Summary of the content on the page No. 1
Owner’s Manual
Please read and fully understand this manual before
operating your NEWPORT 9000.
Summary of the content on the page No. 2
TM Advanced PureAir Newport 9000 Owner’s Manual SAFETY OPERATION Please exercise caution when using the Newport 9000 or any other electrical device! This manual describes the safety precautions which should be observed in relation to your air purifier. Please review carefully BEFORE using the product. SPECIAL ATTENTION The voltage rating for air purifiers sold in the To prevent the possibility of electrical shock USA, Japan and Canada is AC100-120V, or short-circuiting your air purifier, Do NOT
Summary of the content on the page No. 3
TM Advanced PureAir Newport 9000 Owner’s Manual CONTROLS & AIR FLOW VENTS Front Face Plate Air Outlet Dust Sensor Air Inlets Air Inlets Front Panel Release Tabs Bottom Stand Soft Touch Control Panel Remote Control Odor Sensor ON/OFF FLOW AUTO ION UV TIMER 2
Summary of the content on the page No. 4
TM Advanced PureAir Newport 9000 Owner’s Manual MAJOR COMPONENTS Back View Exploded Parts View 3
Summary of the content on the page No. 5
TM Advanced PureAir Newport 9000 Owner’s Manual BEFORE USE Pre-Installation Air Ventilation Open Windows for Air Ventilation Before plugging in the unit, please open the windows in the area where you will be using the unit. Ventilate the area for 2-3 hours if possible. Once the area has been ventilated, close the windows and plug in the unit. After plugging in, the unit sensor will sample the air and retain a memory of the existing indoor air condition. (The existing indoor air condition will be
Summary of the content on the page No. 6
TM Advanced PureAir Newport 9000 Owner’s Manual EXPLANATION OF INDICATORS Negative Ion Indicator During the process when negative ions are generated, the blue indicator on the Soft Touch Control Panel will gradually change from bright to dim and from dim back to bright every 5seconds. Odor Indicator The odor indicator on the Soft Touch Control Panel will glow whenever the odor sensor detects odor (such as indoor smoke). Dust and Irritant Indicator The dust-and-irritant indicator on the Soft Touc
Summary of the content on the page No. 7
TM Advanced PureAir Newport 9000 Owner’s Manual OPERATING INSTRUCTIONS Locate the Unit Place the Newport 9000 against a wall, near an electric outlet with 12-15 inches clearance on the front and sides. It is best to place the unit where it will be out of any children's play area. How to Start Plug the unit into a standard 120V/60Hz outlet. Press the POWER ON/OFF button. The device starts operating automatically and the negative-ion UV indicator will automatically turn on. Press POWER ON/OFF agai
Summary of the content on the page No. 8
TM Advanced PureAir Newport 9000 Owner’s Manual CLEANING AND MAINTENANCE Before starting any cleaning or maintenance, always turn-off and unplug the unit. Regular cleaning and maintenance is recommended every 2-3 months. Disassembling the Newport 9000 After unplugging, carefully lay the unit down face-up. Disassemble the unit in sequence of 1 to 5 as shown below. (Put the unit back together in the reverse 5 to 1 sequence.) 3. Remove the Washable Plasma Dust Filter 1. Remove the Front Face Plate
Summary of the content on the page No. 9
TM Advanced PureAir Newport 9000 Owner’s Manual ( ) CLEANING AND MAINTENANCE CONT. Regular Cleaning and Maintenance Unit Body Front Face Plate For Instructions regarding the disassembly of the Can be cleaned with flowing water face plate and filters refer to Please use a soft cloth to clean and avoid scraping page 7. off the paint on the cover Take down UV lamp before cleaning Avoid cleaning with hot water or rubbing too hard Use wring dry cloth to rub and clean. or paint damage or deformation c
Summary of the content on the page No. 10
TM Advanced PureAir Newport 9000 Owner’s Manual ( ) CLEANING AND MAINTENANCE CONT. Cleaning and Maintenance of the Washable Plasma Dust Filter The Washable Plasma Dust Filter needs cleaning when: 1) The cleaning indicator is glowing or blinking. 2) The dust collector is making electrical discharge sounds. 3) The device has been used frequently in an area with lower air quality condition. Cleaning Instructions 1. Remove the Front Face Plate. Washable Pre-Filter Washable Plasma Dust Filter 2. Remo
Summary of the content on the page No. 11
TM Advanced PureAir Newport 9000 Owner’s Manual ( ) CLEANING AND MAINTENANCE CONT. The Cleaning and Maintenance of the Washable Plasma Dust Filter (Cont.) 4. Clean the Plasma Dust Filter Use mild detergent or plain water only. Use a soft scouring pad or toothbrush to clean the dust collector. Use warm water (below 40° C) only! 5. If dust and dirt does not wash away easily, pre-soak with diluted detergent and then use a toothbrush to scrub. Please take care not to damage any wiring while cleaning
Summary of the content on the page No. 12
Replacing Filters Please change filter when the REPLACE FILTER indicator is glowing. Note: Please refer to page 7 for instructions on filter installation and removal. Replacing UV Lamp The life span of UV lamp is about 5,000 hours. Replace UV lamp when it is damaged or when no blue light is observed. Remove the Front Face Plate, Washable Pre-Filter, Washable Plasma Dust Filter, and HEPA/Charcoal filter before replacing the UV lamp (refer to page 7 on how to dissemble). Softly twist the UV lamp,
Summary of the content on the page No. 13
TM Advanced PureAir Newport 9000 Owner’s Manual FREQUENTLY ASKED QUESTIONS Air Quality Surveillance Why is there is only one LED glowing all the time with the air quality surveillance function? Indoor air has been clean the whole time. For testing purpose, dust either caused by a cigarette or a dusty cloth can be released near the irritant sensor. If the level of pollution goes up, then the unit should be operating properly. The irritant sensor could be too far away from any irritant for it to d
Summary of the content on the page No. 14
TM Advanced PureAir Newport 9000 Owner’s Manual FREQUENTLY ASKED QUESTIONS (CONT.) Filter Why is it so hard for the filter to get rid of dust and odors? Have the front and back of the HEPA/Charcoal filter been mistakenly reversed? The HEPA/Charcoal filter has been saturated with a serious amount of dust. (Usually dark grey in color). Please replace filter. Plasma Dust Collector Why is it so difficult to eliminate dust and odor? If the electrical discharge wires or the plasma dust collector gets
Summary of the content on the page No. 15
TM Advanced PureAir Newport 9000 Owner’s Manual TECHNICAL SPECIFICATIONS Real Spirit Style No.: Newport 9000 Dust Removal Rate: 1 micron 99.97% • 0.3 micron 80% Rated Voltage: AC 120V/60Hz Noise Level (dB): Quiet 20 • Low 35•• Med 45 High 52 3 3 Power Consumption: 80W Air Volume (High):3m /min. • 106 ft /min. 63 Ion Output: ˃2x10/cm Dimensions: 13.5" x 10" x 25.6” • 343 x 255 x 610 mm Activated Oxygen Output: ˂ 0.05 ppm Weight: 15.1 lbs • 6850 g 2 2 2 UV Spectrum: ˃ 20μ w/cm at 10 cm distance. A
Summary of the content on the page No. 16
Produced and distributed exclusively by: Real Spirit USA, Inc. � 9447 De Soto Ave � Chatsworth, CA 91311 Customer Service Phone 888.698.2080, ext. 210 www.AdvancedPureAir.com � info@RealSpiritUSA.com © Copyright Real Spirit USA, Inc. 2008. All Rights Reserved Manufactured in China
