ページ1に含まれる内容の要旨
Operating Instructions
HOB
Contents
GB
Installation, 2-5
Positioning
GB
Gas connection
Data plate
English,1
Burner and nozzle specifications
Electrical connection, 6
Description of the appliance, 7
Overall view
Start-up and use, 8
Practical advice on using the burners
Precautions and tips, 9
General safety
Disposal
G640N
Recycling & Disposal Information
G640T
G640W
Maintenance and care, 10
G640X
Switching the appliance off
Cleaning the appliance
Gas tap maintenance
Troubleshooting, 11
After Sale
ページ2に含まれる内容の要旨
Installation ! Before operating your new appliance please read this also be equipped with vents to allow gas to escape in the GB instruction booklet carefully. It contains important information event of a leak. As a result LPG cylinders, whether for safe use, installation and care of the appliance. partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level ! Please keep these operating instructions for future (cellars, etc.). It is advisab
ページ3に含まれる内容の要旨
45 mm. Front with the values indicated in Table 1 (Burner and nozzle GB specifications). This will ensure the safe operation and longevity of your appliance while maintaining efficient energy consumption. Connection with a rigid pipe (copper or steel) ! Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order Hooking po
ページ4に含まれる内容の要旨
Setting the burners to minimum: ! If the appliance is connected to liquid gas, the regulation GB screw must be fastened as tightly as possible. 1. Turn the tap to the low flame position. 2. Remove the knob and adjust ! Once this procedure is finished, replace the old rating the adjustment screw, which is sticker with one indicating the new type of gas used. positioned in or next to the tap pin, Stickers are available from any of our Service Centres. until the flame is small but steady. ! Shoul
ページ5に含まれる内容の要旨
Burner and nozzle specifications GB Table 1 Liquid Gas Natural Gas Burner Diameter Thermal power By-Pass Nozzle Flow* Nozzle Flow* (mm) kW (p.c.s.*) 1/100 1/100 g/h 1/100 l/h Nomin. Ridot. (mm) (mm) *** ** (mm) Fast (R) 100 3,00 0,70 41 87 218 214 128 286 Semi Fast (S) 75 1,90 0,40 30 70 138 136 104 181 Auxiliary (A) 51 1,00 0,40 30 52 73 71 76 95 Nominal (mbar) 28-30 37 20 Supply Minimum (mbar) 20 25 17 Pressures Maximum (mbar) 35 45 25 * At 15°C and 1013 mbar - dry gas ** Propane P.C.S. = 50.3
ページ6に含まれる内容の要旨
Electrical Connection ! THIS APPLIANCE MUST BE EARTHED. ! The wires in the mains lead are coloured in GB The hob is designed to work with alternating current, accordance with the following code: the supply voltage and frequency indicated on the Green & Yellow - Earth rating plate (situated under the hob). Make sure that Blue - Neutral the local supply voltage corresponds to the voltage Brown - Live indicated on the rating plate. As the colours of the wires in the mains lead may not correspond wi
ページ7に含まれる内容の要旨
Description of the appliance Overall view GB GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS Ignition for GAS BURNERS* GAS BURNER ignition enables a specific burner to GAS BURNERS differ in size and power. Use the be lit automatically. diameter of the cookware to choose the most appropriate burner to cook with. Control Knobs for GAS BURNERS adjust the power or the size of the flame. Only available on certain models. * 7
ページ8に含まれる内容の要旨
Start-up and use ! The position of the corresponding gas burner or Practical advice on using the burners GB electric hotplate* is shown on every knob. To ensure the burners operate efficiently: Gas burners Each burner can be adjusted to one of the following Use appropriate cookware for each burner (see settings using the corresponding control knob: table) so that the flames do not extend beyond the bottom of the cookware. Off Always use cookware with a flat base and a cover. Maximum When
ページ9に含まれる内容の要旨
Precautions and tips ! This appliance has been designed and Always make sure that pan handles are turned GB manufactured in compliance with international safety towards the centre of the hob in order to avoid standards. The following warnings are provided for accidental burns. safety reasons and must be read carefully. Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot. General safety Do not use unstable or deformed pans. This is a class 3
ページ10に含まれる内容の要旨
Maintenance and care Switching the appliance off Gas tap maintenance GB Disconnect your appliance from the electricity supply Over time, the taps may become jammed or difficult to before carrying out any work on it. turn. If this happens, the tap must be replaced. ! This procedure must be performed by a qualified Cleaning the appliance technician authorised by the manufacturer. ! Do not use abrasive or corrosive detergents such as stain removers, anti-rust products, powder detergents or sponges
ページ11に含まれる内容の要旨
Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for GB assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. Problem Possible causes/Solution The burner does not light or the flame is not The gas holes on the burner are clogged. even around the burner. All the movable parts that ma
ページ12に含まれる内容の要旨
After Sales Service GB No one is better placed to care for your Hotpoint appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1100 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08709 066 066 Republic of Ireland: 0818 313 413 www.hotpointservice.co.uk Please note: Our advisors will req
ページ13に含まれる内容の要旨
Guarantee GB 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturers guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you. This guarantee is subject to the following conditions: - The applianc
ページ14に含まれる内容の要旨
Notes GB 14
ページ15に含まれる内容の要旨
GB 15
ページ16に含まれる内容の要旨
Notes 10/2005 - 195053326.01 XEROX BUSINESS SERVICES GB 16
