ページ1に含まれる内容の要旨
Jiffy 30 Series
Power Ice Drill
OPERATING MANUAL/PARTS GUIDE
This manual contains operating and safety instructions for the Jiffy
SERVICE & REPAIR INFORMATION
30 Series Power Ice Drill. To receive the greatest possible
For engine adjustments, repairs or warranty service not
performance and satisfaction from your Jiffy Power Ice Drill, and to
reduce the risk of injury, it is important that you read and understand covered in this manual, contact your neare
ページ2に含まれる内容の要旨
GENERAL SAFETY PRECAUTIONS + Using your Jiffy Power Ice Drill may be strenuous. If you have any To receive the greatest possible performance and satisfaction from condition that may be aggravated by strenuous activity, your Jiffy Power Ice Drill, and to reduce the risk of injury, it is check with your doctor before operating your Jiffy Power Ice Drill. important that you read and understand the assembly, operating, maintenance, and safety instructions before using your Jiffy Power + Do
ページ3に含まれる内容の要旨
ASSEMBLY WING HANDLE INSTALLATION (See diagram – some units may TO MIX OIL AND GASOLINE have handle installed. 1. Mix a brand name gasoline and quality two-cycle engine oil in an approved, clean, safety-type container. Inferior quality gasoline or oil Fasten both wing handle halves (Ref. No. 2) to wing handle plate may damage the engine, sealing rings, fuel lines or fuel tank. #2823 using 4-hex capscrews (#2840) and 4-locknuts (#2841). Affix 2. Add recommended oil to gasoline per FUEL
ページ4に含まれる内容の要旨
5. Grasp STARTER HANDLE (see Figure 1) and pull slowly until OPERATION/STOPPING INSTRUCTIONS you feel the rewind engage, then give the handle a brisk, strong NOTE: To minimize water splash, back-off throttle when the drill breaks pull. Do not wrap the starter rope around your hand. Do not let thru ice, then raise drill slowly. the starter rope snap back, rather guide it slowly into the housing to allow proper rewind. Failure to follow these NOTE: The clutch slips when the drill is overl
ページ5に含まれる内容の要旨
When you have your Jiffy Key Keeper positioned where you want it, For engine adjustment or repairs not covered in this section see the Service install (or re-install) your handle half, tightening the bolts securely & Repair Information section below. without over-tightening. Allow your installed Jiffy Key Keeper to dry for a day or two, and then slide (without any lubrication) your hex IF ENGINE IS NOT TO BE USED FOR 30 DAYS OR MORE, PREPARE AS wrench about midway into the small hole in th
ページ6に含まれる内容の要旨
JIFFY® POWER ICE DRILL 30 SERIES PARTS LIST Includes: Model 30, Model 31 LEGEND™, Model 34 STEALTH™ & STEALTH STX™, FirePower™ and D-Ice’r ARMOR™ RIPPER™ Drill Assemblies REF. NO. PART NO. DESCRIPTION NO. USED 1 3033 Fuel Tank Cap 1 2 2879 Wing Handle Half (For Model 30) 2 “ 3485 “ “ “ (For Model 31 & 34) 2 3 1721 Vinyl Finger Grip 1 4 1716 Throttle Rod 1 5 2823 Wing Handle Plate 1 6 2451 Locknut 1
