Toshiba の取扱説明書

ページ1に含まれる内容の要旨

INDEX MDS-O-0001
TOSHIBA INTERNATIONAL CORPORATION
SHEET NO. 1 of 3
Industrial Division / Houston Motor Plant
ISSUED 01/24/96

SUPERSEDES NEW
Motor Operation Procedure
REVISION 0

WRITTEN BY I. MARQUEZ
REFERENCE USE ONLY WHEN ISSUED BY MOTOR MKTG.
APPROVED BY
J. Bugbee


Motor Lubrication
Dist: Mktg.
QC 1. SCOPE
To give recommended guidelines for electric motor relubrication.

2. START UP
Toshiba motors are properly greased at the time of manufacture. It is recommended t

ページ2に含まれる内容の要旨

INDEX MDS-O-0001 TOSHIBA INTERNATIONAL CORPORATION SHEET NO. 2 of 3 Industrial Division / Houston Motor Plant ISSUED 01/24/96 SUPERSEDES NEW Motor Operation Procedure 3. STANDARD SERVICE (-cont.) 5. Remove relief plug or plate and using a low pressure hand held grease gun, pump the required amount of grease. 6. For Frames 143T to 365T allow motor to run for 20 to 30 minutes and for Frames 405T and larger allow motor to run for 30 to 60 minutes before replacing hardware. 7. G

ページ3に含まれる内容の要旨

SHEET NO. 3 of 3 Industrial Division / Houston Motor Plant ISSUED 01/24/96 SUPERSEDES NEW Motor Operation Procedure Fig. 3 TYPE OF SERVICE SYNC. RPM FRAME SIZE STANDARD SEVERE VERY SEVERE RANGE DUTY DUTY DUTY 3600 143T-256T 8 Mos. 4 Mos. 1 Mo. 1800 ~ 900 143T-256T 30 Mos. 12 Mos. 4 Mos. Bearing Size Periodic Grease Amount 6205/6206 3 Grams 6207/6208/6305 5 Grams 6306 10 Grams 6308/6309 20 Grams 3600 284T-365T 8 Mos. 4 Mos. 1 Mo. 1800 ~ 900 284T-365T 24 Mos. 12 Mo