Summary of the content on the page No. 1
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION
27 ” Digital / Analog
Television
Owner’s Manual
CR270TT8
TO RECEIVE DIGITAL/ANALOG SIGNAL,
YOU MUST CONNECT ANTENNA.
IF YOU NEED ADDITIONAL ASSISTANCE WITH SETUP OR OPERATING AFTER
READING OWNER’S MANUAL, PLEASE CALL TOLL FREE 1-800-844-5001.
L4758UJ_EN.indd 1 L4758UJ_EN.indd 1 2 2006/12/11 22:06:48 006/12/11 22:06:48
Summary of the content on the page No. 2
NTRODUCTION I WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A RISK OF ELECTRIC RISK OF ELECTRIC SHOCK SHOCK IS PRESENT WITHIN THIS UNIT. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS SYMBOL INDICATES THAT THERE ARE DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE IMPORTANT OPERATING AND MAINTENANCE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVI
Summary of the content on the page No. 3
WATCHING TV INFORMATION INTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTING TROUBLESHOOTING 15. POWER LINES - An outside antenna system should not be located c. If the TV has been exposed to rain or water. in the vicinity of overhead power lines or other electric light of d. If the TV does not operate normally by following the operating power circuits, or where it can fall into such power lines or circuits. instructions. Adjust only those controls that are covered by the When instal
Summary of the content on the page No. 4
NTRODUCTION I LOCATION For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation: • Shield it from direct sunlight and keep it away from sources of intense heat. • Avoid dusty or humid places. • Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes. • Ins
Summary of the content on the page No. 5
WATCHING TV INFORMATION INTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTING TROUBLESHOOTING Features Contents • DTV/TV/CATV INTRODUCTION - Y ou can use your remote control to select channels Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 which are broadcast in digital, conventional analog, Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Supplied A
Summary of the content on the page No. 6
NTRODUCTION I Remote Control Function 1. POWER button (p10) 7. DVT/TV button (p12) Press to turn the unit on and off. P ress to switch between the digital 2. Number buttons (p12) mode (DTV) and analog (TV) POWER DTV/ TV • Press to select channels. mode. 1 7 AUDIO INFO -/ENT button 8. INFO button (p13) 8 • Press to shift the minor channel Digital Mode (DTV) 9 1 2 3 from the major channel. • Press to display the channel +100 button number and the program 4 5 6 2 • Press to sel
Summary of the content on the page No. 7
WATCHING TV INFORMATION INTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTING TROUBLESHOOTING Control Panel 1. Infrared Sensor Window Receives infrared rays transmitted from the remote control. 2. POWER button (p10) Press to turn the unit on and off. K L 3. CHANNEL / buttons (p11) Press to select channels or move up/down through the main menu items. X Y 4. VOLUME / buttons (p12) Press to adjust the volume or move right(X)/left(Y) through the main menu items. 5. MENU button (p10)
Summary of the content on the page No. 8
ONNECTION C Cables not included. Please purchase the necessary cables at your local store. Basic Connection This section describes how to connect the unit to an antenna, cable/satellite box, etc. Note: • Be sure your antenna or other device is connected properly before plugging in the power cord. [Antenna Cable Connection] When connecting the unit to an antenna or cable TV company (without cable/satellite box) Connect the RF coaxial cable on your home outlet to the antenna input jack of this
Summary of the content on the page No. 9
INTRODUCTION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION CONNECTION Cables not included. Please purchase the necessary cables at your local store. External Device Connection [Component Connection] This is the best method to connect this TV to video devices with the component output jack, such as DVD player, etc. It can minimize the deterioration of image quality. Use the component cable for connection. component video cable e.g.) rear of this unit COMPONENT VIDEO O
Summary of the content on the page No. 10
NITIAL SETTING I These operations are accessible by remote control. Some may also be accessible by controls on the main unit. Initial Setup K L This section will guide you through the unit’s initial setting which includes Use [CH / ] to select “AUTO PRESET CH(TV/DTV)” 5 selecting a language for your on-screen menu and “AUTO PRESET CH”, which for TV channels or “AUTO PRESET CH(CATV)“ for CATV automatically scans and memorizes viewable channels. X channels, then press [VOL ]. Before you begin:
Summary of the content on the page No. 11
INTRODUCTION CONNECTION WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION INITIAL SETTING • ENG/ESP/FRA • When aerial ant enna is connected, select “AUTO Y ou can change the language (English, Spanish, PRESET CH (TV)”, “AUTO PRESET CH (DTV)” or “AUTO French) displayed on the main menu. PRESET CH (TV/DTV)”. (Refer to “Language Selection” on page 11.) • When c onnected to CATV, select “AUTO PRESET CH (CATV)”. • V-CHIP SET UP • Auto scanning begins. You can set the viewing limitat
Summary of the content on the page No. 12
ATCHING TV W Channel Selection Volume Adjustment Select channels by pressing [CH K /L] or [the Number buttons]. This section describes how to adjust the volume. The mute function, which turns the sound off and on, is also described. • T o select the memorized channels, Use [VOL X/Y] to adjust the audio volume. use [CH K/L] or [the Number buttons]. • To select the non-memorized channels use [the Number buttons]. To Use [the Number buttons] VOL or VOL TV VOLUME - When selecting analog
Summary of the content on the page No. 13
INTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTING TROUBLESHOOTING INFORMATION WATCHING TV Accessing External Devices Screen Information Use your remote control to access an external device when they are You can display the currently selected channel or other information such as connected to the unit. the audio mode on the TV screen. TV Press [INPUT SELECT] repeatedly to cycle through In the analog mode, the current channel number is displayed. analog TV, digital TV, VIDEO1 and VIDEO
Summary of the content on the page No. 14
ATCHING TV W DTV TV Screen Display Mode In the digital mode, the detailed broad casting information for the current 2 types of display modes can be selected in the digital mode. channel such as program title, the program guides are displayed. DTV Press [INFO] repeatedly to cycle through the available display modes. Press [MENU] to display the main menu. 1 [OFF] INFO INFO MENU [BROADCASTING INFORMATION] Use [CH K /L] to select “DTV SET UP”, then press 2 [PROGRAM GUIDE] [VOL X]. e.g.) dig
Summary of the content on the page No. 15
INTRODUCTION CONNECTION INITIAL SETTING OPTIONAL SETTING TROUBLESHOOTING INFORMATION WATCHING TV Sleep Timer The sleep timer can be set to automatically turn off the unit after an incremental period of time. Press [SLEEP] to set the sleep timer. 1 SLEEP SLEEP 0 • Sleep timer display appears on the TV screen. Press [SLEEP] repeatedly to change the amount of 2 time until shut off. SLEEP SLEEP 90 • You can set the unit to turn off after a set period of time (from 10 to 90 minutes).
Summary of the content on the page No. 16
PTIONAL SETTING O Channel Add/Delete The channel add/delete function lets you add the channel that was not Press [MENU] to exit. 6 added by the auto channel scan due to the reception status at the initial setting. You can also delete the unnecessary channels. MENU Press [MENU] to display the main menu. 1 Note: • The main menu will disappear automatically in about 10 seconds. MENU • In the digital mode (DTV), you can add or delete channels only for major channel. • Once you delete a DTV
Summary of the content on the page No. 17
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV TROUBLESHOOTING INFORMATION OPTIONAL SETTING Picture Adjustment Closed Caption You can adjust brightness, contrast, color, tint and sharpness. You can view closed captioning (cc) for TV programs, movies and news. Closed caption refer to text of dialogue or descriptions displayed on-screen for the hearing impaired. Press [MENU] to display the main menu. 1 Press [MENU] to display the main menu. 1 MENU MENU Use [CH K /L] to select “PICTURE”, t
Summary of the content on the page No. 18
PTIONAL SETTING O DTV Closed Caption Press [MENU] to exit. DTV 3 In addition to the basic closed caption described on page 17, DTV has its own closed caption called DTVCC. Use this menu to change the settings for MENU DTVCC. Note: Press [MENU] to display the main menu. 1 • To show the closed caption on your TV screen, broadcast signal must contain the closed caption data. • Not all TV programs and commercials have the closed MENU caption or all types of the closed caption. • Captions
Summary of the content on the page No. 19
INTRODUCTION CONNECTION INITIAL SETTING WATCHING TV TROUBLESHOOTING INFORMATION OPTIONAL SETTING [CAPTION SERVICE] [FONT STYLE] Font style of the displayed caption can be switched as below. [OFF] [STYLE1/8] [SERVICE1/6] [STYLE2/8] [SERVICE2/6] [STYLE3/8] [SERVICE3/6] VOL or VOL [STYLE4/8] VOL or VOL [SERVICE4/6] [STYLE5/8] [SERVICE5/6] [STYLE6/8] [STYLE7/8] [SERVICE6/6] [STYLE8/8] OFF: Select if you do not want DTVCC. This is the default. SERVICE 1 to SERVICE 6: Select one of these be
Summary of the content on the page No. 20
PTIONAL SETTING O [FORE COLOR] V-chip Font color of the displayed caption can be switched as V-chip reads the ratings for programs, then denies access to the programs below. which exceed the rating level you set. With this function, you can block certain programming inappropriate for children. [TRANSPARENT] Press [MENU] to display the main menu. [WHITE] 1 [BLACK] MENU [RED] Use [CH K /L] to select “V-CHIP SET UP“, [GREEN] 2 VOL or VOL then press [VOL X]. [BLUE] e.g.) digital TV mode
