Ives Top Center Pivot 7256 user manual

Summary of the content on the page No. 1

Installation Instructions
7253, 7255/55J, and 7256
Top Center Pivot
Frame leaf
Access hole
Pivot pin
To retract
Finish plate
pivot pin
Door leaf
Figure 1
1. Prepare and mortise top of door and head jamb to receive pivot set. Determine pivot location
using dimensions on reverse side. Most center pivots have the pivot point located 1-3/4”
from side jamb. The pivot point of top pivot set must be plumb with bottom pivot point.
The finish plate should be removed from frame leaf prior to installation.

Summary of the content on the page No. 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Frame Leaf Edge of jamb 1-1/8” 29 mm 1-3/4” Pivot center may be 44 mm* *varied as needed. Minimum distance is 1-3/4” as shown. C pivot 1-5/8” L 41 mm 1/8” 3 mm max 3/8” 10 mm 1/2” 13 mm C pivot L Radius of heel edge of door must not exceed pivot point to jamb distance 1” 25 mm Door Leaf 26675-00 26675 Rev. 4