Stanton RM-22 user manual

Summary of the content on the page No. 1

Troubleshooting
Problem / Symptom Possible Cause/ Solution
Only plug turntables into this input, do not plug in
Sound is distorted
RM-22 Professional DJ Mixer
CD players or other Line Level sources. Turn down
Phono Input
the INPUT GAIN CONTROL
Make sure you are using good shielded audio
cables. Some less expensive audio cables can be
susceptible to hum and interference. Keep your
audio cables away from AC power cables and AC
I hear hum. transformers. Make sure the mixer is not mounted
too close

Summary of the content on the page No. 2

Please read carefully before use of this product Troubleshooting failure to follow the instructions printed below may void warranty Problem / Symptom Possible Cause/ Solution • Follow all security advice printed on your mixer Is the power on? Check the power switch.Make sure the channels are assigned properly to the • When removing the unit's AC plug from the power source, grasp crossfaders. Make sure INPUT GAIN, is turned and pull the plug, NEVER the cord itself! No Sound up and output level

Summary of the content on the page No. 3

Technical Specifications Welcome Frequency Response 20 Hz to 20 kHz +1 dB Congratulations on your choice of the Stanton RM-22 Professional DJ Mixer. You now own one of the most flexible DJ mixers ever THD+N (Line) > 0.005 % at 1 kHz designed. The rackmountable RM-22 offers up to three Microphone Signal to Noise Ratio inputs, three Phono inputs and nine Line inputs—making it one of (ref: max level) > 109 dB (main signal path) the most powerful DJ mixers around. And with Stanton’s smooth Noise -9

Summary of the content on the page No. 4

Making Connections Application Example Are you ready to get on the 1’s and 2’s? Let’s make sure you’ve This is a typical setup you’ll find in many nightclubs: 2 turntables, 2 made all the right connections… CD players, plus a microphone for the DJ. Here’s how you would set up your equipment with the RM-22: 1. Be sure all equipment is powered “OFF” and all of the RM-22’s Channel faders and Level knobs are at minimum volume. 2. Connect the turntables to the Phono inputs of Channels 1 and 2. Be

Summary of the content on the page No. 5

Description of Function Making Connections 16. Input Selector switches: Use these to choose between the Outputs Phono, Line and Mic inputs. Use the REC output to connect a stand-alone CD recorder, DAT 17. Talkover switch: Switch this to the “ON” position to enable recorder, or tape deck. Use the BOOTH output to connect directly to Microphones 1 and 2. When moved to the “Talkover” position, powered monitors or your monitor amp. The ZONE output can be the music is lowered by a preset amount when

Summary of the content on the page No. 6

Description of Function Description of Function At this point, you’re pretty much ready to start mixing. So if you’re a 6. Headphone outputs: Connect up to two pairs of stereo know-it-all, or you’re just one of those people who like to learn by headphones using 1/4-inch and 1/8-inch jacks. trial-and-error, you are free to throw down. But if you wanna go for the gold and get your pilot’s license, take a moment and learn what 7. Cue Pan slider: This adjusts the relative headphone balance each of