ページ1に含まれる内容の要旨
PIXMA PRO-10
series
PIXMA PRO-100
series
Setup Guide
© CANON INC. 2012
ページ2に含まれる内容の要旨
Setup Guide This guide provides information for setting up a network connection for the printer. Network Connection Wireless Connection Preparation for Connection Connection Using WPS Wired Connection Preparation for Connection Cable Connection Printer Setup Troubleshooting
ページ3に含まれる内容の要旨
Network Connection Wireless Connection a Preparation for Connection Before Starting Wireless Connection Setup 1. Make sure that the printer is turned on. If the power is on, the POWER lamp (A) will be lit. Notes on Wireless Connection • Make sure that the computer is connected to the access point (A) (or wireless network router) you want to connect your printer to. • The confi guration, router functions, setup procedures and security settings of the network device vary depending on your system
ページ4に含まれる内容の要旨
b Connection Using WPS 1. Press and hold the Wi-Fi button (A) on the printer when you are ready to press the button on the access point. 2. Make sure that the (blue) Wi-Fi lamp fl ashes quickly and the POWER lamp is lit as shown in the illustration above, then press and hold the button on the access point within 2 minutes. 3. Make sure that the (blue) Wi-Fi lamp and POWER lamp are lit. The network connection setup is now complete.
ページ5に含まれる内容の要旨
Wired Connection a Preparation for Connection Before Starting Wired Connection Setup 1. Make sure that the printer is turned on. If the power is on, the POWER lamp (A) will be lit. Notes on Wired Connection • Make sure that the computer and router (A) (or access point) are connected. • The confi guration, router functions, setup procedures and security settings of the network device vary depending on your system environment. For details, refer to the manual of your network device or contact its
ページ6に含まれる内容の要旨
2. Connect the printer and a network device (router, etc.) with an Ethernet cable (A). Please make sure to use the correct port on the back of the printer. Do not connect it to the USB port. c Printer Setup 1. Hold down the RESUME/CANCEL button (A) on the printer until the POWER lamp fl ashes 11 times, then release the RESUME/CANCEL button after the eleventh fl ash. The wired connection setup is complete. The network connection setup is now complete.
ページ7に含まれる内容の要旨
Troubleshooting WPS When the (blue) Wi-Fi lamp fl ashes slowly and the (orange) Alarm lamp is lit: • Press the button on only one access point. • Check the security settings of the access point. After checking the above points, wait for a while and confi gure wireless connection setting again. For details on how to check the security settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. When the (blue) Wi-Fi lamp fl ashes quickly and the
