ページ1に含まれる内容の要旨
WINDOW
ACS520 ACSIOZ MODELS
CONDlTlONERS AIR SLIDER/CASEMENT
cdlwllhqlbeslion8acommonts.
laxw53-1301
28 Warranty
24
$$$=F~
Need You If
20
c&i&F&~
17 conditioner Au
Your Operating
5 Mordtioner
Your lnstallin
Features
4
And Parts
IFZZ?
3
ANoteToYw
2
UseAndCare
lnstakrtion,
ページ2に含まれる内容の要旨
A To for a WhirlpooP safety is to is toll-free, a Date Purchase Phone Demler Number Serial Name Dealer Number Model reference. future for place safe a in together slip sales the and book this Keep number. telephone and name dealer’s your and slip sales the from date purchase the numbers, these record to you for below place handy a included have we convenience, your For 4). page on diagram (see plate number serial and model the on information this find can You number. serial and numb
ページ3に含まれる内容の要旨
l l l l l l l l l l l l l 3 material. the damage can These cleaners. abrasive or fluids flammable instruments, sharp use not Do residue. glue any off take to cloth damp a Use Guide. Buy and Label Energy the remove Also, properly. conditioner air the Maintain propetfy. it operate to unable anyone by used not is conditioner air the sure Be purpose. intended its for only condiiioner air the Use cool. to want you area the for size correct the is conditioner air the sure Be ti
ページ4に含まれる内容の要旨
I COIIBOI number lobphone Centu COlltTOl Asoistmco tisumu FL panel) Intake air (behind lilb air ROIlbOVdO wheel thumb direction Air like. look they what and located are features and parts all where with familiar become to them Use appliance. your of illustrations captioned contains section This Features PartsAnd
ページ5に含まれる内容の要旨
In This PWP PW 5 ln.lallbIg in a crmont . . . . . . . . . . . . . . . . . . 13 requirements POWER l l l l l Electrical 5 provided. be must appliance, this only sewing circuit, separate A required. also is breaker circuit delay time or fuse delay time A required. is supply death. or electrical fused ampere 15 only, AC Hertz, 60 injury serious shock, electrical in resutt maximum), 126.5 minimum, (103.5 volt 115 A could instructions these follow to Failure requirements grounde
ページ6に含まれる内容の要旨
Electrical tips l l l l l l l l l l l l l damage. product or injury personal in resull bit drill %-inch could precautions above the follow to Failure bit drill %-inch sanitary. not is lt purposes. drinking for drill hand or Electric unit the in collected water the use not Do saw tooth Fine installation. during measure Tape fall not does conditioner air your sure Be level Carpenter’s coils. rear and front the on fins metal sharp the for out screwdriver Phillips-head W
ページ7に含まれる内容の要旨
kft. x x x x x W’ 7 installation. for screws separating when handy in come will This screws. your of length the measure to right the at scale the Use NOTE: (1) brace Support M. (8) wood-head round #8 - Screw L. (1) l/4’ - nut flange Hex K. (1) bracket locking Window J. (1) panel window Plastic I. (1) seal channel Side H. (1) seal strip/Sash seal Foam G. (1) seal Track F. (7) self-threading o/4’ #8-32 - Screw E. (1) bracket Safety D. (2) pan-head 1’ #lO - Screw OR (2) pan-he
ページ8に含まれる内容の要旨
l l l l l jambs. jamb 8 window. the in assembly the testing when place in board the hold house, your of outside the on 5) Step (see board protection siding- a use to planning are you lf NOTE: damage. water cause and home your into drip could water slope, proper the Without outside). on lower (?&inch slope proper the allow and properly rest will platform the if determine to window the in assembly the Try brace. support the and platform the between angle 45’ a create will that loc
ページ9に含まれる内容の要旨
mark jamb. jambs, mark Dammge marked 2. 9 studs. wall 2 span to enough long be should board siding-protection The NOTE: shown. as brace support the of base the to board siding-protection the attach damage, siding permanent avoid To OR house. the of side the to board riding-protection a attach Securely 5. track inner the in strip seal the above directly be should 3 Step in drilled holes screw two The Step in line the with coincide should strip seal the of center The track. wind
ページ10に含まれる内容の要旨
jamb. make md 10 grooves. retainer the by sides all on enclosed firmly is panel window plastic the sure Make cabinet. conditioner air the of channels side the into back assembly frame panel the Slide outside. the to side smooth the with frame the into panel window plastic the Slide cabinet. conditioner air the of channels side the from frame panel the Lift 11. in&se. 20% subtract bebnco Measure file. a with burrs any Remove saw. tooth fine a with line cutting the along cut and
ページ11に含まれる内容の要旨
l fmmo. jambs. 11 window side and top the against are channels side cabinet the and frame panel window the that so assembly platform the on sit should It opening. window the in conditioner air the Piece 14. l.Preudown louvers. direction air the on pull or push not Do NOTE: clips. spring bottom the off up it lift and forward, lt tilt frame, panel front the of edge top the on down press Finally, place. in frame panel front the holding screws Phillips-head 2 the remove Next, clips.
ページ12に含まれる内容の要旨
x x jambs, x brmket x x jamb jambs, jambs. A 12 we wge -stop la- or Add16- AddM*to locally. strip angle the purchase can You flange. C the becomes sash inner the of comer leading the opening, the of side sash the On ments. treat- alternate show C CL B Figures installed. angle this shows A Figure window the to attached angle) thick max. l&inch (or flange mating a against fit must frame panel and channels the side and top the on stops wood or flanges no having windows in ins
ページ13に含まれる内容の要旨
casement jamb. l jamb jamb jamb jamb jamb. 4. jamb x 13 screw. self-threading %-inch #8 a Use 2. - Step in drilled you hole pilot the through seal Track window the to assembly pletform the Screw bottom the of outside the on sill window the to seal the stick and seal track jamb. window bottom UM of dg~ Appiytmcksuitotboouteido the from backing protective the off Peel 3. slot. this miss to window the and edge platform the through drilled be to have will hole additional an bo
ページ14に含まれる内容の要旨
14 grooves. retainer the by sides all on enclosed firmly is panel window plastic the sure Make cabinet. conditioner air the of channels side the into back assembly frame panel the Slide outside. the to side smooth the with frame the into panel window plastic the Slide cabinet. conditioner air the of channels side the from frame panel the Lii 9. file. a with burrs any Remove saw. tooth fine a with line cutting the along cut and table work a and board a between penel window pleetlc the
ページ15に含まれる内容の要旨
3. forward to front fmme. enduft to jambs. jambs equally. window side overlap should channels Side window side and top the against are channels side cabinet the and frame panel window the that so assembly platfom-r the on sit should It opening. window the in conditioner air the Piece 12. panel. lntako air remove toward l.Pmedown louvers. direction air the on pull or push not Do NOTE: clips. spring bottom the off up it lift and forward, it tilt frame, panel front the of edge
ページ16に含まれる内容の要旨
jamb jamb x jambs. jambs x 16 place. into panel intake air snapping before panel intake air of back into filter air Snap filter. air and panel intnke air the Replete 16. louvers. panel front the on pull or push not Do place. in panel the hold that screws 2 the replace to sure Make frame. panel front conditioner air the Replete 15. room. the into pushed being from conditioner air the prevent will screws these of insertion The NOTE: screws. the with seals channel side the twist t
ページ17に含まれる内容の要旨
In This Pm PW 17 . . . . . . . . . . . 16 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 . . . . . . . . . . . . . . . 18 l l l 17 breaker. circuit a tripping or fuse a blowing from conditioner air the keeps this Doing on. back it turning before minutes 3 least at wait Control, Thermostat the lowering when off turns compressor the if or off conditioner air your turn you If NOTE: best. you suits which setting the find to expe
ページ18に含まれる内容の要旨
temperatures l 18 open. are louvers all sure Make 3. setting. middle the to Control Thermostat Set 2. setting. COOL desired to Control Fan the Set 1. build-up: frost prevent To gone. is frost until run to unit allow and setting ONLY FAN the to Control Fan the Set coik: the defrost To room. the into airflow the block will This panel. intake air the behind coils the on form may frost cooling, is conditioner air the and 70°F below drops temperature outside the When outside low at Cool
ページ19に含まれる内容の要旨
louvers l l 19 combinations. airflow of variety a for separately adjusted be can wheels thumb and tabs The NOTE: airflow. desired for right or left the to wheel thumb Turn right: or left airflow direct To aim0w down ThhXup/ of edges outside the at louvers. the located tabs the with down or up louvers the Tilt down: or up airflow direct To right. or left down, up, - directions 4 in airflow the direct can conditioner air Your direction. airflow the control louvers direction air Th
ページ20に含まれる内容の要旨
In This Pm .20 normd l . ..2 3 Iho .......................... 21 ................................................ tho ...... . ................................ l nnud .................... .21 l l 1. forwerd 20 cord. power the in Plug 10. tabs. upper the secure to unit the toward it push and panel of edge top on down Press clips. spring the on panel of bottom Locate panel. intake air the Replace 9. pnd i&ko Air fifter. air Replace 6. cloth. dry soft, a wfth clean panel control
