Summary of the content on the page No. 1
5
Cordless
GHz8 Phone
chg/
in use
PAGE
OWNER'S MANUAL
5.8 GHz Cordless Telephone
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
Model : STC580
GHz8
In Use
Low Batt.
PAUSE
DEF
1 3
MNO
5
TU WXY
V
7 8 9
OPER
REDIAL
VOL
CH MUTE
MEMO FLASH
TALK
ABC
2
GHI JKL
4 6
PRS
0 #
*
5
Summary of the content on the page No. 2
Contents Safety Instructions..................................................................................................... 2 Handset Controls....................................... .............................................................. 4 Base unit Controls.................................................................................................... 6 Getting Started........................................................................................................... 7 C
Summary of the content on the page No. 3
Safety Instructions IMPORTANT SAFETY INSTRUCTIONS To reduce the risk of fire, electric shock and/or injury, always follow these basic safety precautions when using your cordless telephone equipment. 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the telephone. 3. Do not use this telephone near a bathtub, wash bowl, kitchen sink, or laundry tub, in a wet basement, near a swimming pool, or anywhere else where there is water. 4. Avoid using a telephone (o
Summary of the content on the page No. 4
Safety Instructions D. If the telephone does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions. Improper adjustment may require extensive work by a qualified technician to restore the telephone to normal operation. E. If the telephone has been dropped or the case has been damaged. F. If the telephone exhibits a distinct change in performance. 16. Never install telephone wiring during a lightning storm. 17. Neve
Summary of the content on the page No. 5
HANDSET Controls 8. ANTENNA 5 GHz8 1. REDIAL/ PAUSE BUTTON 9. IN USE/LOW BATT. In Use Low Batt. LED INDICATOR 2. VOL (VOLUME) REDIAL PAUSE BUTTON VOL 3. CH (CHANNEL) CH MUTE 10. MUTE BUTTON BUTTON MEMO FLASH TALK 4. MEMO BUTTON 11. FLASH BUTTON ABC DEF 1 2 3 GHI JKL MNO 12. TALK BUTTON 5. HEADSET JACK 4 5 6 WXY PRS TUV 9 7 8 13. RINGER ON/OFF OPER SWITCH 6. TEMPORARY TONE 0 # * BUTTON 7. MICROPHONE 14. CHARGE CONTACTS 4
Summary of the content on the page No. 6
HANDSET Controls 1. REDIAL/PAUSE Button: (REDIAL) Press to REDIAL the last number you called. (PAUSE) Press to insert a PAUSE while dialing. (You will need the PAUSE button to dial numbers which use an alternative Long Distance Access Code.) 2. VOL (VOLUME) Button: During a call, press the (+) button to increase the receiver volume level from LOW, MEDIUM, HIGH, or MAXIMUM. Press the (-) button to decrease the receiver volume level. 3. CH (CHANNEL) Button: Press to change the operating channel
Summary of the content on the page No. 7
BASE UNIT Controls 1. POWER-IN CONNECTION JACK (LOCATED AT THE BOTTOM SIDE) 2. TELEPHONE LINE CONNECTION JACK (LOCATED AT THE BOTTOM SIDE) 5 Cordless GHz 8 Phone 3. BASE UNIT ANTENNA PAGE 4. PAGE BUTTON 5. CHARGE TERMINALS 6. TONE/PULSE SELECT SWITCH LOCATED AT THE LEFT SIDE) chg/ in use 7. CHARGE/IN USE LED INDICATOR BASE UNIT Controls 1. POWER-IN CONNECTION JACK 2. TELEPHONE LINE CONNECTION JACK 3. BASE UNIT ANTENNA 4. PAGE Button: Press to page the HANDSET. 5. CHARGE TERMINA
Summary of the content on the page No. 8
Getting Started Connecting Your Phone This section is a reference guide to the basic functions and operations of your cordless telephone. For more detailed descriptions of the operations and features of this telephone, refer to the Contents on page 1. 1. Carefully remove your cordless telephone from its shipping carton. If there is any visible damage, do not attempt to operate this equipment. Return it to the place of purchase. 2. Check to be sure you have all items that come with this cordless
Summary of the content on the page No. 9
Getting Started 7. Install the HANDSET BATTERY PACK by plugging it into the BATTERY CONNECTOR inside the BATTERY COMPARMENT. 8. Place the BATTERY PACK inside the BATTERY COMPARTMENT. BATTERY PACK 9. Slide the HANDSET BATTERY COMPARTMENT COVER firmly into place in its closed position. 10. IMPORTANT: Before initial use, charge the HANDSET for 12 hours. Place the HANDSET on the BASE UNIT and BATTERY make sure that the CHARGE LED COMPARTMENT indicator on the BASE UNIT lights COVER up and a “beep” c
Summary of the content on the page No. 10
Cordless Telephone Operation Preparing for Use 1. Place the HANDSET on the BASE UNIT for 12 hours. 2. After 12 hours, remove the HANDSET from the BASE UNIT. Before you can use your cordless telephone, you must charge the HANDSET for 12 hours. Failure to do so will require more frequent charging of the BATTERY PACK. NOTE: Depending on the frequency of use, once the HANDSET is fully charged, it remains func-tional for approximately 6 hours of continuous use and approximately 6 days when the HANDSE
Summary of the content on the page No. 11
Cordless Telephone Operation Receiving Calls with the HANDSET on the BASE UNIT 1. When the phone rings, lift the HANDSET. The IN USE LED indicator will light up. NOTE: The HANDSET RINGER ON/OFF switch must be in the “ON” position for In Use Low Batt. ringer to operate. 2. Start your conversation. REDIAL PAUSE 3. To end your conversation, either press the VOL CH MUTE TALK button or place the HANDSET on the BASE UNIT. If you place the HANDSET MEMO FLASH on the BASE UNIT CHARGE CRADLE, you TALK
Summary of the content on the page No. 12
Cordless Telephone Operation EXAMPLE : To store the number 115-1968 under the TELEPHONE KEYPAD 1 button: 1 - Press the MEMO button. 4 - Press the TELEPHONE KEYPAD 1 button. 2 - Dial 115-1968. 5 - You have stored 115-1968 under TELEPHONE KEYPAD 1 button. 3 - Press the MEMO button again. A total of 10 telephone numbers can be programmed in memory. IMPORTANT: The maximum number of digits that can be stored for any phone number is 16 in PULSE or TONE mode. The maximum number of digits for
Summary of the content on the page No. 13
Cordless Telephone Operation Mute Function 1. While you are having a phone conversation, press the MUTE button. In Use Low Batt. The microphone will be muted and the other party will not hear any voice/ REDIAL PAUSE talking from your end. VOL CH MUTE 2. Press the MUTE button again to 1, 2 continue your phone coversation with MEMO FLASH the other party. TALK Using the Headset Feature Your telephone can utilize a headset (not included) to be connected to your HEADSET HANDSET for you to enjo
Summary of the content on the page No. 14
Security System Security System Your cordless telephone uses a digital coding security system to prevent unauthorized use of your telephone line by another nearby cordless telephone. The system has its own identifying signal created by microcomputers in both the BASE UNIT and the HANDSET. Security Code This telephone has an internal security code with 65,536 possible combinations. Resetting Security Code and Channel Information Communication between the HANDSET and the BASE UNIT may not be possi
Summary of the content on the page No. 15
Recharging the BATTERY PACK Recharging the BATTERY PACK The nickel metal hydride (Ni-MH) BATTERY PACK in the HANDSET can be recharged many times using the built-in charger in the BASE UNIT. When the BATT LOW LED indicator starts to blink rapidly, a “beep”sound will be heard every 12 seconds. This indicates that the BATTERY PACK needs to be recharged. Charge the BATTERY PACK at least once every 90 days of non-use to avoid battery failure. When the BATTERY PACK can no longer be charged, replacemen
Summary of the content on the page No. 16
Problem Solving Problem Solving Section For your assistance, we have listed below a few common problems. Phone does not work, check the following: 1. BASE UNIT is plugged into a power source. 2. HANDSET is charged. 3. TONE/PULSE Select Switch is in the right position. 4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK. Range of phone limited, check the following: 1. BASE UNIT is centrally located in your residence. 2. BASE UNIT is not located near appliances. No dial tone, check the follo
Summary of the content on the page No. 17
Technical Information Technical Information This cordless telephone uses radio frequencies to allow mobility. There are certain difficulties in using radio frequencies with a cordless telephone. While these are normal, the following could affect the operation of your system. Noise Electrical pulse noise is present in most homes at one time or another. This noise is most intense during electrical storms. Certain kinds of electrical equipment such as light dimmers, fluorescent bulbs, motors, and f
Summary of the content on the page No. 18
FCC Requirements FCC NOTICE The FCC requires that you be advised of certain requirements involving the use of this telephone. 1. This telephone is hearing aid compatible. 2. This equipment complies with Part 68 of the FCC Rules. A label on the BASE UNIT of this equipment contains, among other information, the ACTA Product Number and the Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company. 3. The REN is also useful in
Summary of the content on the page No. 19
FCC Requirements RINGER EQUIVALENCE NUMBER NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the ringer equivalence numbers of all devices does not exceed 5. CAUTION: Users should not attempt to make such connections themselves, but should con
Summary of the content on the page No. 20
FCC Requirements NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no gu
