ページ1に含まれる内容の要旨
4-095-793-07 (1)
LCD Monitor
JP
_____________________________________________
GB
Operating Instructions ____________________________________
FR
Mode d’emploi __________________________________________
DE
Bedienungsanleitung _____________________________________
ES
Manual de instrucciones ___________________________________
IT
Istruzioni per l’uso ________________________________________
CS
_____________________________________________
CT
____________________________________________
KR
_________
ページ2に含まれる内容の要旨
a b c JP 2
ページ3に含まれる内容の要旨
JP
ページ4に含まれる内容の要旨
JP 4
ページ5に含まれる内容の要旨
JP 5
ページ6に含まれる内容の要旨
JP 6
ページ7に含まれる内容の要旨
JP 7
ページ8に含まれる内容の要旨
JP 8
ページ9に含まれる内容の要旨
A B C D E F G JP 9
ページ10に含まれる内容の要旨
12 3456 A F B C 1 8 y D y y y y E y JP 10
ページ11に含まれる内容の要旨
1 2 JP 11
ページ12に含まれる内容の要旨
JP 12
ページ13に含まれる内容の要旨
JP 13
ページ14に含まれる内容の要旨
Compliance with this directive implies conformity to the following European standards: WARNING • EN55103-1: Electromagnetic Interference (Emission) • EN55103-2: Electromagnetic Susceptibility Owner's Record (Immunity) This product is intended for use in the following The model and serial numbers are located at the rear. Electromagnetic Environment(s): Record these number in the space provided below. E1 (residential), E2 (commercial and light industrial), Refer to these numbers whenever you
ページ15に含まれる内容の要旨
Attention-when the product is installed in Rack: 1.Prevention against overloading of branch circuit: When this product is installed in a rack and is supplied power from an outlet on the rack, please make sure that the rack does not overload the supply circuit. 2.Providing protective earth: When this product is installed in a rack and is supplied power from an outlet on the rack, please confirm that the outlet is provided with a suitable protective earth connection. 3.Internal air am
ページ16に含まれる内容の要旨
Table of Contents Installation ..............................................................5 Cautions ..............................................................5 Installing to the rack ...........................................5 Precautions .............................................................5 On safety .............................................................5 Handling the LCD screen ...................................5 About the fluorescent tube ............................
ページ17に含まれる内容の要旨
Installation Precautions Cautions On safety • Prevent internal heat build-up allowing adequate air • Operate the unit on 100 - 240 V AC only. circulation. • The nameplate indicating operating voltage, power Do not place the unit on surfaces (rugs, blankets, etc.) consumption, etc. is located on the rear. or near materials (curtains, draperies) that may block • Should any solid object or liquid fall into the cabinet, the ventilation holes. unplug the unit and have it checked by qualified • Do
ページ18に含まれる内容の要旨
High brightness LCD panel Maintenance Because the monitor uses high brightness and high contrast technology, it can be used under various Before cleaning lighting conditions. Be sure to disconnect the AC power cord from the AC outlet. Rack mount monitors with tilt function On cleaning the monitor screen LMD-7220W and LMD-5320 are mounted to a 3U size The monitor screen surface is especially treated to rack and LMD-4420 is mounted to a 2U size rack. All reduce reflection of light. the moni
ページ19に含まれる内容の要旨
Location and Function of Parts and Controls Front Panel Each panel is equipped with buttons and controls other than the POWER switch and indicator. LMD-7220W LMD-5320 LMD-4420 GB Location and Function of Parts and Controls 7
ページ20に含まれる内容の要旨
A POWER switch and indicator Adjusting the viewing angle Each time you press the switch, the power is turned on You can adjust the viewing angle of LMD-5320/7220W or off. When the power is turned on, the indicator up to 10 degrees upward or downward and LMD-4420 lights in green. up to 8 degrees upward or 10 degrees downward. B Tally lamp Adjusting upward You can check the status of the monitor that the signal is input by the color. The lamp lights in red or green by signals from the Press
