ページ1に含まれる内容の要旨
HVN61/81 Induction Hob
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
ページ2に含まれる内容の要旨
Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it,
ページ3に含まれる内容の要旨
• Always use appropriate cookware. • Do not cook unopened tins of food directly on the hob. • Never put cooking foil or plastic materials on the ceramic surface when the hob is hot. These materials could melt and cause damage to the hob. • This hob (Class 3) has been designed for use only as a cooking appliance. Any other use should be considered incorrect and therefore dangerous. FOR THOSE WITH HEART PACEMAKERS OR ACTIVE IMPLANTS: The function of this hob conforms to current electr
ページ4に含まれる内容の要旨
Using your Hob 7 2 3 6 8 4 5 1 Fig.1 HVN61FR Zones: HVN81FR Zones 1. Front left 2.8 kW 180 mm 5. Front left 2.2 kW 160 mm 2. Back left 2.8 kW 180 mm 6. Back left 3.1 kW 210 mm 3. Back right 3.1 kW 210 mm 7. Back right 2.2 kW 160 mm 4. Front right 2.2 kW 160 mm 8. Front right 3.1 kW 210 mm Control panel: 9. Power key 10. Power level keys 11. Direct power key 12. Zone indicator 13. Boost 14. Direct power key 2 15. Tempo function 16. Timer keys 17. Childlock 9
ページ5に含まれる内容の要旨
Using your Hob To switch the zone on • Touch the key for the zone required. The zone display will flash 0 and the hob will beep to confirm the hob is on. Please note: If a power level is not set within five seconds, the zone will switch off automatically. To set the power level • Touch the key to increase the power level from 1 (lowest) to 12 (maximum), and the key to reduce it. • To go straight to 12, touch the key when the zone is switched on. To turn the power off • Touch the key
ページ6に含まれる内容の要旨
Please note: • When the zone display shows PC, the zone will switch off automatically after five seconds if the power level is not set. • The precook time is preset according to the power level selected. • The precook function can only be used for cooking at power levels 6-12. • If you have set the direct power key to a power level below six, touching that key when setting the precook function will set the power level at 6. The timer • The timer allows you to preset the length of time an
ページ7に含まれる内容の要旨
Safety Features The childlock The hob is equipped with a childlock to lock the controls. This can be used when the hob is off or during cooking To set the childlock Touch the key for approximately three seconds until the LED above the childlock key illuminates and the hob beeps to confirm the childlock is switched on. To turn off the childlock Touch the key for approximately three seconds until the LED above the childlock key goes out and the hob beeps twice to confirm the childlock is swit
ページ8に含まれる内容の要旨
Efficient Use of your Hob The hob is equipped with zones of different sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate zone depending on the size of the pan. The most ef- ficient use of the hob is shown below, where the pan and zone are correctly chosen. Use pan lids where possible to minimize the energy usage of your appliance. Fig.2 Zone Size Minimum Pan Size (cm) Maximum Pan Size (cm) 160mm 10 18 180mm
ページ9に含まれる内容の要旨
Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. Important: • Steam cleaners must not be used when cleaning this appliance. • You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. • Sugar and starch can cause permanent damage to the surface of the hob. Wipe away any spillages immediatly. Types of
ページ10に含まれる内容の要旨
Troubleshooting On first use You observe that Possible Causes What should you do? The display shows a series of digits and Nothing, the hob will be ready to use Working normally symbols on first connection within approximately 30 seconds Installation blows a fuse or The electrical connection of the hob Check that it is set up properly (see the only one side of the hob works is incorrect Electrical Connection section) The hob produces an odour during the Heat a saucepan full of water on each N
ページ11に含まれる内容の要旨
Fitting the Hob Unpacking the hob: Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 180mm away from any adja- cent vertical surfaces, e.g. a tall cupboard end panel. This may be reduced to 100mm if the adjacent surface is resistant to fire (tiles or steel, for example). These dimensions are shown in Fig.6. Ventilation requirements: This appliance must be installed to allow air to flo
ページ12に含まれる内容の要旨
ventilation space 40 60 How to install the hob: Overall dimensions of the hob: HVN61FR: Width: 580 mm Depth: 510 mm HVN81FR: Width: 770 mm Depth: 510 mm Worktop cut-out dimensions: HVN61FR: Width: 560 mm Depth: 490 mm HVN81FR: Width: 750 mm Depth: 490 mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.6) shows a 60mm gap from t
ページ13に含まれる内容の要旨
Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13a plug or 13a supply. This appliance is intended to be connected to fixed wiring by a double pole switch, having a contact separation of at least 3mm in all po
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
