Canon Pixma Mg3220 Inkjet Multifunction Printer 6223B002の取扱説明書

ページ1に含まれる内容の要旨

PIXMA MG3200
series
Setup Guide
© CANON INC. 2012

ページ2に含まれる内容の要旨

Setup Guide This guide provides information for setting up a network connection for the printer. Network Connection Wireless Connection Preparation for Connection Printer Setup Connection Using WPS Troubleshooting

ページ3に含まれる内容の要旨

Network Connection Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. • The confi guration, router functions, setup procedures and security settings of the netw

ページ4に含まれる内容の要旨

c Connection Using WPS 1. Press the Fit to Page button (A). 2. Make sure that the LED fl ashes as shown in the illustration above, then press and hold the WPS button on the access point within 2 minutes. For details on pressing the WPS button, refer to the access point manual. The (blue) Wi-Fi lamp on the printer fl ashes while searching for or connecting to the access point. 3. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to "1" as shown in the left

ページ5に含まれる内容の要旨

Troubleshooting WPS  E > 2 > 1 The error appears when wireless connection setup was not completed within 2 minutes after pressing the WPS button. • Is the network device (router, etc.) turned on? If the network device is already turned on, turn it off, then turn it back on.  E > 2 > 3 The screen appears when multiple access points are detected. Wait for a while, then confi gure WPS settings again. Press the WPS button on only one access point.  E > 2 > 4 The screen appears when an error occ