Summary of the content on the page No. 1
DW12-HFM
DW12-HFM ME
DW12-HFM SS
PT NL
GB DE FR IT ES 0120503790
Summary of the content on the page No. 2
Safety Is a Good Habit to Get Into NOTICE - Do not touch the heating element during or after a wash cycle. - Do not lean or sit on the door when it is open as this could Carefully read the instructions contained in this manual, as they over turn the dishwasher. provide important information which is essential to safe and proper - If the appliance malfunctions, turn off water supply to the appli- installation, use and maintenance of the appliance. ance and disconnect the plug from the wall so
Summary of the content on the page No. 3
Close-up View (Interior) Upper Rack A E Bottom Spray Arm Rack Height Adjustor B F Washing Filter Top Spray Arm C G Detergent and Rinse Aid Dispenser Lower Rack D Salt Container Cap H I Third Sprayer Technical characteristics 60 cm Width 60 cm Depth 85 cm Height Capacity 12 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V~50Hz Total absorber power 2100W .2. GB
Summary of the content on the page No. 4
Salt Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard The dishwasher is equipped with a system to adjust the level of water is used in the dishwasher, deposits will form on the dishes salt consumption in function of the hardness of the water being and utensils. used in order to optimize and customize the level of salt con- The appliance is equipped with a special softener that uses a salt sumption while keeping it to a minimum. specifica
Summary of the content on the page No. 5
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each out spotting. The dispenser is located on the inside panel of the wash cycle following the instructions provided in the "Wash Cycle door and should be filled after every 80 wash cycles. Table". The detergent dispenser is located on the inside panel of t
Summary of the content on the page No. 6
Loading the Dishwasher Before placing the dishes in the dishwasher, remove the large food particle to prevent the filter from becoming clogged, which results Lower Rack Upper Rack in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycle. Pull out the rack to facilitate loading the dishwasher. How to Use the Lower Rack We recommend that you p
Summary of the content on the page No. 7
Starting the Appliance Starting a wash cycle... At the end of the wash cycle... - Make sure that the plug for the appliance is inserted into the wall When the knob stops turning and is aligned with a STOP mark socket. (see figure), the cycle has finished. Turn off the appliance using - Make sure that the water supply is turned on to full pressure. the ON-OFF button, turn off the water supply and open the door - Load the dishwasher (see the section entitled, "Loading the of the dishwasher.
Summary of the content on the page No. 8
Wash Cycle Table Eco Cycle Selection Description of Deter- Rinse Cycle Information Button Cycle gent Aid Pre-wash with cold water. Very dirty dishes, pots and Rinse with cold water. pans (not to be used with 30g Extended wash at 60. Intensive delicate items). Rinse with hot water. Wash Drying. Pre-wash with cold water. Very dirty dishes, pots and Rinse with cold water. pans. (not to be used with Extended wash at 50. 30g Intensive delicate items) Rinse with hot water. Wash Drying
Summary of the content on the page No. 9
Energy Saving Tips - Use the right amount of detergent: if you use too much detergent, - It is important to try and run the dishwasher when it is fully the result will not be cleaner dishes, but, rather, a greater nega- loaded in order to save on energy. In order to prevent odours tive impact on the environment. from forming and food from caking onto the dishes, you can run - There is no utility in rinsing dishes, cookware and utensils the soak cycle. before placing them in the dishw
Summary of the content on the page No. 10
Cleaning and Special Maintenance Filter Assembly Cleaning the Spray Arms For best performance and results, the filter assembly must be It may happen that food particle become encrusted on the sprayer cleaned. arms and block the hole. Check the sprayer arms periodically The filter efficiently removes food particles from the wash water, and clean them when needed. (see "Close up view [interior]", allowing it to be recirculated during the cycle. For this reason, it letters C-E ). is a good idea to
Summary of the content on the page No. 11
Installation Positioning the Appliance Drain Hose Connection Positioning the appliance in the desired location. The back should Insert the drain hose into a drain pipe with a minimum diameter rest against the wall behind it, and the sides, along the adjacent of 4cm, Or let it run into the sink, making sure to avoid bending cabinets or wall. The dishwasher is equipped with water supply or crimping it. Use the speical plastic support that comes with and drain hoses that can be positioned to the ri
Summary of the content on the page No. 12
Installation Diagram
