Summary of the content on the page No. 1
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page a
WDECT
2300
Wide Band Digital
Technology provides
the clearest sound
and the best privacy.
Quick Start
Guide
Summary of the content on the page No. 2
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page i INSTALLATION & SAFETY Choosing the best location for your phone. When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. AVOID - CHARGE - Television sets and AVOID - the new phone other electronic Moisture for 15 - 20 hrs. appliances AVOID - Microwave ovens • This symbol AVOID - indicates important moisture operating and servicing instructions. Don’t - AVOID - over
Summary of the content on the page No. 3
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page ii QUICK START GUIDE This page is a very condensed version of the Owner’s Start Manual. It is designed to allow you to get your phone installed and operating as quickly as possible - Here! however it does not attempt to explain any of the advanced features of the WDECT2300 series. Installing the Base Unit Route the cord. 1) Connect the AC adapter to the DC IN 9V jack and to a standard AC wall outlet. AC adapter (supplied) To AC outlet To DC IN
Summary of the content on the page No. 4
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page iii 3) Set the base on a desk or tabletop. Installing the battery pack 1) Press down on the battery cover release and slide the cover down until it comes off. • Charge the handset battery pack for at least 15-20 hours before using your new cordless 2) Connect the battery plug to the socket at the rear of the telephone for the battery compartment. The RED and BLACK battery wires first time. must match the RED and BLACK dots on the phone case for
Summary of the content on the page No. 5
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page iv Charging the handset 1) Place the handset in the base unit with the keypad facing forward. Recharge your phone on a regular basis by returning the handset to the base after each phone call. 2) Make sure the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and that the handset makes good contact with the base charging contacts. • After installing the batteries in the handset, charge your h
Summary of the content on the page No. 6
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page v CONTENTS INSTALLATION & SAFETY i Flash and Call Waiting 22 Using One Touch Voice Mail Access 23 QUICK START GUIDE ii PHONEBOOK 24 CONTENTS v Phonebook 24 GETTING STARTED 1 Storing Phone Numbers, Names, Controls and Functions 1 Distinctive Rings, and Speed Dial 24 Uniden Company Philosophy 3 Steps for Entering Names and Special Characters 26 Welcome 3 Viewing the Phonebook 28 Features 3 Making Calls Using the Phonebook 29 Checking the Package
Summary of the content on the page No. 7
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 1 CONTROLS AND FUNCTIONS 1. Handset Antenna 2. Headset Jack Cover 3. Beltclip Hole 4. Hands-Free Speaker 1 5. Handset Battery Compartment 6 6. New Message LED 2 7 7. Handset Earpiece 8. LCD Display 3 9. /del Key 4 10. /vol/ / Key 8 a. ringer volume control 14 b. scroll keys for display screen 9 15 11. Key 10 16 12. redial/pause Key 17 13. speaker Key 5 14. Key 15. Key 11 18 16. Key 12 19 17. Key 13 20 18. Key 21 19. phonebook Key 22 20. /transf
Summary of the content on the page No. 8
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 2 Base 23 24 25 26 27 28 27. TEL LINE Jack 23. Base Antenna 28. DC IN 9V Jack 24. Base Charging Contacts 25. charge LED 26. Key [ 2 ]
Summary of the content on the page No. 9
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 3 UNIDEN COMPANY PHILOSOPHY To bring outstanding wireless communication products to people’s lives throughout the world. WELCOME Congratulations on your purchase of this Uniden cordless telephone. This is designed for reliability, long life and outstanding performance utilising the latest in 2.4GHz Digital Spread Spectrum Technology. Note: The illustrations in this manual are intended as a guide and may differ from actual unit. FEATURES Great f
Summary of the content on the page No. 10
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 4 CHECKING THE PACKAGE CONTENTS Make sure you have received the following items in the package. If any of these items are missing or damaged, contact your retailer. • Base unit (1) • Handset (1) • AC adapter (1) • Rechargeable battery pack (1) • Linecord (1) Also included: • This Owner’s Manual • Other Printed Material TERMINOLOGY Throughout this manual, terms such as Standby and Talk Mode are used. Below is the terminology explanation. Standby
Summary of the content on the page No. 11
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 5 MOUNTING THE BASE UNIT ON A WALL You can mount your base directly to the wall. Before doing this, consider the following: • Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. • Mount your phone within distance of a working phone jack. • Make sure the wall material is capable of supporting the weight of the base and handset. • Use screws with anchoring devi
Summary of the content on the page No. 12
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 6 BATTERY MAINTENANCE Battery use time (per charge) Fully charged • Up to 7 hours continuous use. • Up to 10 days when the handset is in the standby mode. Recharge your phone on a regular basis by returning the handset to the base after each phone call. Low battery alert When the batteries are very low and need to be charged, the phone is programmed to eliminate functions in order to save power. The batteries need to be charged when: - The emp
Summary of the content on the page No. 13
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 7 Battery replacement and handling When the operating time becomes short, even after a battery is recharged, please replace the battery. With normal usage, your battery should last about one year. Please contact your place of purchase or the Uniden Parts Department for a replacement battery. Caution • Use only the specified Uniden battery pack (BT-446). • Do not remove the batteries from the handset to charge them. • Never throw the battery int
Summary of the content on the page No. 14
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 8 HEADSET INSTALLATION Your phone may be used with an optional headset, the Uniden HS910. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. Headset is available through Uniden authorized retailers. DISPLAY AND ICONS Example of the standby mode display SUN 12:00A Day of the week and time / battery icon Handset #1 Handset ID and Banner New: 5 :OFF Number of new Caller
Summary of the content on the page No. 15
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 9 ABOUT THE MENU OPTIONS There are 3 main menu options, (Handset Setup, Global Setup and System Reset) and submenu options. • During Global Setup Summary of the Main Menu and Submenu and System Reset, make sure your cordless phone is in Handset Setup standby mode (not Submenu name Description in use), and the handset is within Edit Voice Mail Program or delete the voice mail access number (see page 11). range of the main Ringer Tones Adjusting
Summary of the content on the page No. 16
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 10 Global Setup Submenu name Description Day & time Set the day and time of your display (see page 14). Name Tag (POP ID) Display the stored name with the Caller ID telephone number, if the displayed (Default is on) Caller ID telephone number is exactly the same as a number stored in the phone book (see page 14). Insert 0 Add “0” or “00” to the number, when you receive the Caller ID message (New Zealand only) (see page 14). Dial Mode Set the
Summary of the content on the page No. 17
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 11 SETTING UP THE MENU Entering the Menu 1) Press the /del key in standby mode. DirectLink Mode 2) Use /vol/ or /vol/ to move the pointer to • To back to the a desired main menu (DirectLink Mode, Room Monitor, Room Monitor previous screen, press /del. Handset Setup, Global Setup, and System Reset). Handset Setup 3) Press to select the desired main menu. • Direct Link, Room Monitor, and Copy 4) Use /vol/ or /vol/ to select a desired submenu, and
Summary of the content on the page No. 18
UP349BH (WDECT2300) ENG OM 5/12/04 10:52 AM Page 12 Selecting a Ringer Tone 1) Enter the Handset Setup menu, and then the Ringer Ringer Tones Tones submenu (see “Entering the Menu” on page 11). Flicker There are 10 ringer tones or 10 Polyphonic Tones to Clatter choose from. - Ringers [Flicker, Clatter, Soft Alert, Wake Up, Light Bug, Beep Boop, Tone Board, Chip Chop, Party Clap, Reminder] - Polyphonic Tones [Beethoven’s Symphony #9 (Beethoven9), For Elise (Elise), We Wish You A Merry Chri
Summary of the content on the page No. 19
UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 13 Setting the Anykey Answer 1) Enter the Handset Setup menu, and then the Anykey Anykey Answer Answer submenu (see “Entering the Menu” on page 11). On 2) Press /vol/ or /vol/ to select On or Off. Off 3) Press . You will hear a confirmation tone. Setting the True Banner 1) Enter the Handset Setup menu, and then the Banner Banner submenu (see “Entering the Menu” on page 11). _________ #1 2) Use the number keypad (0-9), , , or /del to en
Summary of the content on the page No. 20
UP349BH (WDECT2300) ENG OM 5/12/04 10:53 AM Page 14 Global Setup Setting Name Tag (POP ID) 1) Enter the Global Setup menu, and then the Name Tag submenu (see “Entering the Menu” on page 11). 2) Press /vol/ or /vol/ to change the selection, On or Off. 3) Press . You will hear a confirmation tone. Setting Insert Zero (New Zealand only) 1) Enter the Global Setup menu, and then the Insert 0 submenu (see “Entering the Menu” on page 11). 2) Press /vol/ or /vol/ to change the selection, On or Off. 3
