれる内容の要旨
8
ページ10に含まれる内容の要旨
Parts list KEY NO. DESCRIPTION Q’ty 1 Left Upright Beam 1 2 Right Upright Beam 1 3 Left Stabilizer 1 4 Right Stabilizer 1 5 Dumbbell Rack 6 6 Weight Post 4 7 1” End Cap 4 8 Olympic Sleeve 4 9 Ø ¾” Washer 38 10 M10 x 5/8” Allen Bolt 2 11 M10 x 1 1/8” Allen Bolt 4 12 M10 x 2 ¾” Allen Bolt 12 13 M10 x 3 ½” Allen Bolt 4 14 M10 Aircraft Nut 16 9
ページ11に含まれる内容の要旨
® IMPEX INC. LIMITED WARRANTY IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of two years on the Frame from the date of purchase. This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited to replacing or repairing, at IMPEX's option. All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
