ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
For DACOR Built-in Kit Model AOCTK27 or AOCTK30
THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALL OVENS.
PLEASE SEE THE OPERATION MANUAL REGARDING BUILT-IN APPLICATIONS.
IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE OPERATION MANUAL OR THE INSTALLATION INSTRUCTIONS OF THE MICROWAVE OVEN
AS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENE
ページ2に含まれる内容の要旨
STEP 1 CABINET OR WALL OPENING CABINET OR WALL OPENING Figure 1 Provide an opening in the wall or cabinet as indicated on fi gure 1. The depth should be a minimum of 24". The fl oor of the opening should be constructed of plywood strong 5 5" " enough to support the weight of the oven (about 100 lbs.) and should be level for proper operation of the oven. Note: While the proper functioning of the oven does not require that the opening be enclosed (with sides, ceiling and rear partition), t
ページ3に含まれる内容の要旨
Figure 4 Figure 5 SCREW-A DUCT-A3 DUCT-A2 SCREW-A SCREW-A SCREW-A D DU UC CT T- -A A1 1 SCREW-A DUCT-A2 STEP 3 CORD BOX 1. Plug the oven electrical cord into the CORD BOX Figure 6 RECEPTACLE and roll the remaining part of the cord into the CORD BOX as shown in Figure 6-A. 6-A CUSHION-A 2. Remove screw #2 from lower left rear of the oven. Insert right fl ange of the CORD BOX into hold lip of the oven. Using the screw #2 just removed from the oven, secure the CORD BOX to the oven. See Figu
ページ4に含まれる内容の要旨
STEP 5 FRAME INSTALLATION Attach bottom duct with two SCREWS-C. Attach built-in Figure 8 trim kit frame with four SCREWS-B. See fi gure 8. SCREW-B SCREW-C SCREW-B SCREW-B SCREW-C SCREW-B OVER OVEN INSTALLATION OVER WARMING OVEN INSTALLATION T T T T TO O O O OP O P O P O P O P OF F F F F M M M M M M M M MI I I I I I I I IC C C C C C C C CR R R R R R R R RO O O O O O O O OW W W W W W W W WA A A A A A A A AV V V V V V V V VE E E E E E E E E S S S S SH H H H HE E E E EL L L L LF F F F
