Summary of the content on the page No. 1
Dishwasher
WQP12-BFE
0120504191
GB
Summary of the content on the page No. 2
Safety Is a Good Habit to Get Into NOTICE - Do not touch the heating element during or after a wash cycle. Carefully read the instructions contained in this manual, as they - Do not lean or sit on the door when it is open, as this could provide important information which is essential to safe and proper over turn the dishwasher. installation, use and maintenance of the appliance. - If the appliance malfunctions, turn off the water supply to the appliance and disconnect the plug from the wall
Summary of the content on the page No. 3
Close-up View (Interior) Upper Rack A Washing Filter F Rack Height Adjustor B G Detergent and Rinse Aid Dispenser Top Spray Arm C Salt Container Cap H Lower Rack D Third Sprayer I Bottom Spray Arm E Technical characteristics Width 60cm 60cm Depth Height 85cm Capacity 12 standard place settings Mains water pressure 0.03-0.6MPa Power voltage 220-240V~ 50Hz 2150W Total absorber power .2. GB
Summary of the content on the page No. 4
Salt Salt Adjusting Salt Consumption The hardness of the water varies from place to place. If hard The dishwasher is designed to allow for adjusting the amount of water is used in the dishwasher, deposits will form on the dishes salt consumed based on the hardness of the water used. This is and utensils. intended to optimise and customise the level of salt consumption The appliance is equipped with a special softener that uses a salt so that it remains at a minimum. Your local Water Board can sp
Summary of the content on the page No. 5
Detergent and Rinse Aid Detergent Rinse Aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each out spotting. The dispenser is located on the inside panel of the wash cycle following the instructions provided in the "Wash Cycle door and should be filled after every 80 wash cycles (or when Table." The detergent dispenser is located on the inside panel of the rin
Summary of the content on the page No. 6
Loading the Dishwasher Before placing the dishes in the dishwasher, remove large food particles to prevent the filter from becoming clogged, which re- Lower Rack Upper Rack sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they be allowed to soak before they are washed. This will eliminate the need for extra wash cycles. Pull out the rack to facilitate loading the dishwasher. How to Use the Lower Rack We recommend that you p
Summary of the content on the page No. 7
Turning on the Appliance Starting a wash cycle Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the preced- Premise: After selecting the wash cycle as indicated in the para- ing paragraphs, turn on the water all the way and press the ON- graph entitled, "Setting and Starting a Wash Cycle..." the delay OFF button (A) located on the control panel. The "B" indicator time can be set. light will come on. At this point, the appliance is on
Summary of the content on the page No. 8
Energy Saving Tips - Use the right amount of detergent: if you use too much detergent, - It is important to try and run the dishwasher when it is fully the result will not be cleaner dishes, but a greater negative im- loaded to save on energy. In order to prevent odours from pact on the enviroment. forming and food from caking onto the dishes,you can run - There is no untility in rinsing dishes, cookware and untensils the soak cycle. before placing them in the dishwasher. - Choos
Summary of the content on the page No. 9
Wash Cycle Table Cycle Selection Description of Cycle Cycle Detergent Rinse Aid Information Pre-wash with cold water Very dirty dishes,pots and Extended wash at 70K 30g pans.(not to be used with Rinse with cold water. Intensive delicate items) Rinse with hot waterK Wash Drying. Pre-wash with cold waterK Normally dirty dishes,pots Extended wash at 50K Pre-wash: 5g and pans without dried-on Rinse with cold waterK Extended wash: ( 5 ) Normal wash residue Rinse with hot waterK 25g (EN50242) Dr
Summary of the content on the page No. 10
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the "A" semi-circular filter and cup under running water. To remove the filter assembly, pull Cleaning the Spray Arms on the cup handle in
Summary of the content on the page No. 11
Installation Positioning the Appliance Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned on the right or the left to facilitate proper installation. Levelling the Appliance Once the appliance is positioned, adjust the feet (screw them in or out) to level the dishwasher. In any case, the appliance should not be inc
Summary of the content on the page No. 12
Installation Installation
