ページ1に含まれる内容の要旨
MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before you begin, read these instructions completely and carefully.
Getting Started
■ Remove packaging
Contents Tools Required
Part Description Qty 1/8” Drill
#2 Phillip Screwdriver
Trim Assembly 1
Base 1
Rear Duct 1
Forward Duct 1
Foam Tape 2 ft
Mounting Bracket (L/R) 2
Sheet Metal Screws 14
Before installing trim kit, install the convection duct as follows:
1. Insert the rear section of the duct into the forward section o
ページ2に含まれる内容の要旨
Installing Trim Kit 1. Cut opening in the cabinet face per the following dimensions: Height: 19-3/16” + 1/16”, –0 Width: 25-3/4” + 1/16”, –0 Note: Refer to diagram on the following page. The minimum cabinet depth is 20”. When installing the Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the recommendations in the Microwave Installation/ Use & Care Manual. 2. Add adequate platform base support in the bottom of the cabinet for trim kit base to rest on. Fi
ページ3に含まれる内容の要旨
REAR CABINET CONVECTION DUCT FOAM TAPE ON HORIZONTAL CLIP THIS FLANGE ORIENTATION ON MOUNTING FORWARD BRACKET 25 3/4" +1/16"-0" CONVECTION DUCT 1/8" HOLE FOR FOAM TAPE ON MOUNTING TOP PIN THIS FLANGE SCREW OF TRIM SCREW HOLE FOAM TAPE ON CENTER THIS FLANGE LINE MOUNTING BRACKET SUPPORT INSERT 4 TRIM KIT ASSEMBLY INSERT 1 BASE CABINET CUT-OUT: 19 13/16" +1/16" -0" BOTTOM PIN OF TRIM FLANGE INSERT 2 TRIANGULAR CENTERING TOP SCREW NOTCH HORIZONTAL CLIP ORIENTATION SCREW HOLE ON
ページ4に含まれる内容の要旨
5800 Skylab Road, Huntington Beach, CA 92647 Tel: 714.372.7000 • Fax: 714.372.7001 Customer Service: 888.281.5698 P/N 241185 Rev. A 10/07 www.dcsappliances.com
